Getting started
3. Power on/Power off
z Position the device in the vehicle using the suction mount and press
the Power button to turn it on. To power off the device press the
button again.
z You can also connect the device to the car charger. It will
automatically turn on and start recording when the car engine starts.
When the engine stops, the device will automatically save the last file
and turn off.
4. Charging
z Using the power cable: connect the device to the USB port of a
computer/Laptop
z Using the car changer: Connect the device to the car charger. The
device will start charging after the car engine is turned on. The device
will automatically turn on and start recording. When the engine stops,
the device will automatically save the last file and turn off.
z Normally it takes approximately 2-3 hours to fully charge the device.
Operating the device while charging with the Car Charger may extend
the time of full charge.
Note:
Before using the device for the first time, please, connect it to the PC
or notebook using the USB cable provided to fully charge the battery.
The battery is completely charged in 2-3 hours.
5. Inserting the Micro SD-card
z Before starting video recording, please, insert a Micro SD card (not
included) into the Micro SD card slot in the device (need to open the
battery door).
z To extract the Micro SD card slightly push it inside the device, and
remove.
Note:
After inserting the Micro SD card the device will automatically
recognize it as default storage and all the data will be saved on this
card.