Philips Series 500 S560 Manual

Philips barbermaskine Series 500 S560

Læs gratis den danske manual til Philips Series 500 S560 (6 sider) i kategorien barbermaskine. Denne vejledning er vurderet som hjælpsom af 43 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 22 anmeldelser. Har du et spørgsmål om Philips Series 500 S560, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/6

ENGLISH

Introduction

Congratulations on your purchase and

welcome to Philips! To fully benet from

the support that Philips offers, register your

product at www.philips.com/welcome.

Important

Read this user manual carefully before you

use the appliance and save it for future

reference.

Danger

- Keep the adapter dry (Fig. 1).

Warning

- The adapter contains a transformer.

Do not cut off the adapter to replace

it with another plug, as this causes a

hazardous situation.

- The appliance is not intended for use

by persons (including children) with

reduced physical, sensory or mental

capabilities, or lack of experience and

knowledge, unless they have been given

supervision or instruction concerning

use of the appliance by a person

responsible for their safety.

- Children should be supervised to

ensure that they do not play with the

appliance.

- Always unplug the appliance before

you clean it under the tap.

Caution

- Never use water hotter than 80°C to

rinse the appliance.

- Do not use the appliance, adapter or

any other part if it is damaged, as this

may cause injury. Always replace a

damaged adapter or part with one of

the original type.

- Never use compressed air, scouring

pads, abrasive cleaning agents or

aggressive liquids such as petrol or

acetone to clean the appliance.

- Water may leak from the socket at the

bottom of the shaver when you rinse

it. This is normal and not dangerous

because all electronics are enclosed in

a sealed power unit inside the shaver.

Compliance with standards

- This shaver is waterproof and complies

with the internationally approved

safety regulations. It is suitable for use

in the bath or shower and for cleaning

under the tap. For safety reasons, the

shaver can therefore only be used

cordlessly (Fig. 2).

- This Philips appliance complies with all

applicable standards and regulations

regarding exposure to electromagnetic

elds.

General

- The adapter is equipped with an

automatic voltage selector and is

suitable for mains voltages ranging from

100 to 240 volts.

- The adapter transforms 100-240 volts

to a safe low voltage of less than 24

volts.

General description (Fig. 3)

1 Protection cap

2 Shaving unit with shaving head holder

3 Shaving head holder release button

4 On/off button

5 Display

6 Retaining ring

7 Cutter

8 Guard

9 Shaving head holder

10 Trimmer

11 Adapter

12 Small plug

13 Cleaning brush

14 Storage pouch

The display

’Charging’ indication

- When the shaver is charging, the

battery symbol ashes (Fig. 4).

’Battery fully charged’ indication

- When the battery is fully charged,

the battery symbol lights up

continuously (Fig. 5).

- If you leave the shaver connected to

the mains, the light goes out after 30

minutes.

4222.002.5700.1

S560

www.philips.com/welcome

2 4

6 7

8 9

12 13

15 16

18 19

20 21

24 25

27 28

30 31

32 33

’Battery low’ indication

- When the battery is almost empty, the

plug symbol starts ashing (Fig. 6).

- When you switch off the shaver, the

plug symbol continues to ash for a

few more seconds.

Travel lock

You can lock the shaver when you are going

to travel. The travel lock prevents the shaver

from being switched on by accident.

Note: The travel lock cannot be activated

when the shaver is connected to the mains.

Activating the travel lock

1 Press and hold the on/off button until

the travel lock symbol stops ashing

and the motor stops running (Fig. 7).

The travel lock is now activated.

Note: If you release the on/off button before

the travel lock symbol stops ashing, the travel

lock is not activated.

Deactivating the travel lock

1 Press and hold the on/off button until

the travel lock symbol stops ashing

and the motor starts running.

The shaver is now ready for use again.

Note: When you start charging, the travel lock

is deactivated automatically.

Charging

It takes approx. 60 minutes to fully charge

the battery.

When you charge the shaver for the rst

time or after a long period of disuse, let it

charge for 90 minutes.

A fully charged shaver provides up to

40 shaving minutes.

