Nemco 6480-24S Manual

Nemco Madvarmer 6480-24S

Læs gratis den danske manual til Nemco 6480-24S (6 sider) i kategorien Madvarmer. Denne vejledning er vurderet som hjælpsom af 16 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 8.5 anmeldelser. Har du et spørgsmål om Nemco 6480-24S, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/6

NEMCO SLANTED 2-SHELF MERCHANDISER

MODEL SERIES: 6480-18S, 6480-24S, 6480-30S, 6480-36S

OPERATING INSTRUCTIONS

INTRODUCTION

1. Read These Operating Instructions thoroughly before installing or using this Equipment. Improper installation or use can result in

equipment or property damage, electric shock or personal injury.

2. The Nemco 2-Shelf Merchandiser is heavy duty and is designed for commercial use.

3. Only trained personnel should operate this equipment.

4. The Nemco 2-Shelf Merchandiser is designed to maintain the safe serving temperature of precooked food items. It is not designed

for cooking.

SAFETY INSTRUCTIONS

1. IMPORTANT: Clean machine thoroughly before first use and after all uses, using cleaning instructions below.

2. IMPORTANT: Incoming power MUST be the same as the equipment’s rating. Refer to the Electrical Ratings listed on the

equipment’s Data Tag Located on the side of the unit.

3. CAUTION: This unit’s power cord is equipped with a GROUNDED, 3-prong power cord. Plug only into a matching, grounded outlet.

DO NOT cut or break off the third prong. Operating this equipment without proper grounding may result in electric shock.

4. CAUTION: Always disconnect Power when not in use and before cleaning or servicing.

5. CAUTION: Do not operate with a damaged cord or plug or after the machine malfunctions, has been dropped or damaged. Use

authorized service for examination, electrical or mechanical adjustment or repair.

6. CAUTION: Equipment surfaces are HOT during use and a short time after disconnecting the power. Allow to cool before moving or

servicing.

7. WARNING: DO NOT immerse in water or other liquid. DO NOT clean with water jet. SEVERE personal injury or death can result.

ELECTRICAL REQUIREMENTS

1. The electrical ratings are listed on the equipment’s Data Tag located on the side of this equipment.. Refer to model data chart

2. This equipment must be properly GROUNDED.

PREPARATION

1. Remove all packing pieces and lift unit out of the box.

2. Remove any outside packaging.

3. Caution: Glass is packed separately in carton. Do Not Discard. Refer to Glass Installation Instructions.

4. Set unit on a flat surface. REFER to SAFETY INSTRUCTIONS No. 1 above.

5. Position unit near the power outlet. Do not use extension cords. Do not run cord under carpeting or cover with runners or the like.

Arrange cord where it will not be tripped over.

6. This appliance has hot and live electrical parts inside. Do not use it in areas where gasoline, paint or flammable liquids are used or

stored.

7. Unit must be operated with legs installed. Install legs by screwing into nuts located on bottom of unit.

8. Install Glass panels. Place edge in top channel, swing into bottom channel and lower into place.

9. Remove any plastic coating that may be affixed to exterior surfaces.

10. Caution: Dividers and dividers rods packed separately in carton. Do Not Discard. Refer to Divider

Installation Instructions.

11. Install dividers and divider rods. Place divider on shelf by sliding onto divider posts. Install divider rods into slots located on

dividers.

12. If unit fails to work properly when first operated, call NEMCO customer service at 1-800-782-6761.

OPERATION

1. Plug the unit into the power supply.

2. Turn on/off switches to the on position.

3. Turn temperature controls to desired temperature. Note: Allow unit to preheat for 30 minutes before use.

 Knob setting LOW: temperature is at 120º-140°F

 Knob setting MED: temperature is at 140°-165°F *TEMPERATURES VARY WITH TYPES

 Knob setting HI: temperature is at 165°-185°F OF FOOD PRODUCT

4. Place food product on shelf, centered under the heating element.

5. To disconnect appliance, turn controls to off and remove plug from outlet.

WARNING: DURING NORMAL OPERATION, THE EXTERIOR OF THE UNIT IS HOT.

CLEANING

NOTE:

Proper maintenance plays an important part in the life span and functioning of the unit.

1. Move the power switch on both shelves to the OFF position. Unplug the power cord.

2. Allow the unit to cool 30 minutes.

3. Wipe down the unit using a damp cloth or sponge and hot detergent water.

4. Rinse by wiping with a clean damp cloth.

5. Wipe dry.

6. Do not immerse in water or other liquid.

Produkt Specifikationer

Mærke:	Nemco
Kategori:	Madvarmer
Model:	6480-24S

Har du brug for hjælp?

Hvis du har brug for hjælp til Nemco 6480-24S stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Madvarmer Nemco Manualer

Nemco 6455-2 Manual

27 August 2025

Nemco 6480-18S Manual

26 August 2025

Nemco 6480-36 Manual

26 August 2025

Nemco 6480-36S Manual

26 August 2025

Nemco 6480-24S Manual

26 August 2025

26 August 2025

15 Juni 2025

15 Juni 2025

15 Juni 2025

14 Juni 2025

Madvarmer Manualer

Nyeste Madvarmer Manualer

Vollrath HDC9248 Manual

8 Oktober 2025

Cadco PGW-10 Manual

8 Oktober 2025

Vollrath HDC9348 Manual

7 Oktober 2025

Krampouz AMPC1AA Manual

7 Oktober 2025

Vollrath Mirage 595087502 Manual

7 Oktober 2025

Vollrath HDE8136 Manual

7 Oktober 2025

Vollrath Somerville Manual

7 Oktober 2025

Cadco PGW-15 Manual

7 Oktober 2025

Cadco PGW-5 Manual

7 Oktober 2025

Mirage 5950280 Manual

2 Oktober 2025