Newco AK-2 Manual

Newco Kaffemaskine AK-2

Læs gratis den danske manual til Newco AK-2 (5 sider) i kategorien Kaffemaskine. Denne vejledning er vurderet som hjælpsom af 19 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 10 anmeldelser. Har du et spørgsmål om Newco AK-2, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/5

Man Pt No 110402 Rev 20170214

ISS 0599

N E W C O E N T E R P R I S E S

INSTALLATION and OPERATION MANUAL

for AK SERIES BREWERS

BREWER SPECIFICATIONS

Model

No of

Warmers

Width

Length

Height*

US 120V

Amps**

Canada 120V

Amps**

AK-1

8- 1/2"

16 3/8"-

16 15/16-

12.5

11.2

AK-2

8- 1/2"

16 3/8"-

18 9/16-

13.3

10.8

AK-3

15 1/2"-

16 3/8"-

16 15/16-

14.2

11.7

AK- LD

N/A

8- 1/2"

16 3/8"-

21 3/16-

14.6

11.7

AK- TC

N/A

8- 1/2"

16 3/8"-

17 5/8-

14.6

11.7

AK AP-

N/A

8- 1/2"

16 3/8"-

22 15/16-

14.6

11.7

AK-D

N/A

8- 1/2"

17 3/8"-

27 3/8-

14.6

11.7

* Height with ABS base shown for Airpot/Dispenser models

** Other Wattages/Voltages available as special order

AK- LD

Note: Decanters and Dispensers not Included

AK-3AS

INSTALLATION / SETUP INSTRUCTIONS

WARNING: - Read and follow installation / setup instructions before plugging or wiring in machine to electrical

circuit. Warranty will be void if machine is connected to any voltage other than that specied on the name plate.

FILL BREWER TANK WITH WATER BEFORE CONNECTING TO POWER SUPPLY !

1) Place the decanter under brew basket, raise top evaporation cover and pour three decanters of water through

the top pour-in screen. Water should come through the brew basket as the third decanter of water drains out of

the pour in basin.

2) Brewer is shipped with thermostat turned on. Plug or wire in machine to appropriate voltage circuit as indicated

on serial tag.

3) Allow 10 to 15 minutes for water in tank to heat to brewing temperature. Additional water may drip from brew

basket on initial expansion of water in the tank. This will not occur thereafter.

4) After water has reached brewing temperature (thermostat will click o, heating noise will stop and green ready

light will be on) pour 1 decanter (60 oz.) of water through pour-in screen. More than 1 decanter of water will

ow into decanter below brew basket due to water expansion in the tank. Machine is now ready to use.

5) Pour 1 decanter of water through pour-in screen to check for the proper temperature setting with an accurate

thermometer. Take the temperature of this water at a point below the brew basket opening, at the start of the

brew cycle and when the decanter is half full. Recommended temperature of the water is approximately 195 F.

6) In higher altitude locations (5000 feet above sea level) the thermostat may have to be adjusted lower to prevent

boiling.

COFFEE PREPARATION PROCEDURES

1) Place lter into brew basket.

2) Put the proper amount of coee into the lter.

3) Slide the brew basket into holder.

4) Place the appropriate empty decanter into position below the brew basket. For airpots rst open lid and remove

pump stem unless it is of the brew thru design. For other dispensers without brew thru lids, remove the lid.

Turn lower warmer switch to the ON position for warmer units.

5) Raise the top evaporation cover and pour one decanter of cold water through the pour in screen into the basin.

Do not overll unit by pouring in more than one decanter of water at a time.

6) Hot water will be delivered through the sprayhead. This distributes the hot water evenly over the coee bed

within the brew basket. The coffee brew will drain from the brew basket into the decanter below.

7) TURN OFF WARMERS WHEN NOT IN USE. Red light in switch indicates when warmer is on.

8) To clean brew basket simply remove from brew rails and dump lter into waste basket. The brewing process,

as described above, can now be started again.

AUTOMATIC WARMER SAFETY SHUT OFF - OPTIONAL FEATURE

Warmer models may be equipped with an electronic control system which automatically monitors the

length of time the warmers are on, and shuts them off after they have been turned on for a preset length of time.

The model number on the serial tag of brewers equiped with this feature is appended by "AS". For example an

AK-3AS is a 3 warmer AK brewer with Automatic Shuto.

The warmer shuto control is initially set at the factory for two hours but the duration of on time for the

warmers may be adjusted anywhere between thirty minutes and four hours, depending on the needs of your

customer. To adjust the time, simply remove the access panel located on the right side of the brewer. Use a

screwdriver to turn the knob. Turning the knob clockwise will increase the on time and counter clockwise will

decrease the length of time the warmers will stay on.

The warmer control circuit will operate all warmers on for the same amount of time. The on time will

automatically be reset to the programmed time when any warmer is turned on. For example, if the customer has

turned on the lower warmer and then 30 minutes later turns on the second warmer, the on time for both warmers

will automatically be reset for the full programmed time of two hours, assuming the factory set time of two hours is

used. This feature eliminates individual warmers shutting o separately. A warmer may be turned o manually by

depressing the appropriate control switch. The red pilot light indicates that the warmer is on.

LIMING

To prevent liming problems in tank fittings remove sprayhead and insert deliming spring all the way into the

tank. When inserted into tank properly, no more than ten inches of the spring should be visible at the

sprayhead tting. Saw back and forth ve or six times. This will keep ttings open and clear of lime. In hard

water areas this should be done everyday. This process takes approximately one minute. In all areas the

sprayhead should be cleaned at least once a week. Where bad liming has already occurred, a new complete

tank assembly may be installed. The tank may be changed in approximately 5-10 minutes time.

Produkt Specifikationer

Mærke:	Newco
Kategori:	Kaffemaskine
Model:	AK-2

Har du brug for hjælp?

Hvis du har brug for hjælp til Newco AK-2 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Kaffemaskine Newco Manualer

28 December 2024

23 August 2024

19 August 2024

16 August 2024

16 August 2024

16 August 2024

16 August 2024

15 August 2024

15 August 2024

15 August 2024

Kaffemaskine Manualer

Nyeste Kaffemaskine Manualer

Fetco MBS-1221 Manual

12 August 2025

Camry CR 4423 Manual

12 August 2025

Adler AD 4400 Manual

12 August 2025

Wilbur Curtis RU-225 Manual

12 August 2025

Mahlkönig E80W GbS Manual

12 August 2025

Wilbur Curtis RU-150 Manual

12 August 2025

Wilbur Curtis CBP Manual

12 August 2025

Mahlkönig E65W GbS Manual

12 August 2025

Heinner HEM-200BG Manual

12 August 2025

Camry CR 4418 Manual

12 August 2025