If you have a heavy beard, the shaver may

provide less than 40 shaving minutes. The

number of shaving minutes may also vary

over time, depending on your shaving

behaviour, cleaning habits and beard type.

Charging

Do not charge the shaver in a closed

pouch or in the packaging.

1 Put the small plug in the shaver.

2 Put the adapter in the wall socket.

,The battery symbol on the shaver

ashes to show that the shaver is

charging (see chapter ‘The display’).

Note: When you remove the adapter from the

wall socket and leave the small plug in the

shaver, the shaver may not work for a few

seconds.

Using the shaver

Note: You cannot use the shaver while it is

connected to the mains.

Shaving

Skin adaptation period

Your rst shaves may not bring you the

result you expect and your skin may even

become slightly irritated. This is normal.

Your skin and beard need time to adapt to

any new shaving system.

We advise you to shave regularly (at least

3 times a week) for a period of 3 weeks to

allow your skin to adapt to the new shaver.

During this period, use your new electric

shaver exclusively and do not use other

shaving methods. If you use different shaving

methods, it is more difcult for your skin to

adapt to the new shaving system.

1 Press the on/off button to switch on

the shaver.

2 Move the shaving heads over your

skin. Make both straight and circular

movements (Fig. 8).

3 Press the on/off button to switch off

the shaver.

4 Clean the shaver after every shave

(see chapter ‘Cleaning and

maintenance’).

Wet shaving

You can also use this shaver on a wet face

with shaving foam or shaving gel.

To shave with shaving foam or shaving gel,

follow the steps below:

1 Apply some water to your skin.

2 Apply shaving foam or shaving gel to

your skin.

3 Rinse the shaving unit under the tap

to ensure that the shaving unit glides

smoothly over your skin.

4 Press the on/off button to switch on

the shaver.

5 Move the shaving heads over your

skin. Make both straight and circular

movements.

Note: Rinse the shaver under the tap regularly

to ensure that it continues to glide smoothly

over your skin.

6 Dry your face and thoroughly rinse

the shaver with a sufcient amount

of water after every shave. Make sure

you rinse all foam or shaving gel off

the shaver (see also chapter ‘Cleaning

and maintenance’).

Trimming

You can use the trimmer to groom

your sideburns and moustache.

1 Pull the shaving unit straight off the

shaver (Fig. 9).

Note: Do not twist the shaving unit while you

pull it off the shaver.

2 Insert the lug of the trimmer into the

slot in the top of the shaver (1). Then

press down the trimmer (2) to attach

it to the shaver (‘click’) (Fig. 10).

3 Press the on/off button to switch

on the trimmer. You can now start

trimming.

4 Press the on/off button to switch off

the trimmer.

5 Pull the trimmer straight off the

shaver (Fig. 11).

Note: Do not twist the trimmer while you pull

it off the shaver.

6 Insert the lug of the shaving unit into

the slot in the top of the shaver (1).

Then press down the shaving unit (2)

to attach it to the shaver

(‘click’) (Fig. 12).

Cleaning and maintenance

Never use compressed air, scouring pads,

abrasive cleaning agents or aggressive

liquids such as petrol or acetone to clean

the appliance and its accessories.

- Clean the shaver after every shave.

- Clean the shaving heads frequently

with Philips Shaving Head Cleaning

Spray (HQ110) for optimal shaving

performance.

- You can clean the outside of the

shaver with a damp cloth. Do not clean

the shaving unit with a cloth.

Cleaning the shaving unit

Be careful with hot water. Always check if

the water is not too hot, to prevent your

hands from getting burnt.

1 Switch off the shaver.

2 Rinse the shaving unit under a hot tap

for some time (Fig. 13).

Note: You can also clean the shaving unit with

the cleaning brush supplied.

3 After rinsing the appliance under the

tap, hold it upright for 10-15 seconds

to allow water to run out of the

bottom.

4 Press the release buttons on the

shaving unit (1) and pull the shaving

head holder off the shaving unit

(2). (Fig. 14)

5 Rinse the shaving head holder under a

hot tap for 30 seconds (Fig. 15).

