Palmer PMB-L Manual

Palmer Splitter PMB-L

Læs gratis den danske manual til Palmer PMB-L (9 sider) i kategorien Splitter. Denne vejledning er vurderet som hjælpsom af 22 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 11.5 anmeldelser. Har du et spørgsmål om Palmer PMB-L, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/9

USER´S MANUAL

BEDIENUNGSANLEITUNG

MANUEL D`UTILISATION

MANUAL DE USUARIO

PMBL

LINE SUMMIERER 2 KANAL PASSIV

EN PREVENTIVE MEASURES

1.Please read these instructions carefully.

2.Keep all information and instructions in a safe place.

3.Follow the instructions.

4.Observe all safety warnings. Never remove safety warnings or other information from the equipment.

5.Use the equipment only in the intended manner and for the intended purpose.

6.Use only sufﬁciently stable and compatible stands and/or mounts (for ﬁxed installations). Make certain that wall mounts are properly installed and secured.

Make certain that the equipment is installed securely and cannot fall down.

7.During installation, observ e the applicable safety regulations for your country.

8.Never install and operate the equipment near radiators, heat registers, ovens or other sources of heat. Make certain that the equipment is always installed so

that is cooled sufﬁciently and cannot overheat.

9.Never place sources of ignition, e.g., burning candles, on the equipment.

10.Ventilation slits must not be blocked.

11.Do not use this equipment in the immediate vicinity of water (does not apply to special outdoor equipment - in this case, observe the special

instructions noted below. Do not expose this equipment to ﬂammable materials, ﬂuids or gases. Avoid direct sunlight!

12.Make certain that dripping or splashed water cannot enter the equipment. Do not place containers ﬁlled with liquids, such as vases or drinking

vessels, on the equipment.

13.Make certain that objects cannot fall into the device.

14.Use this equipment only with the accessories recommended and intended by the manufacturer.

15.Do not open or modify this equipment.

16.After connecting the equipment, check all cables in order to prevent damage or accidents, e.g., due to tripping hazards.

17.During transport, make certain that the equipment cannot fall down and possibly cause property damage and personal injuries.

18.If your equipment is no longer functioning properly, if ﬂuids or objects have gotten inside the equipment or if it has been damaged in anot her way,

switch it off immediately and unplug it from the mains outlet (if it is a powered device). This equipment may only be repaired by authorized, qualiﬁed

personnel.

19.Clean the equipment using a dry cloth.

20.Comply with all applicable disposal laws in your country. During disposal of packaging, please separate plastic and paper/cardboard.

21.Plastic bags must be kept out of reach of children.

FOR EQUIPMENT THAT CONNECTS TO THE POWER MAINS

22.CAUTION: If the power cord of the device is equipped with an earthing contact, then it must be connected to an outlet with a protective ground.

Never deactivate the protective ground of a power cord.

23.If the equipment has been exposed to strong ﬂuctuations in temperature (for example, after transport), do not switch it on immediately. Moisture

and condensation could damage the equipment. Do not switch on the equipment until it has reached room temperature.

24.Before connecting the equipment to the power outlet, ﬁrst verify that the mains voltage and frequency match the values speciﬁed on the equipment.

If the equipment has a voltage selection switch, connect the equipment to the power outlet only if the equipment values and the mains power values

match. If the included power cord or power adapter does not ﬁt in your wall outlet, contact your electrician.

25.Do not step on the power cord. Make certain that the power cable does not become kinked, especially at the mains outlet and/or power adapter and

the equipment connector.

26.When connecting the equipment, make certain that the power cord or power adapter is always freely accessible. Always disconnect the equipment

from the power supply if the equipment is not in use or if you want to clean the equipment. Always unplug the power cord and power adapter from the

power outlet at the plug or adapter and not by pulling on the cord. Never touch the power cord and power adapter with wet hands.

27.Whenever possible, avoid switching the equipment on and off in quick succession because otherwise this can shorten the useful life of the equip-

ment.

28.IMPORTANT INFORMATION: Replace fuses only with fuses of the same type and rating. If a fuse blows repeatedly, please contact an authorised

service centre.

29.To disconnect the equipment from the power mains completely, unplug the power cord or power adapter from the power outlet.

30.If your device is equipped with a Volex power connector, the mating Volex equipment connector must be unlocked before it can be removed. How-

ever, this also means that the equipment can slide and fall down if the power cable is pulled, which can lead to personal injuries and/or other damage.

For this reason, always be careful when laying cables.

31.Unplug the power cord and power adapter from the power outlet if there is a risk of a lightning strike or before extended periods of disuse.

CA UTIO N

RI SK OF SEL ECT RI C HO CK

DO N O NOT PE

CAUTION: Never remove the cover, because otherwise there may be a risk of electric shock. There are no user

serviceable parts inside. Have repairs carried out only by qualiﬁed service personnel.

The lightning ﬂash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated

“dangerous voltage” within the product’s enclosure that may be of sufﬁcient magnitude to constitute a risk of electrical shock.

The exclamation mark within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance

instructions.

CAUTION – HIGH VOLUME LEVELS WITH AUDIO PRODUCTS!

This equipment is intended for professional use. Therefore, commercial use of this equipment is subject to the respectively applicable national accident