Planet Audio PM30B Manual

Planet Audio Ikke kategoriseret PM30B

Læs gratis den danske manual til Planet Audio PM30B (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 31 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 16 anmeldelser. Har du et spørgsmål om Planet Audio PM30B, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Installation

Connect all wiring harness and slide the head unit into the

mounting sleeve until it clicks into place.

Wiring Connections

ANT

F-R R-R

F-L R-L

Radio Antenna

White

Front Left

Speaker

Rear Left

Speaker

Front Right

Speaker

Rear Right

Speaker

White/Black

ACC + (Red)

GND - (Black)

ANT + (Blue)

Power B+ (Yellow)

Gray/Black

Purple

Purple/Black

Green

Green/Black

Gray

Red: Front Right PRE-AMP Output

White: Front Left PRE-AMP Output

White: Rear Left PRE-AMP Output

Red: Rear Right PRE-AMP Output

Installation

Installation Procedures

First complete the electrical connections and then check for correctness of

connection.

Insert the mounting sleeve into the dashboard. Then bend the tabs

on the mounting sleeve with a screwdriver to achieve fastening of

the mounting sleeve.

Make sure that lock lever is flush with the mounting sleeve( not

projecting outward).

Installation Opening

This unit can be installed in any dashboard which has an opening as shown

below.

2.05 inches

7.20 inches

B ket keyrac

Mounting sleeve

B ket keyrac

Plastic trim out

10.

11.

12.

13.

15.

Turn Unit on/off, Change the Source

• Press the button to turn on the unit. Press and hold the /SRC /SRC

button to turn off the unit.

• Press the button to select the different modes: Radio, USB(with/SRC

USB device inserted), AUX-IN(auxiliary input) and BT(Bluetooth) modes.

Adjust the volume

Rotate the volume knob to increase or decrease the volume level.

Push-To-Talk

Press the button (volume knob) to access to smartphones voice assistant

capability via Bluetooth.

Overview of the Components

General Operation

(power) / SRC (source) button

VOL (volume) knob, (Push-To-Talk) button, SEL (select/menu) button

BAND button, (answer call) button

(pause/play), Preset station 1 button

RPT (repeat), Preset station 3 button

-10(previous 10 tracks), previous folder, Preset station 5 button

INT (intro), Preset station 2 button

RDM (random), Preset station 4 button8.

+10(next 10 tracks), next folder, Preset station 6 button

CLK (clock setting), (end call) button

(tune/seek down, previous track, fast reverse) button

(tune/ seek up, next track, fast forward) button 14. EQ (Equalizer) button

Hands-free Microphone 16. MUTE button 17. Loud(Loudness) button

18. LCD Display 19. USB Port 20. AUX IN(aux audio input)jack 21. Reset button

Adjust Menu Options

• Press and hold the volume knob to enter into setting menu, then press the

volume knob repeatedly to select setting items:

- ILL MID/HI/LOW: This receiver is equipped with 3 brightness settings.

Rotate the volume knob to preset the illumination to middle, high or low.

- BASS/TREBLE:-7, -6, ~, 1, 0, +1,~, +6, +7

- BALANCE:L7, L6,~, L1, 0, R1,~,R6, R7

- FADER:R7, R6, ~, R1, 0, F1, ~ ,F6, F7

- Loudness: LOUD ON/OFF

- EQ(Equalizer) Setting: OFF, FLAT, CLASSIC, POP, ROCK, JAZZ

- Stereo/Mono: Switches between MONO and STEREO reception mode

for radio frequencies.

- DX/LOCAL: Enables or disables the local broadcast mode (LOCAL).

- CLOCK 12/24: Select between 12 hours and 24 hours display.

- AREA US/EU: This car radio is equipped the USA / Europe frequency.

Rotate the volume knob to switch between USA and Europe frequency.

• Rotate the volume knob to change values.

Setting the Clock

Press the button to display time. Press and hold the button the CLK CLK

hours digits start flashing on the display. Set hours by rotating the volume

knob. Briefly press the button. The minute digits start flashing. CLK

Set minutes by rotating the volume knob.