Note: You can also clean the shaving head

holder with the cleaning brush supplied.

6 Carefully shake off excess water and

let the shaving head holder dry.

Never dry the shaving head holder with

a towel or tissue, as this may damage the

shaving heads.

7 Reattach the shaving head holder

to the shaving unit (‘click’) (Fig. 16).

Extra-thorough cleaning method

1 Switch off the shaver.

2 Press the release buttons on the

shaving unit (1) and pull the shaving

head holder off the shaving unit

(2) (Fig. 14).

3 Turn the retaining ring anticlockwise

(1) and lift it off the shaving head

(2) (Fig. 17).

Repeat this process for the other retaining

ring.

4 Remove the shaving heads from the

shaving head holder. Each shaving

head consists of a cutter and

guard. (Fig. 18)

Note: Do not clean more than one cutter and

guard at a time, since they are all matching

sets. If you accidentally put a cutter in the

wrong shaving guard, it may take several

weeks before optimal shaving performance

is restored.

5 Clean the cutter with the cleaning

brush supplied (Fig. 19).

6 Clean the inside of the guard. (Fig. 20)

7 After cleaning with the brush, clean

the cutter and guard under the

tap (Fig. 21).

8 Place the cutter back into the guard.

9 Put the shaving heads back into the

shaving head holder (Fig. 22).

Note: Make sure the projections of the

shaving heads t exactly into the recesses.

10 Place the retaining ring on the shaving

head (1) and turn it clockwise (2) to

reattach the retaining ring (Fig. 23).

The retaining ring is xed properly if the

two wings of the retaining ring are located

exactly under the projections of the shaving

head holder.

Repeat this process for the other retaining

ring.

Note: The shaving heads and retaining ring

should be rmly set in place before closing the

shaving unit.

11 Reattach the shaving head holder to

the shaving unit (‘click’). (Fig. 16)

Note: If the shaving unit does not close

smoothly, check if you have positioned the

shaving heads properly and if the retaining

rings are xed properly.

Cleaning the trimmer

Clean the trimmer after every use.

Cleaning the trimmer under

the tap.

1 Switch on the appliance with the

trimmer attached.

2 Rinse the trimmer under a hot tap for

some time (Fig. 24).

3 After cleaning, switch off the appliance.

4 After rinsing the appliance under the

tap, hold it upright for 10-15 seconds

to allow water to run out of the

bottom.

Produkt Specifikationer

Mærke:	Philips
Kategori:	barbermaskine
Model:	Series 500 S560

Har du brug for hjælp?

Hvis du har brug for hjælp til Philips Series 500 S560 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

barbermaskine Philips Manualer

Philips Series 3000 S3233 Manual

1 April 2025

Philips NorelcoS1311 Manual

13 Marts 2025

Philips Norelco S6600 Manual

13 Marts 2025

Philips i9000 Prestige Manual

12 Marts 2025

Philips Series 9000 XP9404 Manual

12 Marts 2025

Philips 1000 Series S1151 Manual

12 Februar 2025

Philips OneBlade Pro QP6506 Manual

14 Januar 2025

Philips PQ209 Manual

21 December 2024

Philips Oneblade Pro QP6650 Manual

21 December 2024

Philips Styleshaver QS6162 Manual

21 December 2024

barbermaskine Manualer

Nyeste barbermaskine Manualer

Teesa TSA0213 Manual

3 April 2025

Braun Series 5 570cc Manual

2 April 2025

Braun Prosonic 9765 Manual

2 April 2025

BaByliss Super-X Metal S996E Manual

27 Februar 2025

BaByliss Graphite Precision MT987E Manual

26 Februar 2025

Braun Series 8 8510s Manual

21 Februar 2025

Braun Series 9 Pro 9599cc Manual

21 Februar 2025

BaByliss Triple S T880E Manual

13 Februar 2025

Braun Series 9 Pro 9376cc Manual

8 Februar 2025

Melissa 16670085 Manual

14 Januar 2025