NightStick TAC-300 Manual

NightStick Lys TAC-300

Læs gratis den danske manual til NightStick TAC-300 (2 sider) i kategorien Lys. Denne vejledning er vurderet som hjælpsom af 3 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 2 anmeldelser. Har du et spørgsmål om NightStick TAC-300, eller vil du spørge andre brugere om produktet?

Side 1/2
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.nightstick.com
INS-T300B-K01-21
Instruction Manual
TAC-300B-K01
WARNINGS
NOT FOR USE ABOVE HAZARDOUS LOCATIONS
DO NOT use in explosive atmospheres, near ammable liquids, or where explosion
prooflampsarerequired.
DONOTuseintheproximityofvehiclesorequipmentwhenthereisariskofammable
liquidscomingintocontactwiththeashlight.
DONOTexposethebatteriestowaterorsaltwater,orallowthebatteriestogetwet.
DONOTstorethebatterieswithmetallicobjectsthatmaycauseashortcircuit.
Immediately discontinue use of the batteries if they emit an unusual smell, feel hot,
changecolor,changeshapeorappearabnormalinanyway.
Keep out of the reach of children.
ASSEMBLY INSTRUCTIONS
The TAC-300B includes the pocket clip and the tail cap switch already attached. The
lightcanbeusedimmediatelyasaconventionaltacticalashlightoncethebatteriesare
installed.Thislightmaybeconvertedbacktothiscongurationatanytime.
1. Removethepocketclip(Figure1-B)byunscrewingandremovingthelightbezel(Figure1-A).
2. Reinstallthelightbezel(Figure1-A).
3. Remove the tail cap switch (Figure 1-C). NOTE: Keep the tail cap switch and pocket clip
forfutureuseforthelightistobeconvertedbacktoaconventionaltacticalashlight.
4. InstallthetwoincludedCR123 batteries (Figure2-A).The positiveterminalson each
batteryshouldbeorientedinthedirectionoftheLightBezel.
5. Install the Remote Pressure Switch (Figure 2-B) and tighten into place.
6. Test the operation of the Remote Pressure Switch and the side switch. See section titled
Operation for how the switches work.
7. Determinelocationoftherailmountonthebodyofthelight.Keepthemountclearofthe
switchcap,otherwisechangingthebatterieswillrequireremovingthemount.
8. Once the location of the mount has been determined, loosen the screws using the
supplied Allen wrench and slide the mount onto the handle of the light (Figure 3).
Partially tighten the screws.
9. TesttthemountontothePicatinnyorWeaverrail ofthelonggun.Determinethe
desiredlocationoftheRPS(Figure5)onthelonggun.Itcanbeattachedtoanyclean,
dry,atsurface.Figure5isoneexample;choosethebestlocationforyourweapon’s
congurationandpersonalpreferences.
10.Finishtighteningthemountscrews,alternatingbetweeneachasmallamountatatime
untilthegapisequalonbothsides(Figure3).
11. OncethelocationofthemountandtheRPShavebeendetermined,thoroughlyclean
thelocationontheweaponwheretheRPSwillbelocatedaswellastheinsidesurface
oftheRPSusingthesuppliedalcoholswab.
12.PeeloffthepaperbackingononesideoftheVelcro
®
adhesive strip and press it into
placeonthebacksideoftheRPS(Figure4).
13.Attachthelightwithmountontotherailoftheweaponandtightenthethumbscrew.
14.PeeloffthepaperbackingontheothersideoftheVelcro
®
adhesive strip and press it
onto onto the clean area of the long gun. (Figure 5).
NOTE:Donotmoveorremovetheadhesivestripsoncetheyhavebeenplaced.The
Velcro
®
adhesiverequiresabout24hourstomakeasemi-permanentbond.Donotattempt
to separate the two Velcro
®
sections until it is set.
OPERATION
The Nightstick Tactical Long Gun Kit is now fully installed and ready for use.
The Remote Pressure Switch provides momentary On/Off operation of the light only.
Using this switch gives the operator instant control when the light is on and off.
ThesideswitchprovidesmomentaryOn/Offoperationbypressingslightlyonthebutton,
orconstant-onbypressinguntilthebuttonclicks.
If the mount is positioned correctly (see Step 7 above), changing the batteries may be
accomplished without removing the light from the mount. Depending on the installation location,
itmaybepossibletochangethebatterieswithoutremovingthemountfromtheweapon.
Tochangethebatteries,rstseparatethetwohalvesoftheVelcro
®
strip from each other
sothatonehalfstaysadheredtoyourweaponandtheotherremainsattachedtotheback
side of the Remote Pressure Switch. Next, unscrew the Remote Pressure Switch and
replacethebatteries(seeStep4above).
WARRANTY
LIMITED LIFETIME WARRANTY
BaycoProducts,Inc.warrantsthisproducttobefreefromdefectsinworkmanshipand
materialsfortheoriginalpurchaser’s lifetime.TheLimitedLifetimeWarrantyincludesthe
LEDs, housing and lenses. Rechargeable batteries, chargers, switches, electronics and
included accessories are warranted for a period of two years with proof of purchase. Normal
wear and failures which are caused by accidents, misuse, abuse, faulty installation and
lightning damage are excluded.
Wewillrepairorreplacethisproductshouldwedetermineittobedefective.Thisisthe
onlywarranty,expressedorimplied,includinganywarrantyofmerchantabilityortnessfor
a particular purpose.
For a complete copy of the warranty, go to www.baycoproducts.com/bayco-product-
support/warranties. Retain your receipt for proof of purchase.
Mode d’emploi
TAC-300B-K01
AVERTISSEMENTS
NEPASUTILISERAU-DESSUSD’ENDROITSDANGEREUX.
NE PAS utiliser ce produit dans une atmosphère explosive, à proximité de liquides
inammables,oudansdesendroitsexigeantunéclairageantidéagrant.
NEPASutiliserceproduitàproximitédevéhiculesoud’équipementquanddesliquides
inammablespourraiententrerencontactaveclalampetorche.
NEPASexposerlesbatteriesàl’eauouàl’eausalée,etnepaslaisserlesbatteries
se mouiller.
NEPASrangerlesbatteriesàproximitéd’objetsmétalliquesquipourraientcauserun
court-circuit.
Arrêtezimmédiatementd’utiliserlesbatteriessiellesémettentuneodeurinhabituelle,
sontbrûlantesautoucher,changentdeforme,ouencasdetouteautreanomalie.
Ne pas laisser pas à la portée des enfants
INSTRUCTIONS DE MONTAGE
La lampe torche tactique TAC-300B est fournie avec l’agrafe pour poche et le
capuchonarrièredéjàenplace.Latorchepeutdoncêtreutiliséedèsquevouslasortez
desonemballage entantquelampetorchetactiqueconventionnelleune foisqueles
batteries CR-123 incluses sont en place. La conguration de cette torche peut être
changée à tout moment.
1. Enlevez l’agrafe de poche (illustration 1-B) en dévissant et retirant la tête lumineuse
(illustration 1-A).
2. Unefoisl’agrafedepocheretirée,réinstallezlatêtelumineuse(illustration1-A).
Figure 5Figure 4
Figure 3


Produkt Specifikationer

Mærke: NightStick
Kategori: Lys
Model: TAC-300

Har du brug for hjælp?

Hvis du har brug for hjælp til NightStick TAC-300 stil et spørgsmål nedenfor, og andre brugere vil svare dig