Mute On/Off

In power on mode, briefly press the button to toggle mute on or off. MUTE

Preset EQ (Equalizer)

Press the button to toggle: OFF, FLAT, CLASSIC, POP, ROCK, JAZZ.EQ

Loudness on/off

Press the button to turn on the loudness to reinforce the output of bass LOUD

frequencies, press againto turn it off.

USB Port

Connect to a USB device for audio play, or charging of a mobile phone.

Hands-free Microphone

To receive your voice when you calling by using this bluetooth handsfree

system.

Aux Audio Input Jack

Connect to the headphone jack on an external device (e.g. a mobile phone

or MP3 player) for audio play.

General Operation General Operation

Radio Operation

Switch Between USA area and Europe area Frequency

In radio mode, press and hold the button (volume knob) to enter settingSEL

menu, then press the volume knob repeatedly to access the state of the USA

and Europe frequency, then rotate the volume knob to switch between USA

and europe frequency. The system will change the frequency setting in about

3 seconds.

Change Bands

In radio mode, shortly press the button to switch between theBAND

FM1(F1), FM2(F2), FM3(F3) and AM1(A1), AM2(A2) bands.

To Store / Recall Preset Stations

The radio can be stored 6 preset stations for each band (FM1, FM2, FM3,

AM1 and AM2) for a total of 30 preset stations.

- To memorize a station:

Press and hold the desired preset buttons (1-6) to save a radio station.

- To recall a preset station:

Briefly press the respective station button (1-6) to recall the corresponding

preset station.

Manual Tuning

In the radio mode:

Press and hold the or button to enter the manual tuning mode.

In manual tuning mode, briefly press the or button to search the next

or previous frequency step by step.

Seek Tuning

In radio mode, press the or button, the automatic search will start, it

will search upward or downward for the strong signal radio station within the

current band. The auto searching will stop until find a station.

Automatic Store Preset station (AMS)

Press and hold the button to store 18 FM stations and 12 AM stations AMS

automatically.

press the button to recall each preset station that stored in the AMS

memories in each band.

Reset

Push the button with a thin object with a pointed end to reset the unit.RESET

This function may be used when the LCD does not display normally or sound

is distorted, or when any of controls are disabled.

- Only support speakers of 4 ohms or above.

- +12V DC Negative Ground.

- The maximum current of the Amp remote trigger is 200mA.

- The equipment shall be protected by the circuit with max. 10

Amperes of the front end of DC source.

4. AMS(automatic store station, preset station scan, automatic music search)

Produkt Specifikationer

Mærke:	Planet Audio
Kategori:	Ikke kategoriseret
Model:	PM30B

Har du brug for hjælp?

Hvis du har brug for hjælp til Planet Audio PM30B stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Planet Audio Manualer

Planet Audio P90CPAP Manual

17 Juni 2025

Planet Audio PCPA975W Manual

17 Juni 2025

Planet Audio PM30B Manual

17 Juni 2025

Planet Audio P9900CPAP Manual

17 Juni 2025

Planet Audio P90CPACP Manual

17 Juni 2025

Planet Audio PC35B Manual

16 Juni 2025

Planet Audio PCPA975WP Manual

16 Juni 2025

Planet Audio PCBLK3.5 Manual

16 Juni 2025

Planet Audio P100CPAP Manual

16 Juni 2025

Planet Audio PM40RGB Manual

16 Juni 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Microchip MPF300T Manual

26 November 2025

Mars Gaming MARM-PRO2 Manual

26 November 2025

Icon U44 Manual

26 November 2025

Russell Hobbs Powersteam Ultra Pro 28630-56 Manual

26 November 2025

Icon Cube2Nano Pro Manual

26 November 2025

Ikea BAKTRADITION 904.801.75 Manual

26 November 2025

Fantech APEXGRIP FMH01 Manual

26 November 2025

Blumfeldt Perth Manual

26 November 2025

Comatec PSM46012 Manual

26 November 2025

Microchip M2GL025 Manual

25 November 2025