Netgear MS108UP Manual

Netgear Ikke kategoriseret MS108UP

Læs gratis den danske manual til Netgear MS108UP (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 75 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 38 anmeldelser. Har du et spørgsmål om Netgear MS108UP, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Installation Guide

Router

May 2022 © NETGEAR, Inc., NETGEAR and the NETGEAR Logo

are trademarks of NETGEAR, Inc. Any non‑NETGEAR

trademarks are used for reference purposes only.

8-port Ultra60 PoE++ Multi-Gigabit (2.5G)

Ethernet Unmanaged Switch

Model MS108UP

Package contents

• NETGEAR 8‑port Ultra60 PoE++ Multi‑Gigabit (2.5G) Ethernet Unmanaged Switch

• Power adapter (power cable varies by region)

• Wall‑mount installation kit

• Rubber feet

• Installation Guide

1. Register the switch

1. From a computer or mobile device that is connected to the Internet, visit

my.netgear.com.

2. Log in to your NETGEAR account.

NOTE: If you don’t have a free NETGEAR account, you can create one.

The Your Registered Products page displays.

3. Click the REGISTER NEW PRODUCT button.

4. In the SERIAL NUMBER eld,typetheserialnumberofyourswitch.

The serial number is 13 digits long. It is printed on the switch label.

5. From the PURCHASE DATE menus, select the date that you purchased the switch.

6. Click the button.REGISTER

Your switch is registered to your NETGEAR account.

AconrmationemailissenttoyourNETGEARaccountemailaddress.

2. Connect the switch

Internet

IP conference

phone

WAX630

PoE++ APs

MS108UP switch

Sample connections

PTZ camera

Non PoE

PoE+

3. Check the LEDs

When you connect the power adapter to the switch and plug the cable into an electrical

outlet, the LEDs indicate the status:

LED Description

Power LED

Solid green: The switch is powered on and operating normally.

Off. Power is not supplied to the switch.

PoE Max LED

(The status of

the switch’s PoE

budget.)

Off:Sufcient(morethan7Wof)PoEpowerisavailable.

Solid yellow:Lessthan7WofPoEpowerisavailable.

Blinking yellow: At least once during the previous two minutes, less

than7WofPoEpowerwasavailable.

Left Port LED : 2.5 Gbps link on this port.Solid green

Blinking green: 2.5 Gbps activity on this port.

Solid yellow: 1000 Mbps or 100 Mbps link on this port.

Blinking yellow: 1000 Mbps or 100 Mbps activity on this port.

Off. No link is detected on this port.

Right Port LED Solid Green: The port is delivering PoE power.

Off: The port is not delivering PoE power.

Solid yellow: A PoE fault occurred.

Technical specications

Specication Description

Network interfaces RJ‑45 connectors that support 100BASE‑TX,

1000BASE‑T, and 2.5GBASE‑T

Ports 8

PoE Ports 1–4: PoE++ (802.3bt)

Ports 5–8: PoE+ (802.3at)

PoE budget 230W

Power adapter 54V@4.7ADCinput

Power consumption 270.5W

Dimensions (W x D x H) 8.27x5.51x1.58in.(210x140x40mm)

Weight 1.98 lb (900 g)

Operating temperature 32 to 104° F (0 to 40° C)

Operating humidity 10 to 90% relative humidity, noncondensing

Maximum operating altitude 10,000 ft. (3,000 m)

Storage temperature –4to158°F(–20to70°C)

Storage humidity 5 to 95% relative humidity, noncondensing

Maximum storage altitude 10,000 ft. (3,000 m)

Electromagneticcertications

and compliance

EMC class B device, FCC, ISED, CE, RCM, VCCI, BSMI,

CCC, KC

Safetycertications CB, CE LVD, CSA, BSMI, CCC

WAC540

PoE+ AP

PoE++

ReadyNAS

Computer

NOTE: We recommend that you use a Category 5e (Cat 5e) cable or higher‑rated

cable for Gigabit Ethernet connections.

WARNING: Before connecting this switch to outdoor cables or devices, see

https://kb.netgear.com/000057103for safety and warranty information.

This switch is designed for indoor use only. If you want to connect it to a device located

outdoors, the outdoor device must be properly grounded and surge protected, and you

must install an Ethernet surge protector inline between the switch and the outdoor device.

Failure to do so can damage the switch.

Produkt Specifikationer

Mærke:	Netgear
Kategori:	Ikke kategoriseret
Model:	MS108UP
Bredde:	210 mm
Dybde:	140 mm
Højde:	40 mm
Vægt:	900 g
Opbevaringstemperatur (T-T):	-20 - 70 °C
Relativ luftfugtighed ved drift (H-H):	0 - 90 %
Driftstemperatur (T-T):	0 - 40 °C
Ethernet LAN-datahastigheder:	100,1000,2500 Mbit/s
Husmateriale:	Metal
Strømkilde:	DC
Certificering:	CB, CSA, CCC, BSMI, RCM
Netværksstandarder:	IEEE 802.1p,IEEE 802.3,IEEE 802.3ab,IEEE 802.3af,IEEE 802.3at,IEEE 802.3az,IEEE 802.3bt,IEEE 802.3u,IEEE 802.3x
Servicekvalitet support (QoS):	Ja
Kan monteres på væggen:	Ja
Driftshøjde:	0 - 3000 m
DC indgangsspænding:	54 V
Indgangsstrøm:	4.7 A
Fuld duplex:	Ja
Strøm over Ethernet (PoE):	Ja
Gennemsnitstid mellem fejl (MTBF):	373643.7 t
Switch-type:	Ikke administreret
Total Power over Ethernet (PoE):	230 W
Power over Ethernet plus (PoE+) porte, antal:	8
10G understøttelse:	Ingen
Auto MDI/MDI-X:	Ja
VLAN understøttelse:	Ja
Auto-sensing:	Ja
Antal VLAN'er:	64
Basis omskiftning RJ-45 Ethernet porte, antal:	8
Basis omskiftning RJ-45 Ethernet porttype:	2.5G Ethernet (100/1000/2500)
MAC adresselabel:	16000 entries
Switch kapacitet:	40 Gbit/sek.
Jumbo Frames support:	Ja
Jumbo rammer:	12000
Stativ-montering:	Ingen
Antal blæsere:	0 blæser(e)
Varmeafgivelse:	923.49 BUT/t
Strømforsyning inkluderet:	Ja
Halv dupleks:	Ja
Pakke bufferlager:	1.5 MB
Latens (1 Gbps):	3.593 µs
Elektromagnetisk kompatibilitet:	CE, FCC part 15 Class B, ISED, VCCI, KC, CCC, BSMI, RCM
Pakke videresendelsesrate (1 Gbps):	1488000 pps
Head-of-line (HOL) blokering:	Ja
Ventilatorfri:	Ja
Antal 2,5G Ethernet-porte (kobber):	8