NEC DTR-1-1 Manual

NEC Telefon DTR-1-1

Læs gratis den danske manual til NEC DTR-1-1 (2 sider) i kategorien Telefon. Denne vejledning er vurderet som hjælpsom af 71 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 36 anmeldelser. Har du et spørgsmål om NEC DTR-1-1, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

OWNER’S MANUAL Model

DTR-1-1 TEL

Please read before using this equipment.

1. MF/DP switch

Before using your telephone, it must be set in accordance with the dialing method used by your local public

telephone exchange: MF=dual-tone multi-frequency dialing(DTMF),or DP=pulse dialing

2. Volume control for receiver and Speaker

Press ∧ / ∨ buttons to increase/decrease handset receiver volume while on a call. Volume can be increased 3 levels,

decrease 2 levels against the default level.

3. Selecting Ringing Pitch and Ringing Volume

a) Pick up the Handset

b) Press Program button

c) Dial #

d) Dial 0-9 (Refer to the table in the right)

e) Hang up

4. Flash

With certain public telephone exchanges or private

PABXs, the Flash button can be used to activate additional features, e.g. transfer of a call or pick-up of a call.

5. Redial

In the case of busy tone or no answer, you can redial the number. For this purpose, cradle the handset, lift it again

and press the Redial button.

6. Temporary Switchover of the Dialing Mode

After a connection has been set up to use PULSE dialing, switch over to TONE dialing can be made by pressing the * button,

and certain services offered by certain public Telephone exchanges or PABXs, e.g. control of a telephone answering system,

simple data traffic, etc .,can then be utilized by dialing additional digits. The telephone is automatically reset to PULSE dialing

when the handset is cradled.

NEC America, Inc.

4 P1G001000911

OWNER’S MANUAL Model DTR-1-1 TEL

IMPORTANT SAFETY INSTRUCTIONS

When using your telephone equipment, basic safety precautions should always be followed to reduce

the risk of fire, electric shock, and injury to persons by doing the following:

1. Read and understand all instructions.

2. Follow all warnings and instructions marked on the product.

3. Do not use this product near water, for example, near a bathtub, wash bowl, kitchen sink, or laundry tub, in

a wet basement, or near a swimming pool.

4. Do not place this product on an unstable cart, stand, or table. The product may fall, causing serious

damage to the product.

5. Slots and openings in the cabinet and the back or bottom are provided for ventilation. To protect it from

overheating, these openings must not be blocked or covered. The openings should never be blocked by

placing the product on a bed, sofa, rug, or other similar surface. This product should never be placed near

or over a radiator or heat register. This product should not be placed in a built-in installation unless proper

ventilation is provided.

6. Never push objects of any kind into this product through cabinet slots as they may touch dangerous

voltage points or short out parts that could result in a risk of fire or electric shock. Never spill liquid of any

kind on the product.

7. To reduce the risk of electric shock, do not disassemble this product. Take it to a qualified serviceman

when service or repair work is required. Opening or removing covers may expose you to dangerous

voltages or other risks. Incorrect reassembly can cause electric shock when the product is subsequently

used.

8. Avoid using a telephone during an electrical storm. There may be a remote risk of electric shock from

lightning.

9. Do not use the telephone to report a gas leak in the vicinity of the leak.

NOTE: The maximum level setting for the Receive Volume Control should only be used by hearing

impaired individuals, otherwise hearing damage may occur. This telephone complies with HAC

(Hearing Aid Compatible) volume control defined by section 68.317 of the FCC Rules and

Regulations, 1996 edition.

Please keep this unit away from equipment that uses radio wave or

microwave, a portable radio, a microwave oven, etc. This type of

equipment may cause improper operation....

