Posh P2 Manual

Posh Højttaler P2

Læs gratis den danske manual til Posh P2 (6 sider) i kategorien Højttaler. Denne vejledning er vurderet som hjælpsom af 61 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 31 anmeldelser. Har du et spørgsmål om Posh P2, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/6
Thank you for selecting this Posh
high-performance speaker. Posh has
gained an enviable track record
providing professionals with
audiophile-quality speakers for
commercial and residential installations.
Mounting Instructions
Installation Guide
P1 & P2
Surface Mount Speakers
Sound Solutions for the Real World
Speaker Systems
Unscrew the fastener at the top and bottom of the speaker
and remove the U-bracket.
Step 1
Step 2
Step 3
Fastener
U-bracket
5
5
10
10
2.5
1.25
.0625 1.25
2.5
DO
NOT
USE
8 Ω
8
Ω
70V
100V
Red Positive
Input Screw
Using the U-bracket mark and drill mounting holes where
you wish to mount your speaker. Attach U-bracket to wall
or ceiling, using appropriate mounting hardware.
NOTE: Construction work for the installation of any Posh
product should be performed by a qualified, licensed installer
and conform to all applicable building codes. A local building
inspector should approve any overhead installations.
Strip 3/8 inch of insulation off the wire ends. Secure the speaker wire (positive
+ red or white) and (negative – black or green) under the corresponding input
terminal block screw located on the back of the speaker. When daisy chaining
multiple speakers, twist the two stripped ends of the positive wires together and
secure under the positive input terminal block screw. Then twist the two
stripped ends of the negative wires together and secure under the negative
input terminal block screw.
Step 4
Decide whether to mount your speakers vertically or horizontally using
the enclosed U-bracket.
Red Positive
Input Screw
Silver Negative
Input Screw
Silver Negative
Input Screw
Adjust the wattage tap selector
located at the back of the
speaker for either 8 ohm (8 )Ω
or appropriate 70/100 volt
setting.
Step 5
Screw supplied fasteners through U-bracket and into the two holes
located on either end of the speaker.
NOTE: The brass insert, located on the back of the speaker is
for use with the optional Posh ball and socket mounting system. In
addition, tamper proof screws may be ordered as an option for a more
secure installation.
Step 6
5
5
10
10
2.5
1.25
.0625 1.25
2.5
8 Ω
8 Ω
DO
NOT
USE
7.5
10
15
15
5
70V
100V
2.5
1.25 2.5
5
DO
NOT
USE
rotceleS 2ProtceleS 1P
8 Ω
8
Ω
70V
100V
8 Ω
8 Ω
15
15
30
30
7.5
70V
100V
3.75
1.88 3.75
7.5
DO
NOT
USE
P2-T30 Selector
U-bracket
Brass insert
Fastener
5
5
10
102.5
1.25
.0625 1.25
2.5
DO
NOT
USE
8 Ω
8 Ω
70V
100V
WARRANTY PERIOD: 5 (five) years
WHAT IS COVERED. This Warranty covers defects in materials and
workmanship only. This Limited Warranty does not extend to: (1) cos-
metic damage; (2) damage caused by shipment; (3) damage caused by
accident, abuse, misuse, or failure to install the speakers in a manner as
set forth in this Installation Guide; (4) failure resulting from use contrary
to that set forth in this Installation Guide.
WHAT YOU MUST DO TO OBTAIN WARRANTY SERVICE. In the
event that your speakers require service, call Posh Speaker Systems
toll-free at 800-841-8501, Monday through Friday 8am to 4:30pm Pacific
Time, or fax us at 206-842-0494. You will receive instructions on how to
return your speakers for warranty service. Initial shipping costs may not
be paid by Posh Speaker Systems at our discretion. However, return
shipping will be prepaid if repairs are covered by the scope of this
Warranty. Do not send speakers to Posh for repair unless you have
first contacted us via telephone or fax. Posh Speaker Systems ship-
