Prima LPR601 Manual

Prima Opvaskemaskiner LPR601

Læs gratis den danske manual til Prima LPR601 (8 sider) i kategorien Opvaskemaskiner. Denne vejledning er vurderet som hjælpsom af 2 personer og har en gennemsnitlig bedømmelse på 3.9 stjerner ud af 1.5 anmeldelser. Har du et spørgsmål om Prima LPR601, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/8
GB
-1-
Chart
PROGRAMME SELECTION BUTTON
Press this button (repeatedly) until the indicator of the required programme lights
up (see “Table of programmes” below).
ON
BUTTON
OFF
BUTTON
The indicator lights up during operation, flashes when a fault occurs and goes off at
the end of the programme.
START BUTTON RESET FUNCTION
Press this button for at least 2 seconds; the selected programme and options are
cancelled. Main failure displays (repeated flashing of the START indicator lamp) can
be cancelled by RESETTING. Detailed instructions are given in chapter “What to
do if...”.
1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional
options) and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor programmes as a result of
the appliance’s automatic calibration system.
2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information
on the EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.
Table of programmes
Detergent
Consumption
P
Programmes Loading instructions Litres kWh
Minutes
1)
1
Pre-Wash cold
Crockery to be washed later. —5.0 0.02 10
2
Quickwash 40°C
Lightly soiled crockery, with no
dried-on food. * Use of tablets not
recommended.
X*13.0 0.70 30
3
Bio
2)
50°C
Normally soiled crockery. Energy
saving programme with prolonged
drying cycle.
X 16.0 1.05 195
4
Daily 60°C
Normally or heavily soiled crockery. X 16.0 1.35 120
5
Intensive 70°C
Recommended programme for
heavily soiled crockery, especially
suitable for pots and pans.
X 17.0 1.65 145
5019 696 01535LPR 601
BEFORE USING THE APPLIANCE FOR THE
FIRST TIME CAREFULLY READ THIS QUICK
REFERENCE GUIDE AND THE INSTALLATION
INSTRUCTIONS! THE GUARANTEE IS NOT
APPLICABLE IF FAULTS ARE CAUSED BY
INCORRECT USE OF THE APPLIANCE.
Quick reference guide
GB
-2-
First time use
1- salt reservoir
2- rinse aid dispenser
3- detergent dispenser
4- racks system
5,6,7,8- available functions on the panel
9- filters
10- spray arms
In order to always ensure the best cleaning
results, you NEED to set:
DETERGENT type and WATER HARDNESS.
1.
Select 3rd programme
(see Table of programmes
- page 1)
2.
Press START button
for 7 seconds
3a.
Check your
detergent type...
3b.
...and set it on your dishwasher
using the START button
(as per table below)
4.
Remember to use salt and rinse
aid when needed (as indicated
below)
5.
Switch off and switch on
again to save setting
Detergent
types
Dishwasher models
model without
display
model with display
Powder or gel
(factory setting)
no symbol add rinse aidadd salt
Tablet 2 in 1
add salt
Tablet 3 in 1
Tablet All in 1
For models without “detergent type” option, the salt and rinse aid indicators will be lit when tablets are used.
3h 6h 9h
rinse aid
salt
rinse aid
1.
Ask your water supply company what
the
water hardness
is...
2.
...enter this value on your dishwasher
Suggestions for detergent use
English
degrees °eH
Water
hardness
Dishwasher with
display: insert value
in the display
Dishwasher without
display: count
START button led
flashes
Gel or Powder
(rinse aid and salt)
Tablets
0 - 6.3 Soft 1 1x
go to step 1
(see “Daily check”)
if extra salt is
needed go to step 1
(see “Daily check”)
7 - 12.6 Medium 2 2x
13.3 - 18.9 Average 3 3x
19.6 - 25.9 Medium-hard 4 4x
26.6 - 35 Hard 5 5x
35.7 - 44.1 Very hard 6 6x
44.8 - 74.9 Extremely hard 7 7x
How to set water hardness
*
only
before the first wash
or if the
water hardness has been changed
Switch on the appliance
- Select the 2nd programme “P2” - consult the table of programmes.
- Press the START button for at least 5 seconds until the START indicator lamp flashes.
- The water hardness setting is shown on the display (if present) or the START button flashes.
- With each successive touch of the START button the setting increases and when it reaches 7 it returns to 1 again.
- The appliance must be switched off to memorise the new setting.
Even if you use tablets which include salt,
you must still add salt since such
detergents are not effective enough at
softening hard water.
Water hardness level is factory set for
medium hard water (a number “4” is
shown on the display or the START
indicator lamp flashes 4 times).
How to set detergent type: powder/gel/tablet (if option is available)

Produkt Specifikationer

Mærke: Prima
Kategori: Opvaskemaskiner
Model: LPR601

Har du brug for hjælp?

Hvis du har brug for hjælp til Prima LPR601 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Opvaskemaskiner Prima Manualer

Prima

Prima LPR661 Manual

25 Februar 2025
Prima

Prima LPR601 Manual

25 Februar 2025

Opvaskemaskiner Manualer

Nyeste Opvaskemaskiner Manualer

Bosch

Bosch SKE52M75EU Manual

15 Januar 2025
Candy

Candy CDP 6853X/K Manual

15 Januar 2025
AEG

AEG F56529UM0 Manual

15 Januar 2025
Siemens

Siemens SN536S03ME Manual

15 Januar 2025
Miele

Miele G 5500 SCi Manual

15 Januar 2025
Amica

Amica ADF410WH Manual

15 Januar 2025
Hoover

Hoover DDY 65543FAM-S Manual

15 Januar 2025
Hotpoint Ariston

Hotpoint Ariston HFO 3O32 W C X Manual

15 Januar 2025
Bauknecht

Bauknecht GSIP 6198 AL Manual

15 Januar 2025
Zanussi

Zanussi ZDN11001WA Manual

15 Januar 2025