Netgear FS605 Manual

Netgear Ikke kategoriseret FS605

Læs gratis den danske manual til Netgear FS605 (5 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 17 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 9 anmeldelser. Har du et spørgsmål om Netgear FS605, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/5

Installation Guide

Fast Ethernet Switch

10/100 Mbps FS605 v2/FS608 v2

Technical Support

PLEASE REFER TO THE SUPPORT INFORMATION CARD THAT SHIPPED WITH

YOUR PRODUCT.

By registering your product at www.NETGEAR.com/register, we can provide you with faster

expert technical support and timely notices of product and software upgrades.

NETGEAR, INC.

Support Information

Phone: 1-888-NETGEAR (For US & Canada only) - 24 x7 phone support

See Support Information card for other countries.

E-mail: support@NETGEAR.com (24 x 7 online support)

www.NETGEAR.com

Everybody's Connecting are trademarks or registered trademarks of Netgear, Inc. in the

United States and/or other countries. Microsoft and Windows are registered trademarks of

Microsoft Corporation in the United States and/or other countries. Other brand and product

names are trademarks or registered trademarks of their respective holders. Information is

August 2003

M - 1 0 1 6 0 - 0 1

Introduction

The NETGEAR®5/8-Port Fast Ethernet Switch Model FS605 v2/FS608 v2 provides you with

a low-cost, reliable, high-performance switch to connect up to five or eight different Ethernet-

enabled devices (such as computers, file servers, print servers, printers, routers and hubs).

You use the FS605 v2/FS608 v2 switch to build a small network that enables you to have 10

Mbps or 100 Mbps access to other devices on the network. Also, with this switch, you can add

extra computers to your cable or DSL router. Unlike a hub that shares its connection with all

devices, the FS605 v2/FS608 v2 switch provides a full, dedicated 100 Mbps (or 10 Mbps)

connection between two devices. If a device has full-duplex capability, the FS605 v2/FS608 v2

switch provides a 200 Mbps (or 20 Mbps) connection.

Ethernet cables come as either straight-through or crossover cables—depending on whether

you’re connecting to a device (computer, server, or printer) or networking equipment (hub,

switch, or router). With the Auto Uplink™ feature, you don’t have to worry about which one

you use. Each port on the FS605 v2/FS608 v2 switch automatically configures itself correctly

when you plug in a device’s cable.

If you have a problem with your switch, NETGEAR offers free support 24 hours a day and 7

days a week on the Web (www.NETGEAR.com), by e-mail (support@NETGEAR.com) and by

phone (see the provided support information card for phone numbers).

Installation Overview

Estimated Time: 5–10 minutes

1. Unpack the box and verify the contents.

2. Prepare to install the switch.

3. Install the switch and connect the other devices.

Fast Ethernet Switch FS605 v2/FS608 v2

Statement of Conditions

In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to

make changes to the product described in this document without notice.

NETGEAR does not assume any liability that may occur due to the use or application of the product(s) or circuit

layout(s) described herein.

Certificate of the Manufacturer/Importer

It is hereby certified that the NETGEAR Model FS605 v2/FS608 v2 Fast Ethernet Switch has been suppressed in

accordance with the conditions set out in the BMPT-AmtsblVfg 243/1991 and Vfg 46/1992. The operation of some

equipment (for example, test transmitters) in accordance with the regulations may, however, be subject to certain

restrictions. Please refer to the notes in the operating instructions.

Federal Office for Telecommunications Approvals has been notified of the placing of this equipment on the market and

has been granted the right to test the series for compliance with the regulations.

Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

• This device may not cause harmful interference.

• This device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

EN 55 022 Declaration of Conformance

This is to certify that the NETGEAR Model FS605 v2/FS608 v2 Fast Ethernet Switch is shielded against the

generation of radio interference in accordance with the application of Council Directive 89/336/EEC, Article 4a.

Conformity is declared by the application of EN 55 022 Class B (CISPR 22).

Canadian Department of Communications Radio Interference Regulations

This digital apparatus (NETGEAR Model FS605 v2/FS608 v2 Fast Ethernet Switch) does not exceed the Class B

limits for radio-noise emissions from digital apparatus as set out in the Radio Interference Regulations of the Canadian

Department of Communications.

Règlement sur le brouillage radioélectrique du ministère des Communications

Cet appareil numérique (NETGEAR Model FS605 v2/FS608 v2 Fast Ethernet Switch) respecte les limites de bruits

radioélectriques visant les appareils numériques de classe B prescrites dans le Règlement sur le brouillage radioélectrique

du ministère des Communications du Canada.

Produkt Specifikationer

Mærke:	Netgear
Kategori:	Ikke kategoriseret
Model:	FS605
Bredde:	118 mm
Dybde:	72 mm
Højde:	30 mm
Vægt:	90 g
Produktfarve:	Hvid
Opbevaringstemperatur (T-T):	-20 - 70 °C
Driftstemperatur (T-T):	0 - 40 °C
Husmateriale:	Plast
Strømforbrug (maks.):	2.03 W
Netværksstandarder:	IEEE 802.3, IEEE 802.3u, IEEE 802.3x
LED-indikatorer:	LAN
Strøm over Ethernet (PoE):	Ingen
10G understøttelse:	Ingen
Basis omskiftning RJ-45 Ethernet porte, antal:	5
Basis omskiftning RJ-45 Ethernet porttype:	Fast Ethernet (10/100)
Opbevar-og-frem:	Ja
MAC adresselabel:	2000 entries
Switch kapacitet:	- Gbit/sek.
Stativ-montering:	Ingen
Stabelbar:	Ingen