Item No. 216230 - Charging Block with USB-A Host
Supports 8.3", 8.4" and 10.1" Sizes
Part Number Series 7xx266 and 7xx267
Self-installation instructions and advice are provided for your
convenience. It is your responsibility to determine if you have the
knowledge, skills, and physical ability required to properly perform an
installation. ProClip USA, LLC. shall have no liability for damage or
injury resulting from the installation or use of any ProClip or third
party products. It is your responsibility to ensure that all products are
installed in adherence with local laws and regulations and in such a
manner as to allow a vehicle to be operated safely and without
distraction. ProClip USA, LLC. product warranties do not cover the
installation, removal or re-installation of any product.
Attention: Carefully read all instructions and review the images before installing this product.
1. Remove Existing Block:
This block is designed to be used as a replacement or upgrade for the ProClip
Use the included Allen wrench to loosen the 4 thread forming screws attached
to the back of the cradle. Once loose, slide the block down and away from the
This cradle includes retention clips to ensure the power and USB-A cables
cannot be accidentally removed.
Plug in the cable, and then place the retention clip with brass inserts over the
top of the cable. Use the included fasteners to secure the clip.
The included zip ties can be used with the included holes in the steel base
plate to manage cables and keep them secure.
2. Attach Charging Block:
Using the included screws, attach the charging block with the same 4 holes and the
included Allen wrench. This should be done to hand tight and not with a power tool.
It is recommended that you use the included new thread forming screws to attach this
block and not the old screws that were removed to ensure that the fastener is strong
This charging lock block one of several modular components of this cradle that allow
for easy upgrade or repair in the event a cradle is damaged. It includes the cable
retention clips and fasteners needed to make this a fully capable charging cradle with
