PowerBridge TWO-CK Manual

PowerBridge Ikke kategoriseret TWO-CK

Læs gratis den danske manual til PowerBridge TWO-CK (3 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 19 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 10 anmeldelser. Har du et spørgsmål om PowerBridge TWO-CK, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/3

Power Cable Connector Kit Model #TWO-CK

Power Extension Cable Management

Caution - Risk of Fire - Do Not Install Power Supply Cord Within the Wall Cavity

WARNING - Risk of Fire and Shock, Do Not Connect this Box to any Other Circuits or Outlets.

This kit is rated to 15AMP 125Volt AC only

Do not install this product near water, example, near a sink, tub, shower, swimming pool or laundry area.

Manufacturer is not liable for damages due to improper installation methods not followed herein.

This product does not have built-in electronic circuitry for surge protection or A/C filtering.

It is recommended that this product be connected to a quality surge-protector/power conditioner for equipment protection.

Disclaimer. HD-Products, Inc. the Manufacturer, it's agents, suppliers, and affiliates, shall not be liable for any damages, not limited to; misuse, acts of nature,

verbal and written expression and improper installation. Improper installation is determined such to include, not limited to, non-code compliant installation, product

modifications, alterations, adjustments, and substitutions of components or materials.

Limited 2-year Warranty from Manufactures Defects: Limited Two Year product warranty against manufacturer's defects.

Step 1 Location - Wall Cutout

PowerOUT - Determine TV wall mount bracket location.

Align between wall framing studs.

Use stud finder to determine in-wall obstructions

between framing both VERTICALLY and HORIZONTALLY.

Install in any direction, right/left, below, above,

next to TV wall bracket.

PowerIN - Align with upper PowerOUT within same stud-bay

no more than 60” apart.

Install within 60” from an existing power outlet or power-surge device.

Use supplied template sheet to mark area to cut out from drywall.

Use a level to maintain proper alignment.

Carefully use drywall saw or utility knife to cut along outside of line.

Do not exceed more

than 60” apart

(Unless installing

with Extension kit

part# CKRE)

Do not exceed more

than 60” apart from

existing outlet or

surge-protection unit

PowerOUT

PowerIN

HD-Products, Inc., intent to make this manual accurate and complete. However, HD-Products, Inc., makes no claim that the information contained herein covers all details, conditions, or

variations. Nor does it provide for every possible contingency in connection with the installation or use of this product. The information contained in this document is subject to change

without notice or obligation of any kind. HD-Products, Inc., makes no representation of warranty, expressed or implied, regarding the information contained herein.

HD-Products, Inc/LLC. PowerBridge Solution 3869 Norwood Dr. Littleton, CO 80125 USA

Customer Service: 855-755-9838 info@powerbridgesolution.com www.PowerBridge1.com

Kit Includes:

72” Powerwire Prewired Dual PowerOutlet | 12” Powerwire Prewired PowerInlet

Pre-wired PowerConnectors | 72” PowerConnect Supply Cord | Template

PowerBridge can only be installed

within standard construction walls.

Only attempt installation within

2x4 or 2x6 wood/metal stud

framed wall.

If insulation exists,

remove or push