
PSD1-1000 - Soap Dispenser
PSD1-1000 - Soap Dispenser
PolyJohn Enterprises Corp
Wetherby, England LS22 7RD
Phone: 44 (0) 1937-583333
We recommend reading through the entire information booklet prior to proceeding with
installation, service and maintenance. All references to left and right throughout the booklet
are as viewed from the front of the restroom.
•Drill • 13/64” Drill Bit • Rivet Gun
Step 1. Remove the lid by turning
counterclockwise and lift up.
Step 2. Push the locking tab back and lift up
on the soap dispenser container.
Step 3. Holding the backing plate in the place
where you would like to mount the dispenser,
mark the placement for the three mounting
Step 4. Secure the backing plate in place using
Step 5. Slide the soap container back in place,
making sure the locking tab is in place, and ll with
liquid soap. If the dispenser is tted with a foaming
pump, only foaming soap may be used.
Step 6. Replace the lid and secure in place by
Full Size Scale Fasteners
• Use only mild cleaners with no abrasives
using a soft cloth to clean all surfaces.
• Some silicone grease should be applied
occasionally to the o-ring at the top of the
soap container to keep the lid from sticking.
Mineral oil should NEVER be used.
• If there is a chance for freezing, remove the
dispenser and drain the soap. Be sure to
remove the soap from the pump as well.
The PSD1-1000 PolyJohn soap dispenser is the
rst soap dispenser designed speci cally
for the portable restroom environment.
• A completely sealed soap container
to keep soap from spilling when
transporting the restroom
• A lid that secures onto the soap
container after removing from the
restroom for spill-less storage
• Easy to clean, smooth surfaces
• Capable of regular liquid soap or
foaming soap by changing out the
• Clear container to see the level of soap
•NOT FOR USE WITH ALCOHOL BASED