Olivetti d-Copia 16MF Manual
Olivetti
Ikke kategoriseret
d-Copia 16MF
Læs gratis den danske manual til Olivetti d-Copia 16MF (132 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 27 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 14 anmeldelser. Har du et spørgsmål om Olivetti d-Copia 16MF, eller vil du spørge andre brugere om produktet?
Side 1/132

USER MANUAL

PUBLICATION ISSUED BY:
Olivetti Tecnost, S.p.A.
Via Jervis, 77 - 10015 Ivrea (ITALY)
www.olivetti .comtecnost
Copyright © 200 , Olivetti4
All rights reserved
September 2004
The manufacturer reserves the right to carry out modifications to the product described in this manual at any time
and without any notice.
The ENERGY STAR program is an energy reduction plan introduced by theUnited States Environmental Protection
Agency in response to environmental issues and for the purpose of advancing the development and utilization of
more energy efficient office equipment.
ENERGY STAR is a U.S. registered mark.
Your attention is drawn to the following actions which could compromise the conformity attested to above, as well
as the characteristics of the product:
• incorrect electrical power supply;
• incorrect installation, incorrect or improper use or use not in compliance with the warnings provided in the
User’s Manual supplied with the product;
• replacement of original components or accessories with others of a type not approved by the manufacturer, or
performed by unauthorised personnel.
The mark affixed to the product certifies that
the product satisfies the basic quality
requirements.
Divisione Business Prodotti Office

BASIC OPERATION GUIDE
4Copying at a previously
registered Zoom ratio:
Preset Zoom mode
( )Refer to page 3-8
5Making two-sided copies
from various types of
originals: Duplex mode
( )Refer to page 3-9
6Copying two-page originals
onto se
Split m
(Refer
7Automatic sorting of copy
sets: Sort mode
(Refer to page 3-14)
8Change of orientation of
copies by set: Offset mode
(Refer to Chapter 1,
Advanced Operation Guide)
9Combin
original
page: C
(Refer
Advanc
10 Making a margin space on
copies: Margin mode
(Refer to Chapter 1,
Advanced Operation Guide)
11 Making copies with clean
edges: Border Erase mode
(Refer to Chapter 1,
Advanced Operation Guide)
12 Use to c
one ope
Copyin
1, Adva
Guide)
51/2 × 8 1/2": 64 %
A5: 70 %
1
1
2
3
2
1
3
2
1
3
2
1
3
2
1
2
1

ii BA
Document Processor
(Refer to page 4-3)
Finisher
(Refer to page 4-8)
Job Separator
(Refer to page 4-12)
Key
(Ref
Fax Kit
(Refer to page 4-14)
Network Scanner Kit
(Refer to page 4-14)
Mem
(Com
(Ref
Hard Disk
(Refer to page 4-15)
Additional memory
(Refer to page 4-15)

BASIC OPERATION GUIDE
Energy Star Program........................................................v
• Safety Conventions .................... ............................. ........vi
• Caution Labels .............................................................. viii
• Installation Precautions ..................
• Power Supply/Grounding the Machi
• Precautions for Use........................
• Laser Safety ...................................
• Disconnection of Power..................
• CE Declaration of Conformity.........

iv BA
p y
the printer’s firmware (contents of its read-only memory).
Copyright
This Operation Guide is for 1650, 2050, and 25
1650 is referred to as 16 ppm (prints per minut
(prints per minute) model, and 2550 as 25 ppm
This guide, any copyrightable subject matter so
connection with the sale of the machine, are pr
rights are reserved. Any copies made of all or
copyrightable subject must contain the same c
material from which the copying is done.
Regarding Trade names
PRESCRIBE is a registered trademark of Kyoc
KIR (Kyocera Image Refinement) are trademar
Diablo 630 is a product of Xerox Corporation. I
product of International Business Machines Co
a product of Seiko Epson Corporation. Hewlett-
registered trademarks of Hewlett-Packard Com
name of Centronics Data Computer Corp. Pos
trademark of Adobe Systems Incorporated. Ma
trademark of Apple computer, Inc. Microsoft, W
are registered trademarks of Microsoft Corpora
trademark of International Business Machines
STAR is a U.S. registered mark. All other bran
registered trademarks or trademarks of their re
CompactFlash and CF are trademarks of SanD

BASIC OPERATION GUIDE
The International Energy Star Program has as its basic goals the
promotion of efficient energy use and the reduction of the environmental
pollution that accompanies energy consumption by promoting the
manufacture and sale of products that fulfill pro
International Energy Star Program standards r
devices come equipped with Low Power Mode a
a specified period of time since the last operati
a waiting state but enters Lower Power Mode o
reduces power consumption. This product is e
features as a result of its compliance with Inter
Program standards:
Low Power Mode
The device automatically enters Low Power M
machine inactivity. The period of time the mac
Low Power Mode can be lengthened. For furth
Power Mode, on page 3-18.
Auto Sleep Mode
The device enters Auto Sleep Mode after 30 m
models) or 45 minutes (25 ppm model) of mac
of time the machine is idle before entering Aut
lengthened. For further information refer to Au
19.
Duplex Mode
The Energy Star Program encourages the use
reduces the load on the environment. Your Sa
Representative can provide information about
capabilities to this device. For further informati
page 4-8.

vi BA
surrounding objects. Also, to ensure correct and safe usage of the
machine.
The symbols and their meanings are indicated below.
Symbols
The following symbols indicate that the related
warnings. Specific points of attention are indica
DANGER:Indicates that serious injury
possibly result from insufficient attention
compliance with the related points.
WARNING: Indicates that serious injury
from insufficient attention to or incorrect comp
points.
CAUTION: Indicates that personal injury
may result from insufficient attention to or inco
related points.
.... [General warning]
.... [Warning of danger of electrical shock]
.... [Warning of high temperature]

