Outdoor Connection Galaxy Manual

Outdoor Connection Fuld Galaxy

Læs gratis den danske manual til Outdoor Connection Galaxy (3 sider) i kategorien Fuld. Denne vejledning er vurderet som hjælpsom af 16 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 8.5 anmeldelser. Har du et spørgsmål om Outdoor Connection Galaxy, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/3

QUALITY YOU CAN SEE FEEL AND TRUST

GALAXY INSTRUCTIONS

1. Select a dry level area and clear the ground of any sharp or dangerous objects.

2. Spread out the floor of the inner tent and peg out the four corners, ensuring that the tent is pulled out fi and square . Peg out the rm (be careful not to make it too taut)

remaining pegging points. The adjustable straps on some of the peg loops should be set approximately in their middle position (not pulled up tight all these ). Adjusting

straps up tight r stress the inner tent and cause some seams to start separating.may ove

3. Assemble all the fibreglass poles and steel poles .

4. fibreglass poles. The pole sleeves are colour coded to the The 2 black poles go diagonally over the middle of the main tent and insert the ends into the plastic fitting . 2

grey grey poles go through sleeves . The remaining across the tent at each end poles go across the middle of the tent in the same direction as the end poles. Insert the

ends into the plastic fittings and clip the tent to the poles. The 2 yellow poles go lengthwise across the middle. Insert the ends into the plastic fittings and clip the tent to

the poles. a pole through a sleeve at each end of the tent and a square structure in the middle with diagonal po There be should now les.

5. You are now ready to erect the middle section of the tent. One end of the steel poles has a plug with a small hole, this is the bottom. With one person at either side of the

tent lift one side of the middle section and insert a pole in the plast , then fit the lower end over the pin attached to the floor of the tent. Repeat the process for steel ic fitting

the other side. The middle section of the tent should now be standing.

6. The remaining steel poles can now be fitted using the same process.

7. Attach all tent clips to the upright poles. You are now ready to fit the fly.

8. Position the fly over the tent and ie off the fly around the plastic elbow below the shock cord at the top of the pole tabs on the . Talign it into place s ( ) s. Attach the Velcro

inside of the fly to the poles. Peg out the fly ensuring an adequate gap between the fly and the inner.

9. Peg out all the guy ropes.

10. Finally, fine tune the fly so it remains and positioned correctly over the tent. The adjustment straps at some peg points can be used for small adjustments but make firm

sure that the tent is not too tight as the tent seams can be damaged

***** *****REVERSE THESE PROCEDURES TO LOWER THE TENT

Packing Instructions:

1. tent Make sure the inner and fly are COMPLETELY DRY and CLEAN before packing away.

2. Fold the fly in half lengthwise and fold the ends in to f m a rectangle. Then fold each end into the middle and continue folding until you have a long rectangle approx or

80cm wide and 250cm long. The bottom of the fly should be at one end.

3. Fold the sunroom o the inner tent over onto the main tent. F the inner tent into quarters lengthwise by folding both sides into the centre, then one half over the other.f old