Pryme SPM-600-M8-AMP Manual

Pryme Radio SPM-600-M8-AMP

Læs gratis den danske manual til Pryme SPM-600-M8-AMP (2 sider) i kategorien Radio. Denne vejledning er vurderet som hjælpsom af 5 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 3 anmeldelser. Har du et spørgsmål om Pryme SPM-600-M8-AMP, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

911 Mariner St., Brea, CA 92821

PH: 714.257.0300 FAX: 714.257.0600

TOLL FREE: 800.666.2654

WWW.PRYME.COM

SPM-600-AMP “Synergy” / SPM-2100-AMP “Trooper”

Ampliﬁed Speaker Microphones

Wired, ampliﬁed remote speaker microphones for use with 2-way radios

PRYME® is a trademark owned by PRYME Radio Products, Brea, CA.

All other product or service names are the property of their respective owners.

Applies to: All SPM-600-AMP

and SPM-2100-AMP models

Made in Taiwan

* Typical battery life,

based on 5/5/90 cycle

SUPPORT AND WARRANTY

PRYME Radio Products warrants this product against defects in materials or

workmanship for a period of one year from the date of retail purchase. PRYME will

repair or replace a defective unit, at our option, without charge for parts or labor.

The limited warranty is extended only to the original purchaser and is valid only to

consumers in the United States and Canada. It does not cover damage or failure

caused by or attributable to Acts of God, abuse, misuse, improper or abnormal

usage, faulty installation, improper maintenance, lightning, or other incidences of

excessive voltage, or any tampering or repairs by other than a PRYME authorized

repair facility. It does not cover replacement of consumable parts, transportation

costs, or damage in transit.

Repair or replacement under the terms of this warranty does not extend the terms

of this warranty. This warranty can only be modiﬁed by an oﬃcer of PRYME Radio

Products, and then only in writing. Should this product prove defective in workman-

ship or material, the consumer’s sole remedies shall be such repair or replacement as

provided by the terms of this warranty. Under no circumstances shall PRYME Radio

Products be liable for any loss or damage, direct, consequential, or incidental, arising

out of the use of or inability to use this product. Some states do not allow limitations

on how long an implied warranty lasts or the exclusions or limitations of incidental or

consequential damages, so the above limitations or exclusions may not apply to you.

This warranty gives you speciﬁc legal rights. You may also have other rights, which

may vary, from state to state.

For support or warranty service on your PRYME product, contact us at

1-800-666-2654 or visit us on the web at www.PRYME.com.

owned by PRYME Radio Products. All other product or service names are the property

of their respective owners.

version 2.0 MARCH 2021

26 Hours* 15 Hours*

2 3

Controls and Connections

Charging the Speaker Microphone

The ampliﬁed speaker microphone has an internal Lithium Ion rechargeable battery pack which must

be charged prior to operation and which must be recharged regularly.

A fully charged battery will provide up to 15 hours (for the SPM-600-AMP) or 26 hours (for the

SPM-2100-AMP) of continuous operation before needing to be recharged. However, operating time can

vary depending on how you use the microphone and on the condition of the battery pack. Please

recharge the battery regularly.

To charge the speaker microphone:

1. Ensure the radio is turned oﬀ or disconnected from the speaker mic.

2. Plug the charge cable into any powered USB outlet, such as an AC wall charger, and then into the

earphone/charge jack on the speaker microphone. You will need to remove the protective rubber cover

that is inserted into the charge jack. (To prevent dust and moisture from damaging your speaker

microphone, always ensure this cover is in place when you are not charging or using an earphone.)

3. Once the charging process has begun, the LED indicator on the speaker microphone will show a

constant red light.

4. Typical charge time is approximately ﬁve (for the SPM-600-AMP) or eight (for the SPM-2100-AMP)

hours. Actual charge time will vary depending on several factors including the battery’s

charge state, condition, and age.

5. When the battery is fully charged the red LED indicator on the

speaker microphone will go oﬀ. This indicates that charging is complete.

6. Disconnect the charger from the adapter when charging is completed.

Charging Cautions

- Do not use a wall charger or charge cable that appears to be

damaged. (Example: frayed wires, melted plastic, etc.) Contact

PRYME to get a new manufacturer-approved replacement charger.

- Do not tamper with or modify the speaker microphone or charger.

- Always turn the radio oﬀ or disconnect the speaker

microphone when charging.

Using the Speaker Microphone

To use the speaker microphone once it has been charged, simply connect it to your two-way radio and

power the radio on. The LED on the microphone will show a constant green during normal operation.

Received calls will be heard through the front-ﬁring speaker. You can adjust the volume using the

volume control on the radio. NOTE: that it may be necessary to set the volume on the radio to less than

100%. On some radios, turning the volume up too high could result in distorted sounding audio.

To make a call, press and hold the PTT button on the microphone. Voice audio will be picked up by the

internal microphone.

Earphone Jack / Charge Jack

This jack is used to connect an

(optional) wired listen-only

earphone to the speaker

microphone for enhanced

privacy. It is also used to

connect the supplied charger

and cable to the microphone

to recharge the internal

battery of the speaker

microphone.

Status LED

The red and green LED lets the

user know the current status of

the speaker microphone.

Replaceable Cable

(SPM-2100-AMP only)

The cable connects to

the microphone using

an RJ45 connector. This

allows the cable to be

quickly and easily

removed and replaced if

needed.

Front Firing Speaker

Received calls are heard over this speaker.

The volume level can be controlled using

either the Volume Up / Down buttons on the

speaker microphone, or by using the volume

controls on the two-way radio or phone.

Front Firing Speaker

Microphone

This microphone picks

up the user’s voice audio

when sending a call.

Microphone

PTT Button

This button is used to activate

the push-to-talk feature of the

two-way radio.

PTT Button

Clothing Clip

The alligator-type clip

secures the speaker

microphone to the user’s

clothing during use. The clip

can be rotated to allow the

microphone to be better

positioned.

Produkt Specifikationer

Mærke:	Pryme
Kategori:	Radio
Model:	SPM-600-M8-AMP

Har du brug for hjælp?

Hvis du har brug for hjælp til Pryme SPM-600-M8-AMP stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Radio Pryme Manualer

Pryme SPM-600-M8-AMP Manual

12 August 2025

Pryme SPM-1301 Manual

4 Juni 2025

Pryme SPM-303eB Manual

3 Juni 2025

Radio Manualer

Nyeste Radio Manualer

Eton Field Radio 550 Manual

13 August 2025

Eton Scorpion Rugged Manual

13 August 2025

Camry CR 1910 Manual

12 August 2025

Eton Mini NGWMINIB Manual

12 August 2025

Adler AD 1917 Manual

12 August 2025

Trevi DAB 791 R Manual

9 August 2025

Madison FREESOUND-VR30 Manual

9 August 2025

Trevi CMP 588 DAB Manual

8 August 2025

Trevi DAB 7F92 R Manual

8 August 2025

Trevi DAB 7F91 R Manual

8 August 2025