BASIC OPERATION GUIDE
action are indicated inside the symbol.
Contact your Service Representative to order a
if the safety warnings in this Operation Guide a
itself is missing.
.... [Alert of required action]
.... [Remove the power plug from the outlet]
.... [Always connect the machine to an outlet w

BASIC OPERATION GUIDE
danger of fire or electrical shock.
Avoid locations near radiators, heaters, or other heat sources, or
locations near flammable items, to avoid the danger of fire.
To keep the machine cool and facilitate changi
maintenance, allow access space as shown be
adequate space, especially around the vents, t
properly ventilated out of the machine.
Other Precautions
Adverse environmental conditions may affect t
performance of the machine. Install in an air-co
(recommended room temperature: around 73.4
around 50 %), and avoid the following location
the machine.
• Avoid locations near a window or with expo
• Avoid locations with vibrations.
• Avoid locations with drastic temperature flu
• Avoid locations with direct exposure to hot
• Avoid poorly ventilated locations.
If the floor is delicate, when the product is move
may be damaged.
Left:
11 13/16"
30 cm
Front:
39 3/8"
100 cm
R
R

x BA
WARNING: Plug the power cord securely into the outlet. If
metallic objects come in contact with the prongs on the plug, it
may cause a fire or electric shock.
WARNING: Always connect the machine to an outlet with a
ground connection to avoid the danger of fire o
in case of an electric short. If an earth connectio
contact your Service Representative.
Other Precautions
Connect the power plug to the closest outlet po
The power supply cord is used as the main disc
the socket/outlet is located/installed near the e
accessible.
Handling of Plastic Bags
WARNING: Keep the plastic bags that are
machine away from children. The plastic may c
and mouth causing suffocation.

BASIC OPERATION GUIDE
voltage parts inside the machine.
WARNING: Do not damage, break or attempt to repair the
power cord. Do not place heavy objects on the cord, pull it, bend
it unnecessarily or cause any other type of dam
These types of situations present a danger of f
shock.
WARNING: Never attempt to repair or dis
machine or its parts as there is a danger of fire
or damage to the laser. If the laser beam esca
danger of it causing blindness.
WARNING: If the machine becomes exce
smoke appears from the machine, there is an o
other abnormal situation occurs, there is a dan
electrical shock. Turn the power switch off (
{
)
absolutely certain to remove the power plug fro
then contact your Service Representative.
WARNING: If anything harmful (paper clip
fluids, etc.) falls into the machine, turn the pow
immediately. Next, be absolutely certain to rem
plug from the outlet to avoid the danger of fire o
Then contact your Service Representative.
WARNING: Do not remove or connect the
wet hands, as there is a danger of electrical sh
WARNING: Always contact your Service
for maintenance or repair of internal parts.
CAUTION: Do not pull the power cord wh
from the outlet. If the power cord is pulled, the w
broken and there is a danger of fire or electrica
power plug when removing the power cord from
CAUTION: Always remove the power plug
when moving the machine. If the power cord is
is a danger of fire or electrical shock.

xii BA
with your Service Representative in regard to cleaning of internal
parts. This is particularly effective if accomplished prior to
seasons of high humidity. Consult with your Service
Representative in regard to the cost of cleaning the internal parts of the
machine.
Other Precautions
Do not place heavy objects on the machine or
machine.
Do not open the upper front cover, turn off the p
power plug during copying.
When lifting or moving the machine, contact yo
Do not touch electrical parts, such as connecto
They could be damaged by static electricity.
Do not attempt to perform any operations not e
CAUTION: Use of controls or adjustments
procedures other than those specified herein m
radiation exposure.
Do not look directly at the light from the scanning
eyes to feel tired or painful.

BASIC OPERATION GUIDE
contact a physician.
If you do happen to ingest toner, rinse your mouth out with water and drink
1 or 2 cups of water to dilute the contents of your stomach. If necessary,
contact a physician.
If you do happen to get toner in your eyes, flus
water. If there is any remaining tenderness, co
If toner does happen to get on your skin, wash
Do not attempt to force open or destroy the To
Toner Box.
Other Precautions
After use, always dispose of the Toner Contain
accordance with Federal, State and Local rules
Store all consumables in a cool, dark location.
If the machine will not be used for an extended
paper from the Cassette(s) and Multi-Bypass T
package and reseal it.
Produkt Specifikationer
Mærke: | Olivetti |
Kategori: | Ikke kategoriseret |
Model: | d-Copia 16MF |
Har du brug for hjælp?
Hvis du har brug for hjælp til Olivetti d-Copia 16MF stil et spørgsmål nedenfor, og andre brugere vil svare dig
Ikke kategoriseret Olivetti Manualer
23 Juli 2025
16 November 2024
5 September 2024
21 August 2024
21 August 2024
20 August 2024
20 August 2024
20 August 2024
20 August 2024
20 August 2024
Ikke kategoriseret Manualer
- Y-brush
- Bernstein
- Sonel
- Werma
- Centerline
- Bugera
- AVMATRIX
- Jedo
- Lexar
- Pivo
- Longvie
- BrightSign
- Hertz
- MK
- Expressive E
Nyeste Ikke kategoriseret Manualer
26 Juli 2025
26 Juli 2025
26 Juli 2025
26 Juli 2025
26 Juli 2025
26 Juli 2025
26 Juli 2025
26 Juli 2025
26 Juli 2025
26 Juli 2025