Netis ST3116GS Manual

Netis Ikke kategoriseret ST3116GS

Læs gratis den danske manual til Netis ST3116GS (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 115 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 58 anmeldelser. Har du et spørgsmål om Netis ST3116GS, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

as an example of the product images below.

Power Adapter

ADSL/Router Switch

Computer

60W 120W

> Check if the Power Adapter/Power Cord is well connected. Try to unplug and

plug back in the Power Adapter/Power Cord to the switch or try another power

outlet.

2. The LINK/ACT LED is not on.

> Make sure the network configuration of connecting device is correct, and

network card and drivers are installed correctly.

> Check the cable connections.

> Make sure the cable distance between the switch and other IEEE802.3

compatible network device does not exceed 100 meters.

3. Performance is bad.

> Check the status of Ethernet switching. If Ethernet switching is set to full-duplex

on one device but a partner is set to half-duplex, then performance will be poor.

> Make sure the cable between the switch and other IEEE802.3 compatible

network device is Category 5 UTP or better.

4. Some devices can't talk to other devices on the network.

> Check status of the LINK/ACT LEDs to make sure devices are linked.

> Make sure that the devices' network configurations are correct.

> Reset the switch if needed.

1.The Power(PWR) LED is not on.

Warning:

[A shielded-ty pe power c o rd is required i n ord er to meet FCC emission limits and also to

prevent interference to the nearby radio and television reception. It is essential that only the

supplied power cord be used.]

[Use only s hielded cables to connect I/O devices to this equipment.]

You are cautioned that changes or modifications not ex pr es sl y a pp ro ve d b y t h e par ty

re sp on si bl e f or compliance could void your authority to operate the equipment.

[ ]:depend on EUT condition.

This devic e complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) this devic e may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may

cause undesired operation.

Appendix A: FCC Statement

FCC St ate ment

(For ST-3105, ST-3108, ST3105S, ST3108S, ST3105G, ST3105GS ST3108GS)，

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

-Consult the dealer or an experienced radio/TV technician for help.

(For ST3108G, ST3116, ST3124, ST3116P, ST3124P, ST3116G, ST3124G, PE6108,

PE6108H, PE6108GH, PE6108G)

This Equipment has been tested and found to comply with the limits for a Class A digital device,

pursuant to Part 15 of the FCC rules.

These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications.

Operation of this equipment in a residential area is lik ely to cause harmful interference,

in which case the user will be required to correct the interference at his/her own expense.

Appendix B: Industry of Canada Statement

PK UM 0 59 10

(For ST3105S, ST3108S, ST3105G)

This Class [B] digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du Canada.

(For ST3108G)

This Class [A] digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe [A] est conforme à la norme NMB-003 du

Canada.

Technical Support:

USA/ Canada:

Toll Free: +1 866 71 network (+1 866 716 3896)

E-mail: usa_support@netis-systems.com

Other Regions:

E-mail: support@netis-systems.com

NETI S SYSTEMS C O., LTD.

www.netis-systems. com

MADE IN CHI NA

ST3105GS, ST3108GS

Produkt Specifikationer

Mærke:	Netis
Kategori:	Ikke kategoriseret
Model:	ST3116GS

Har du brug for hjælp?

Hvis du har brug for hjælp til Netis ST3116GS stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Netis Manualer

11 August 2024

5 August 2024

1 August 2024

24 Juli 2024

18 Juli 2024

30 Maj 2024

30 Maj 2024

30 Maj 2024

30 Maj 2024

Netis ST3326(ST-3302) Manual

30 Maj 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

PAG Mini link 6002 Manual

4 November 2025

Wamsler K128 Manual

4 November 2025

Sonifex Redbox RB-DSD8 Manual

4 November 2025

Zotac ZBOX MI561 nano Manual

4 November 2025

MuxLab 500800-RX Manual

4 November 2025

Hawke Laser/LED Foregrip Manual

4 November 2025

Wooden Camera 213900 Manual

4 November 2025

Chauvet Freedom Flex Stick Battery Manual

4 November 2025

DS18 VOC8LD-PK Manual

4 November 2025

Sony XDCAM PXW-Z90 Manual

4 November 2025