Panamorph DCR-S2 Manual

Panamorph Beamer DCR-S2

Læs gratis den danske manual til Panamorph DCR-S2 (2 sider) i kategorien Beamer. Denne vejledning er vurderet som hjælpsom af 38 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 19.5 anmeldelser. Har du et spørgsmål om Panamorph DCR-S2, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

We bring cinema home

DCR-S2

INSTALLATION GUIDE

(Phillips #2 screwdriver required)

Anamorphic Lens System

CEILING OR SHELF MOUNTING. Regardless of the projector

orientation the DCR retainer should be installed with the prongs closer

to the ceiling so the Panamorph logo is upright after installation.

ABOUT GEOMETRIC DISTORTION. Anamorphic vertical

compression lenses such as the DCR naturally create a slight “barrel”

shaped curvature especially at the edges of the image. The amount of

this curvature is greatest at the minimum recommended projector

throw ratio of 1.4:1 and decreases as the projector is located

farther back from a given screen size. However, most content was

actually created with more internal geometric distortion than that from

an anamorphic lens. Once residual edge distortion is masked by the

edge of the screen the eﬀect becomes quite unnoticeable. Note that at

least some residual geometric distortion can be reduced using Sony’s

Calibration Pro software available from both Sony or Panamorph.

LIMITED WARRANTY. Panamorph, Inc. warrants this product against

any change in performance or functionality for a period of twenty-four

months from our ship date. During this period, a unit may be repaired

or replaced, at the discretion of Panamorph, Inc., by returning it in its

original packaging with a copy of your receipt. This warranty does not

cover damage resultant from lack of prudent care, accident or misuse

(including use with other products in ways not intended); any cosmetic

damage not reported within 15 days of purchase; or any performance

change caused by the environment in which it is used. All damages are

limited to the cost of the product.

CLEANING. Small amounts of dust and wipe marks are very

noticeable on lens surfaces with a high brightness projection beam but

typically will not impact the image as much as damage from excessive

cleaning in pursuit of a "perfect" optical surface. Occasionally blowing

oﬀ the lens surfaces with clean air is the best way to keep long term

performance. If there is any excessive residue or build-up then it is

recommended that you clean the optics with professional lens cleaning

supplies such as from a camera store while the lens is in front of the lit

beam of the projector. This will allow you to quickly see if the cleaning

process is causing any damage.

VPL-VW ES (International: VPL-VW ES)915 790

VPL-VW ES (International: VPL-VW ES)885 760

For use only with the following projector models:Sony

IMPORTANT THEATER GUIDANCE

1. Projection screen should be , in the aspect ratio and with a ﬂat 2.4:1

minimum 1.5″ border.

2. Projector should be horizontally centered on the screen +/- 3 inches

with minimal horizontal lens shift.

3. (throw distance divided by screen viewable width) Throw ratio

should be .at least 1.4:1

4. Projector should ideally be close to the top of the vertical position

screen with limits of up to 10% of screen height below to 30% of

screen height above for best performance. Beyond these limits may

prevent the beam from passing through the lens at low throw ratios.

DCR-S2 Instruction Guide Version 1.0

INSTALL THE DCR LENS RETAINER. Remove the two front

Phillips assembly screws from the lens/mount assembly and

remove the rear retainer (it comes loosely assembled).

Squeeze the retainer to ﬁt into the projector lens opening and

then relax it so that it nests into the inner rim of the opening with the

prongs level and the gap downward.

Show a 2.4:1 movie. Set the Sony anamorphic lens menu setting to

1.24X and the Aspect mode to V-Stretch. Make sure the projector

lens is clean and as dust free as possible.

PREPARE THE PROJECTOR. Make sure the projector lens is

horizontally centered in its opening (ie little or no horizontal lens

shift). Adjust the projector roll, tilt and/or yaw so the projector

test pattern lines are square to the screen edges and the test

pattern is centered on the screen. Then ...

INSTALL THE DCR LENS. Remove the rear DCR lens cover.

Tilt the DCR lens/mount assembly to insert the bottom mount

tabs through the bottom retainer gap and behind the projector

housing rim. Then tilt the assembly back and over the retainer

prongs. Remove the front protective ﬁlm; rotate the assembly so that

any visible edges of the movie appear the same on the left and right;

then insert and tighten the two assembly screws (do not over tighten).

ADJUST THE LENS TILT AND PROJECTOR SHIFT. Adjust

the projector lens zoom to ﬁll the width of the screen with the

movie. Tilt the DCR lens in its mount and adjust the projector

vertical lens shift to make sure the beam is getting through the

DCR lens to ﬁll the screen. There is only a slight variation in vertical

image height with this adjustment but experimentation may lead to the

best ﬁt. Lock the DCR lens tilt by tightening the single Philips tilt lock

screw. As desired you may want to adjust any panel alignment in the

projector (see Sony projector instruction manual).

DECIDE HOW TO WATCH 16:9 CONTENT. The “classic”

mode to watch 16:9 content is to set the projector anamorphic

mode to However, Squeeze. V-Stretch Normal or 2.35:1 ,

Zoom will better ﬁll the full cinema format screen with 16:9 with

various tradeoﬀs worth exploring. Note that menus are always created

in 16:9 so some type of switch from V-Stretch will be necessary to

show complete menu content.

DCR-S2 Installation Steps

Retainer nested into

projector lens opening

Assembly

screws

Tilt lock

screw

Produkt Specifikationer

Mærke:	Panamorph
Kategori:	Beamer
Model:	DCR-S2

Har du brug for hjælp?

Hvis du har brug for hjælp til Panamorph DCR-S2 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Beamer Panamorph Manualer

Panamorph DCR-S2 Manual

11 September 2024

Panamorph DCR-J1 Manual

11 September 2024

Beamer Manualer

Nyeste Beamer Manualer

Hisense 100L5ND Manual

2 April 2025

Philips NeoPix 130 Smart Manual

5 Marts 2025

Philips NeoPix 200 NPX200 Manual

5 Marts 2025

Sharp XP-P601Q Manual

20 Februar 2025

InFocus Genesis IN0026ST Manual

20 Februar 2025

20 Februar 2025

30 Januar 2025

30 Januar 2025

30 Januar 2025

Acer Vero PL3515ATV Manual

30 Januar 2025