Nemco 8300 Manual

Nemco Brødrister 8300

Læs gratis den danske manual til Nemco 8300 (2 sider) i kategorien Brødrister. Denne vejledning er vurderet som hjælpsom af 20 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 10.5 anmeldelser. Har du et spørgsmål om Nemco 8300, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Model Series: 8300 & 8301 HOT DOG STEAMER

INCLUDES 220 VOLT MODELS

OPERATING AND MAINTENANCE INSTRUCTIONS

INTRODUCTION

1. Please read instructions before using this appliance.

2. When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock and injury to

persons.

3. Clean steamer thoroughly before and after all uses using cleaning instructions below

SAFETY INSTRUCTIONS

1. Plug electrical cord into a certified electrical outlet with a corresponding voltage rating as listed on the machine model labels.

2. Always unplug the electric cord when appliance is not in use and before cleaning, adjusting or maintaining this steamer. Do not

operate with a damaged cord or plug or after the machine malfunctions, has been dropped or damaged. Use authorized service for

examination, electrical or mechanical adjustment or repair.

3. This steamer will be HOT during use and for a short time after it is turned off – BE CAREFUL. To avoid burns, do not let bare skin

touch hot surfaces. If provided, use handles when moving this appliance. Keep combustible materials away from appliance.

4. Extreme caution is necessary when any appliance is used by or near children and whenever the appliance is left operating and

unattended.

5. This appliance is not intended for use in wet locations. Never locate appliance where it may fall into a water container.

Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electrical shock, fire or

damage to the appliance.

PREPARATION

1. Set steamer on a flat surface

2. Position steamer near the power outlet. Avoid the use of extension cords. Do not run cord under carpeting or cover with runners or

the like. Arrange cord where it will not be tripped over.

3. This appliance has hot and live electrical parts inside. Do not use it in areas where gasoline, paint or flammable liquids are used or

stored

4. Clean steamer thoroughly before use. Be sure to remove the protective film from the hot dog tray and bun tray before use.

5. If steamer fails to operate properly when first installed call NEMCO customer service at 1-800-782-6761

STARTUP

1. Place the hot dog tray in the steamer with the water fill cutout towards the front.

2. Slide the bun tray into the steamer and rest it on the 4 studs halfway up on sides of the machine.

3. Place the bun rack on the bun tray.

4. Lift the sliding glass doors up into the top glass rails then set them into the bottom glass rails.

ELECTRICAL REQUIREMENTS

Refer to the product tag (serial plate) on the bottom of the unit for voltage and wattage requirements. Be sure to plug unit into grounded

outlet with sufficient power.

OPERATION

1. Pour up to 7 quarts of water into the water tank. Distilled water is recommended.

2. Plug the electric cord into a 3-wire outlet, 110-volt. Do not use a 2-prong adapter.

3. Turn the power switch on, and turn the thermostat control to “Preheat” until steam is being generated.

Pre-heat time is normally 30 minutes.

4. Once the steamer has been preheated, turn thermostat down to the “Cook” range.

5. Place hot dogs on the hot dog tray and allow hot dogs to heat thoroughly.

Cooking time varies depending on the quantity and size of hot dogs.

6. Turn thermostat down to the “Hold” range and then place buns in the bun rack.

Note: Leaving buns in unit too long can cause them to be soggy.

7. Add water as needed making sure the unit never goes dry.

TROUBLESHOOTING:

UNIT WON’T HEAT CHECK THAT UNIT IS PLUGGED IN AND POWER SWITCH IS ON. CHECK

POWER SOURCE FOR PROPER VOLTAGE.

CHECK THAT THERMOSTAT IS SET TO DESIRED HEAT SETTING

NO STEAM CHECK WATER LEVEL IN RESERVOIR

UNIT BLOWS FUSE OR CIRCUIT BREAKER CHECK AND MAKE SURE CIRCUIT IS NOT OVERLOADED.

Produkt Specifikationer

Mærke:	Nemco
Kategori:	Brødrister
Model:	8300

Har du brug for hjælp?

Hvis du har brug for hjælp til Nemco 8300 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Brødrister Nemco Manualer

Nemco 8250SX-SLT Manual

18 September 2025

Nemco 8027-SBB Manual

18 September 2025

Nemco 8250-SLT Manual

16 September 2025

Nemco 8045W-SBB Manual

27 August 2025

Nemco 8036-BW Manual

27 August 2025

Nemco 8075SXW-RC Manual

26 August 2025

Nemco 8018-BW Manual

26 August 2025

Nemco 8027-BW Manual

26 August 2025

Nemco 8048-BW Manual

26 August 2025

Nemco 8018-SBB Manual

26 August 2025

Brødrister Manualer

Nyeste Brødrister Manualer

Melchioni Tosto Manual

25 December 2025

Comelec TP 7714 Manual

24 December 2025

Emerio TO-125131 Manual

22 December 2025

Dualit 31213 Manual

15 December 2025

Dualit 96001 Manual

15 December 2025

Dualit 42174 Manual

15 December 2025

DeLonghi Icona Micalite CTIN4003 Manual

15 December 2025

Maestro MR-703 Manual

11 December 2025

Sencor STS 7541BK Manual

10 December 2025

Maestro MR-700 Manual

10 December 2025