SAVE THESE INSTRUCTIONS

Ringing Volume

Soft Medium Loud

Slow 1 2 3

Medium 4 5 6

Ringing

Tone

Pitch Fast 7 8 9

Off - 0 -

OWNER’S MANUAL

Model

DTR-1-1 TEL

FCC Part 68 Registration

The equipment complies with Part 68 of the FCC Rules. A label which contains the FCC Registration Number

and ringer equivalence number(REN) for the equipment, country of origin, and model number among other

information is located on the bottom of the equipment. If requested this information should be provided to the

telephone company.

The equipment uses the following USOC jacks: RJ11C

KX -type telephone with message waiting and/or line status indicators may only be connected to host system

and not to the Network.

The REN is used to determine the quality of the device which may be connected to the telephone line.

Excessive RENs on the telephone line may result in the devices not ringing in response to an incoming call. In

most, but not in all areas, the sum of RENs should not exceed five (5.0). To be certain of the number of devices

that may be connected to the line, as determined by the total RENs contact the telephone company to

determine the maximum REN for the calling area.

If the equipment causes harm to the telephone network, the telephone company will notify you in advance that

temporary discontinuance of service may be required. If advance notice is not practical, the telephone company

will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the

FCC if you believe it is necessary.

The telephone company may make changes in its facilities, equipment, operation, or procedures that could

effect the operation of the equipment. If this happens, the telephone company will provide advance notice in

order for you to make the necessary modifications in order to maintain uninterrupted service.

If trouble is experienced with this equipment, please contact your NEC Dealer for repair and/or warranty

information. If the trouble is causing harm to the telephone network, the telephone company may request you to

remove the equipment from the network until the problem is resolved.

NO REPAIRS CAN BE DONE BY THE CUSTOMER.

The equipment is hearing-aid compatible.

CAUTION: The act of monitoring or recording telephone conversations under certain circumstances may

violate federal or state statutes. Consultation with your legal counsel prior to engaging in such practices would

be advisable.

OWNER’S MANUAL

Model

DTR-1-1 TEL

FCC Part 15

Complies with the limits for a Class B computing device pursuant to Subpart J of Part 15 of FCC

Rules.

INDUSTRY CANADA (CS-03)

The Load Number of the equipment: N/A

"Notice: The Industry Canada label identifies certified equipment. The certification means that the equipment

meets certain telecommunication network protective operational and safety requirements. Industry Canada

does not guarantee the equipment will operate to the user's satisfaction."

"Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of

local telecommunications company. The equipment must also be installed using an acceptable method of

connection. In some cases, the company's inside wiring associated with a single line individual service may be

extended by means of a certified connector assembly (telephone extension cord). The customer should be

aware that compliance with the above conditions may not prevent degradation of service in some Situations."

"Repairs to certified equipment should be made by an authorized Maintenance facility designated by the

supplier. Any repairs or installations made by the user to this equipment, or equipment malfunctions, may give

the telecommunications company cause to request that the user disconnect the equipment.

Users should ensure for their own protection that the electrical ground connections of the power utility,

telephone lines, and internal metallic water pipe system, if present, are connected together. This protection may

be particularly important in rural areas."

Caution: Users should not attempt to make such connections themselves, but should contact the appropriate

electric inspection authority, or electrician, as appropriate.

SAFETY CONSIDERATIONS:

This equipment complies with Underwriters Laboratories Standard U.L. 1459, Third Edition.

Produkt Specifikationer

Mærke:	NEC
Kategori:	Telefon
Model:	DTR-1-1

Har du brug for hjælp?

Hvis du har brug for hjælp til NEC DTR-1-1 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Telefon NEC Manualer

NEC DTR-1-1 Manual

28 Juli 2024

NEC G955 Manual

26 Juli 2024

NEC I755 Manual

14 Juli 2024

Telefon Manualer

Nyeste Telefon Manualer

Allview Soul X7 Style Manual

12 September 2025

Panasonic KX-TG6724 Manual

12 September 2025

12 September 2025

10 September 2025

10 September 2025

10 September 2025

10 September 2025

10 September 2025

10 September 2025

10 September 2025