ping address: 7861 NE Day Road West, Bainbridge Island, WA 98110.
LIMITATIONS OF IMPLIED WARRANTIES.
ALL IMPLIED WARRANTIES FOR MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE ARE LIMITED IN DURATION TO THE WARRANTY
PERIOD UNLESS OTHERWISE PROVIDED BY STATE LAW.
EXCLUSION OF CERTAIN DAMAGES. IN NO EVENT SHALL POSH
SPEAKER SYSTEMS, BE LIABLE FOR PROPERTY OR ANY OTHER INCIDEN-
TAL OR CONSEQUENTIAL DAMAGES WHICH MAY RESULT FROM THE FAIL-
URE OF THIS PRODUCT. IF YOUR POSH SPEAKERS PROVE DEFECTIVE IN
MATERIAL OR WORKMANSHIP, THE LIABILITY OF POSH SHALL BE LIMITED
TO THE REPAIR OR REPLACEMENT, AT THE OPTION OF POSH, OF ANY
DEFECTIVE PART.
STATE LAWS MAY DIFFER. SOME STATES DO NOT ALLOW LIMITATION
ON HOW LONG AN IMPLIED WARRANTY MAY LAST, AND/OR DO NOT ALLOW
THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL
DAMAGES, OR DO NOT ALLOW CERTAIN LIMITATIONS SET FORTH IN THIS WAR-
RANTY, SO THE ABOVE LIMITATIONS MAY NOT APPLY. THIS WARRANTY GIVES
YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY HAVE OTHER RIGHTS WHICH
VARY FROM STATE TO STATE.
OTHER IMPORTANT PROVISIONS. Posh Speaker Systems reserves the right to
make changes in design and improvements in its products without the responsibility of
installing such changes on products previously sold by Posh.
UL REQUIREMENTS. Representative samples of the P1 and P2 have been
investigated by Underwriters Laboratories and determined to comply
with the applicable requirements of UL1480, Speakers for Fire
Alarm, Emergency, and Commercial and Professional Use, Fifth
Edition. These requirements cover speakers intended for one or more of the following:
Commercial and professional audio systems providing non-emergency sound
reinforcement and reproduction in accordance with NFPA 70 and includes equipment for
institutional, industrial use. Non-fire emergency voice warning systems in accordance
with NFPA 70; examples of non-fire emergency-warning systems include, but are not
limited to:
1) Critical process monitoring (nuclear plant, oil refinery, hazardous chemical processing);
2) Distress alert systems (help for handicapped, for life safety, for rape, for robbery);
3) Crowd control in public places ;(sporting arena, theater, shopping mall, transportation center)
4) Non-fire emergency voice-systems covered by the Life Safety Code, NFPA 101
CUL Listed - CSA Standard C22.2 No. 205-M1983
For installation please refer to P1 & P2 Surface Mount Speaker Installation Guide, Rev1 3/20/08.
P1 and P2 Surface Mount Speaker Limited Warranty
The preceding warranty is exclusive to the United States, its territories and possessions. Please see
your authorized Posh dealer or distributor for the correct warranty information in your area or locale.
© 2004 Posh Speaker Systems. All rights reserved. Printed in China.
Rev1 3/20/08
7861 N. E. Day Road West, Bainbridge Island, WA 98110
Phone: 800-841-8501 • Fax 206-842-0494
www.poshspeakers.com
Sound Solutions for the Real World
Speaker Systems

Produkt Specifikationer

Mærke: Posh
Kategori: Højttaler
Model: P2

Har du brug for hjælp?

Hvis du har brug for hjælp til Posh P2 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Højttaler Posh Manualer

Posh

Posh P2 Manual

24 August 2024

Højttaler Manualer

Nyeste Højttaler Manualer

TOA

TOA TZ-406BWP AS Manual

10 Oktober 2025
TOA

TOA CS-761BS-W Manual

10 Oktober 2025
TOA

TOA BS-4W Manual

10 Oktober 2025
TOA

TOA TZ-606W AS Manual

10 Oktober 2025
TOA

TOA BS-634T Manual

10 Oktober 2025
TOA

TOA TZ-200BS Manual

10 Oktober 2025
TOA

TOA TZ-606WWP AS Manual

10 Oktober 2025
TOA

TOA PC-275AB-EB Manual

10 Oktober 2025
TOA

TOA CS-761B Manual

10 Oktober 2025
TOA

TOA TZ-206B AS Manual

10 Oktober 2025