Nubert nuSub XW-1200 Manual

Nubert Subwoofer nuSub XW-1200

Læs gratis den danske manual til Nubert nuSub XW-1200 (8 sider) i kategorien Subwoofer. Denne vejledning er vurderet som hjælpsom af 8 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 4.5 anmeldelser. Har du et spørgsmål om Nubert nuSub XW-1200, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/8
12/2021 EN
Key to the symbols
The triangle symbol with exclamation mark (without additional comment)
indicates important instructions for commissioning, operation and maintenance
of the device.
The term Caution! next to the triangle symbol indicates a medium risk. Failure
to observe this warning may result in property damage.
The term Danger! next to the triangle symbol indicates a high risk. Failure to
observe this warning may result in death or personal injury
This symbol indicates that you must read and observe the operating in-
structions and the safety and warning notices in order to operate the device.
This symbol (triangle with lightning) warns of dangerous voltages inside
the enclosure and of hazards due to electric shock.
This symbol indicates that the device complies with electrical protection
class 2 and therefore does not require earthing.
Devices with this symbol may only be used in a dry indoor environment.
Equipment marked with this symbol must not be disposed of with house-
hold waste. Refer to the Disposal and Battery Return section at the end of this
manual.
General information
Never operate the loudspeaker unattended!
Danger of electric shock!
To avoid the risk of electric shock, the speaker may not be opened by the
user. There are no user-serviceable parts inside the speaker.
Service work and repairs are reserved for qualied specialists authorized by
Nubert. If you need service, please contact Nubert electronic GmbH directly
(info@nubert.de)!
Danger of suffocation!
Never let children use or play with neither speaker, remote control or packaging
unattended. There is a risk that children will get caught in the packaging lm
and suffocate. Make sure that children cannot remove any small parts from the
devices! These parts, like the remote control battery, could be swallowed and
cause suffocation. In case of swallowing any parts, contact a doctor immediately!
Active subwoofer
Safety instructions
Technical data
Warranty terms
1
Device approval and conformity
with EC directives
Nubert electronic GmbH hereby declares that this product complies with the
2014/53/EU directives, provided that it is installed and used in accordance with
the manufacturer‘s instructions. The full text of the EU Declaration of Conformity
is available at the following Internet address:
https://www.nubert.de/konformitaetserklaerungen/716/
• Do not change the serial number on the speaker. It is part of the operating
approval.
• If the loudspeaker is repaired or modied by workshops or other third parties
not authorized by Nubert, it loses its operating license.
• Only accessories and devices may be connected which in turn comply with all
legal requirements and are approved.
• The loudspeaker may only be used for the applications specied in the „In-
tended Use“ section
Intended use
This speaker is designed exclusively for sound reproduction in dry rooms. Use
the speaker only as described in this manual. Any other use (particularly safe-
ty-relevant or medical use, installation in open environment like IP-certied prod-
ucts) is considered improper and may result in property damage or even personal
injury. Nubert electronic GmbH does not assume any liability for damages caused
by improper use.
Safety instructions
The entire operating manual, in particular the safety instructions, must be read
in full before connecting and commissioning the device. For your own safety,
be sure to follow all warnings and safety instructions in this manual and on the
speaker. The user is not permitted to carry out any work on the loudspeaker
other than the described work. Keep this document so that you have access to
it at all times. Furthermore, it must also be handed over to possible re-owners.
nuSub XW-1200
1
Danger of injury or damage!
When moving the speaker, take care to avoid injury and damage!
Caution!
Since the speaker can only be completely disconnected from the mains at the
mains input on the rear of the unit or by pulling the mains plug from the socket, it
must be positioned so that you have free access to the mains input or mains plug.
If any of the following situations occurs, the loudspeaker must be switched off
immediately and disconnected from the mains. Contact Nubert electronic GmbH
(info@nubert.de) immediately!
• The speaker has been damaged or has fallen down.
• Power cord or plug is damaged
• Objects or liquid have got into the loudspeaker
• The speaker has been exposed to excessive moisture or rain.
• The speaker does not work properly or exhibits a signicant reduction in per-
formance.
• The loudspeaker smells burnt, develops smoke or makes unusual noises.
Caution!
The driver in this loudspeaker produces a strong magnetic eld in its immediate
vicinity that can affect or damage other equipment close by. It is therefore im-
perative that you keep magnetically sensitive devices and items away from the
loudspeaker. Never place CRT screens, notebooks, hard drives or similar on
the loudspeakers!
Only use accessories recommended by Nubert!
Installation instructions
Caution!
An unstable location can damage the speaker.
• Only place the loudspeaker on a at, stable surface and make sure that it
cannot be knocked over!
• Also make sure that no unintentional pulling can occur on the cables to avoid
knocking over the speaker or damaging the connection sockets!
• Keep strong mechanical shocks away from the loudspeaker!
Caution!
Excessive heat build-up inside the unit can shorten its service life or lead to re.
• Never cover the back of the speaker! Make sure that there is a clearance of at
least 10 cm and sufcient air circulation in the back area!
• Do not operate the speaker and remote control near heat sources such as
radiators or stoves!
• Do not set the speaker and remote control to direct sunlight.
• Do not expose to direct sunlight!
• Never place burning candles or similar open re sources on the loudspeaker!
Danger of explosion!
Installation in unsuitable locations can cause explosions. Do not use the speaker
or remote control
• in environments where there is a risk of re or explosion!
• at extremely low or extremely high temperatures!
• near ammable gases or vapours!
• near strong dust!
• near ammable materials!
Danger of electric shock!
The loudspeaker carries mains voltage and voltages higher than 35 V AC or DC
inside. It has no special protection against the intrusion of liquids or objects into
the system. There is therefore a risk of lethal electric shock.
• Never touch the speaker with wet hands!
• Only use the speaker in a dry place!
• Do not operate it outdoors or in damp rooms!
• The loudspeaker must be protected from liquids of all kinds, including dripping
and splashing water.
•
Do not place any containers containing liquids (e.g. ower vases) on the speak-
er or in the immediate vicinity!
• If the loudspeaker is moved from a cold environment to a warm room, conden-
sation may form inside the unit. Wait at least six hours until the loudspeaker
has reached room temperature and is dry before switching it on!
• No objects or foreign bodies may get into the device.
• Should the loudspeaker come into contact with liquids or should objects have
got inside, please unplug the mains plug immediately and contact Nubert elec-
tronic GmbH (info@nubert.de)!
Danger of injury or damage!
For speakers with threaded bushings on the underside:
The threaded bushings may be used for upright mounting of the loudspeaker on
suitable base plates only. The threaded bushings on the underside of the loud-
speaker enclosures are not designed for tensile loads and must therefore not be
used as holders for hooks or similar devices in order to suspend the loudspeaker
cabinet. A falling speaker may cause serious injury and damage.
Connection instructions
General connection instructions
• Disconnect the mains plug before changing any wiring on the system!
• Make sure that all connections have been made correctly and that all plugs
are rmly seated in the sockets before connecting the speaker to the mains.
• Use only the intended cables or plug connections for the connections! Failure
to do so may result in damage or malfunction.
•
If you want to disconnect connections on the loudspeaker, always pull the plug,
never the cable!
• Ensure that all plugs are rmly seated in the sockets!
• Only use cables and accessories recommended by Nubert!
Danger of electric shock!
Faulty mains supply systems or excessive mains voltage can lead to electric
shocks.
•
All power supply or antenna systems connected to the loudspeaker must com-
ply with all applicable laws and regulations and be professionally installed by
an approved installation company.
• Use only the appropriate power cord to connect the speaker. Do not modify
the power cord or its plug.
• Make sure that the mains voltage at your location matches the requirements
of the loudspeaker! The correct power supply can be found on the label on the
back of the speaker. It must not be connected to other power supplies.
• Devices of Class 1 construction must be connected to the mains power socket
outlet with a protective earth connection. Make sure that the installation of the
protective earth is carried out correctly!
• When laying the power cables, make sure that they cannot be damaged (e.g.
by heating or mechanical stress)! Pay particular attention to the areas of the
connectors and distributors!
Caution!
Overvoltage in the power supply system (e.g. due to lightning) can damage or
destroy the device and power supply unit.
• An overvoltage protection element can provide a certain degree of protection
against excessively high voltages in the power grid.
• However, the greatest possible protection against damage can only be
achieved with the complete separation from the mains supply.In case of thun-
derstorms or danger of lightning strikes, disconnect the mains cable from the
socket and any antenna plugs from your hi- system!
• If the speaker is not used for a long period of time or is unattended, the power
supply should be disconnected. Disconnect the mains plug from the socket!
nuSub XW-1200 · 12/2021 EN
22

