Always make sure the juice extractor is properly and completely assembled
before operating. The unit will not turn on unless properly assembled. Before
turning the juicer on, install and make sure that the juicing filter, recollecting
ring tray and motor unit are completely assembled in their correct position
and there is no forced contact between the juicing filter and clear cover. Place
the clear cover on, fasten the handle before turning the juicer on.
Before juicing, the motor works in a “running-in” state. There might be a
slight smell and noise right after you turn on the appliance. It is very .normal
Let the motor run without load for about 10 seconds. After the motor works
for some period, the slight smell and noise will disappear.
DO NOT PUT YOUR FINGERS OR OTHER OBJECTS INTO THE JUICER
OPENING WHILE IT IS IN OPERATION. IF FOOD BECOMES LODGED IN
THE OPENING, USE FOOD PUSHER OR ANOTHER PIECE OF FRUIT OR
VEGETABLE TO PUSH IT DOWN. WHEN THIS METHOD IS NOT
POSSIBLE, TURN THE MOTOR OFF, UNPLUG FROM OUTLET AND
DISASSEMBLE JUICER TO REMOVE THE REMAINING FOOD.
Be sure to turn switch to off position “O” (OFF) after each use of your juicer.
Make sure the motor stops completely before disassembling. Always turn the
juice extractor off first before unplugging it from the outlet.
During use, make sure excess juice or pulp residue do not accumulate
excessively in the juicing filter, recollecting ring or pulp collector container. If
any of those are too full, please turn the juicer off, clean up the components,
and then resume using the juice extractor.
Always make sure juicer lid/cover is clamped securely in place before motor
is turned on. unfasten clamps while juicer is in operation. AvoidDO NOT
contact moving parts. touch the small cutting blades located at theDO NOT
base of the stainless steel filter. push produce into the feed chuteDO NOT
with your fingers. Always use the food pusher provided. touch theDO NOT
small cutting blades in the base of the stainless steel filter basket.
