WARNING!:
Never operate doors openthis themachine while are . Serious injury may
happen .
4
MEAT SAW
Before completing electrical connection, verify direction movement saw (6). pressed,the the of of bandthe When the on button is
the from top to the If the from to top, theband saw must moves bottom in sliding side . 5 .bar (Fig A) band saw moves bottom push
stop . Interchange 2 3 coming supply . 5 .button and unplug equipmentthe of in power wires (Fig B)
Reconnect saw supply, verify direction movement .the meat to the power turn it on and the of again If the good operation is
confirmed, connection supply. you have question connectionthen fix the to the power If any regarding to the of equipment,the
contact your authorized . above procedure saws phase connection.to dealer The only applies to meat with three
IV. OPERATION-
Do not use the equipment if it is not properly grounded.
Important: for the first time usage you must cut a couple of pounds of scrap clean product to clean the blade (6) of any dirt or
foreign debris.
Normal operation of the saw:
1.- Select the desired thickness to cut, using the gauge plate assy (11).
2.- Put the product on the carriage (8)
3.-Turn on the machine (do not leave machine unattended while in operation).
Your saw is equipped with a thermo magnetic triple phase switch box, ( which is the same for single phase ) press the green button
to start and the red button to turn off the power.
4. e gauge - Placing the product against the gauge plate ( 11) you can start to cut, it is recommended to work front face to th
plate, once again, never put your hands or fingers close to the blade, serious personal injury may happen.
5.- You may start to cut the product.
Fig. 5A Fig. 5B
CAUTION!:
Unplug or disconnect the machine from the power supply before changing wires.
CAUTION!:
Turn off and disconnect the equipment when is not in use
KS-116