Produkt Specifikationer

Mærke: Nubert
Kategori: Subwoofer
Model: nuSub XW-1200

Har du brug for hjælp?

Hvis du har brug for hjælp til Nubert nuSub XW-1200 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Subwoofer Nubert Manualer

Nubert

Nubert nuSub XW-1200 Manual

11 Februar 2025
Nubert

Nubert nuSub XW-900 Manual

1 Februar 2025
Nubert

Nubert nuBox AW-991 Manual

21 August 2024
Nubert

Nubert nuBox AW-331 Manual

15 August 2024
Nubert

Nubert nuBox WS-201 Manual

14 August 2024
Nubert

Nubert nuVero AW-17 Manual

14 August 2024
Nubert

Nubert nuBox AW-441 Manual

11 August 2024
Nubert

Nubert AW-880 nuBox Manual

10 August 2024
Nubert

Nubert nuJubilee AW-35 Manual

6 August 2024
Nubert

Nubert AW-850 nuBox Manual

1 August 2024

Subwoofer Manualer

Nyeste Subwoofer Manualer

Klipsch

Klipsch ProMedia SWS Manual

12 August 2025
RCF

RCF FLB60673 Manual

12 August 2025
Black Hydra

Black Hydra Delta 10S Manual

12 August 2025
RCF

RCF CMR-S 60T Manual

12 August 2025
RCF

RCF FLB60676 Manual

12 August 2025
RCF

RCF SUB 15-AS Manual

12 August 2025
RCF

RCF SUB 18-AS Manual

12 August 2025
Yamaha

Yamaha VXC8SB Manual

9 August 2025
PreSonus

PreSonus Eris Pro 10 Manual

6 August 2025
Ground Zero

Ground Zero GZRB 20SPL-ACT Manual

6 August 2025