On-Q MS3801 Manual

On-Q Højttaler MS3801

Læs gratis den danske manual til On-Q MS3801 (3 sider) i kategorien Højttaler. Denne vejledning er vurderet som hjælpsom af 46 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 23.5 anmeldelser. Har du et spørgsmål om On-Q MS3801, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/3

INSTRUCTION / INSTALLATION SHEET

evōQ™ 3000 In-Ceiling and In-Wall

Speakers

IS-0242 Rev. D

301 Fulling Mill Road, Suite G

Middletown, PA 17057

Phone (800) 321-2343 / Fax (717) 702-2546

www.onqlegrand.com

1. Introduction

On-Q/Legrand offers both in-ceiling and in-wall styles of

evōQ™ 3000 speakers. These two styles encompass two

(2) sizes and five (5) part numbers (as shown in Figure 1

to the right). The speakers are optimized for audio

distribution (central sound). All models are 2-way speakers

that feature Mica-Fiber woofers and PEI (Polyetherimide)

Mylar tweeters. These speakers come with dual templates

with center markings and paint rings. Optional speaker

pre-construction brackets are available for all models.

(*P/N MS3652, 6.5” In-Ceiling Dual Voice Coil Speaker, is

for reference only and part of this instruction sheet.) NOT

Disclaimer: Make sure you are in compliance with local

building codes before installing these speakers. On-Q

evōQ™ 3000 In-Wall and In-Ceiling Speakers are

suitable for moisture rich environments such as

bathrooms, saunas and outdoor applications.

2. Description

The On-Q/Legrand evōQ™ 3000 speakers are made of a tough semi-flexible plastic frames that feature a

built in foam gasket to minimize vibration and maximize seal-ability. They also feature a perforated metal grill

with an acoustically transparent scrim cloth to enhance the speakers appearance once installed . All evóQ

speakers, except sub woofers, are paint-able. They also come with painting shields to protect the drivers

while painting. These speakers are suitable for moisture rich environments. They also feature flip out tabs for

easy installation and removal.

3. Installation

Installation of the evōQ™ 3000 speakers is best accomplished at multiple times during new construction, at

“Rough-in” before the drywall is installed, and at “Trim-out” after the drywall is installed and painted.

A. “Rough-in” steps:

NOTE: It is recommended that a minimum of 16 gauge, 2 conductor wire be

used for most applications from the amplifier or volume control to the speaker.

Different gauges can, and should, be used based upon the distance of the

intended run or quality of installation (see Figure 2).

NOTE: All On-Q/Legrand lyriQ™ Audio components accommodate wire gauges

from 18 to 14.

1. Run x/2 conductor (x=gauge preference) stranded speaker wire from the distribution/volume control

to the speaker location (pre-wiring).

Distance Gauge

<10 Feet 18

10-50 Feet 16

>50 Feet 14

Speaker Wire

Gauge Selection Chart

Figure 2

In-Ceiling Style

(

shown w/o

rill

)

In-Wall Style

(

shown w/o

rill

)

6.5” – P/N MS3650 (pair)

8” – P/N MS3800 (pair)

* 6.5” Dual Voice Coil –

P/N MS3652 (each)

6.5” – P/N MS3651 (pair)

8” – P/N MS3801 (pair)

Figure 1

INSTRUCTION / INSTALLATION SHEET

evōQ™ 3000 In-Ceiling and In-Wall

Speakers

IS-0242 Rev. D

301 Fulling Mill Road, Suite G

Middletown, PA 17057

Phone (800) 321-2343 / Fax (717) 702-2546

www.onqlegrand.com

2. If an On-Q Speaker Pre-Construction Bracket is to be used, skip to

Step “5” and refer to IS-0243 for detailed instructions.

3. If pre-wiring without using the On-Q Pre-Construction Speaker

Brackets, leave 4 to 6 feet of wire at the speakers intended location.

Use a strip of cardboard stapled to the joints/studs with a hole

through it as a wire place holder for the drywall installers if

installation of the speakers is intended (see Figure 3).

4. After drywall and/or painting is complete, push wire through hole,

center template over hole, mark with a pencil and cut out with a dry-

wall knife.

5. When using the On-Q Pre-Construction Bracket (see

Figure 4), leave a coil of speaker wire on top of the

bracket coiled around the speaker mounting hole. There

are clips on the corner of the bracket to secure the

speaker wire. Leave enough speaker wire to be able to

pull the wire through the bracket and comfortably

connect the wire to the speaker after the drywall is

installed. Strip off 3 inches or so of the speaker cable

jacket to expose the positive and negative insulated

wires. Strip 3/8-1/2 inch of insulation off of these

conductors.

6. It is recommended to place insulation behind the

speaker to provide some damping for the woofer driver.

This will yield the best possible sound. On-Q

recommends using poly-encapsulated insulation such as

Johns Manville Comfort Therm®. If a defined, consistent

sound is desired from both speakers in a space, blocking

can be installed to yield the ideal cubic footage for each

driver. Insulation would then be put in this space during

speaker installation. Refer to blocking chart for

details.

7. If installing speakers in a space with an attic above it is

recommended that the speakers be boxed in with 1/2 inch

MDF (medium density fiber board) or plywood with

insulation installed. This will provide a defined acoustic

space and protect the speaker. The best possible sound

will be achieved by doing this. Refer to the blocking

chart for details.

Note: Make sure you are in compliance with local building codes before installing this speaker in

an attic space.

Figure 4

Figure 3

Blocking

Distance

Produkt Specifikationer

Mærke:	On-Q
Kategori:	Højttaler
Model:	MS3801

Har du brug for hjælp?

Hvis du har brug for hjælp til On-Q MS3801 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Højttaler On-Q Manualer

On-Q MS3801 Manual

17 August 2024

Højttaler Manualer

Nyeste Højttaler Manualer

Diamond Audio DMD652 Manual

15 Juni 2025

Rebeltec Rodos Manual

15 Juni 2025

Sanag M7 Manual

15 Juni 2025

GeekLJT LYYX-2AS Manual

15 Juni 2025

Defender Enjoy 20 Manual

15 Juni 2025

Rad Golf Sound Pro Manual

15 Juni 2025

Frewico X10 Manual

15 Juni 2025

Teufel Mynd Manual

15 Juni 2025

LENRUE A2 Manual

15 Juni 2025

Sony BRAVIA Theatre Bar 6 Manual

15 Juni 2025