PS Engineering PAC24 Manual

PS Engineering Samtaleanlæg PAC24

Læs gratis den danske manual til PS Engineering PAC24 (38 sider) i kategorien Samtaleanlæg. Denne vejledning er vurderet som hjælpsom af 2 personer og har en gennemsnitlig bedømmelse på 3.7 stjerner ud af 1.5 anmeldelser. Har du et spørgsmål om PS Engineering PAC24, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/38

9800 Martel Road

Lenoir City, TN 37772

www.ps-engineering.com

PAC24

Audio Control Panel and Intercom System

Document P/N 200-240-0010

Revision 13, September 2007

PS Engineering, Inc. 2007 ©

Any reproduction or retransmittal of this publication, or any portion thereof, without the expressed written permission of PS En-

gineering, Inc. is strictly prohibited. For further information contact the Publications Manager at PS Engineering, Inc., 9800 Mar-

tel Road, Lenoir City, TN 37772. Phone (865) 988-9800, email info@ps-engineering.com.

In certified aircraft, warranty is not valid unless this product is installed by an

Authorized PS Engineering dealer.

Table of Contents

SECTION I GENERAL INFORMATION .......................................................................................1-1

1.1 INTRODUCTION..........................................................................................................................1-1

1.2 SCOPE ............................................................................................................................................1-1

1.3 EQUIPMENT DESCRIPTION ....................................................................................................1-1

1.4 APPROVAL BASIS -.....................................................................................................................1-2

1.5 SPECIFICATIONS........................................................................................................................1-2

1.6 EQUIPMENT SUPPLIED ............................................................................................................1-3

1.7 EQUIPMENT REQUIRED BUT NOT SUPPLIED...................................................................1-4

1.8 LICENSE REQUIREMENTS ......................................................................................................1-4

SECTION II - INSTALLATION .......................................................................................................2-1

2.1 GENERAL INFORMATION .......................................................................................................2-1

2.1.1 SCOPE..........................................................................................................................................2-1

2.2 U

NPACKING AND PRELIMINARY INSPECTION.................................................................................2-1

2.3 E

QUIPMENT INSTALLATION PROCEDURES.....................................................................................2-1

2.3.1 C

OOLING REQUIREMENTS..............................................................................................................2-1

2.3.2 I

NTERNAL DIP SWITCH CONFIGURATION ......................................................................................2-1

2.3.3 M

OUNTING REQUIREMENTS...........................................................................................................2-7

2.3.4 M

OUNTING RACK INSTALLATION ..................................................................................................2-7

2.3.5 T

RAY AND CONNECTOR ASSEMBLY ..............................................................................................2-7

2.4 C

ABLE HARNESS WIRING ...............................................................................................................2-7

2.4.1 N

OISE ............................................................................................................................................2-7

2.4.2 E

XISTING KMA 24H INSTALLATION.............................................................................................2-8

2.4.3 P

OWER...........................................................................................................................................2-8

2.4.4 C

OMMUNICATIONS PUSH-TO-TALK (SINGLE PANEL INSTALLATION)..............................................2-8

2.4.5 A

UDIO PANEL INTERFACE..............................................................................................................2-8

2.4.6 T

RANSMIT INTERLOCK...................................................................................................................2-9

2.4.7 "S

WAP" MODE...............................................................................................................................2-9

2.4.8 B

ACKLIGHTING..............................................................................................................................2-9

2.4.9 U

NSWITCHED INPUTS.....................................................................................................................2-9

2.4.10 PA M

UTE (J3, PIN 8)...................................................................................................................2-9

2.4.11 P

UBLIC ADDRESS (J3, PIN B) ......................................................................................................2-9

2.4.12 I

NTERCOM WIRING.......................................................................................................................2-9

2.4.13 E

NTERTAINMENT INPUT (J3 PIN 7) ............................................................................................2-10

2.4.14 I

NTERCOM EXPANSION (J3, PINS 22, 23 AND A) ........................................................................2-10

2.4.15 P

LAYBACK BUTTON INSTALLATION (PIN 2- OPTION 1 UNITS ONLY)..........................................2-10

2.5 A

DJUSTMENTS ...............................................................................................................................2-11

2.6 C

OMMUNICATIONS ANTENNA INSTALLATION NOTES .................................................................2-11

2.7 W

IRELESS TELECOMMUNICATIONS INTERFACE ..........................................................................2-11

2.8 PAC24 P

IN ASSIGNMENTS.............................................................................................................2-13

2.9 P

OST INSTALLATION CHECKOUT..................................................................................................2-14

2.10 U

NIT INSTALLATION ...................................................................................................................2-14

2.10.1 O

PERATIONAL CHECKOUT.........................................................................................................2-14

2.11 I

NTERNAL RECORDER CHECKOUT (OPTIONAL UNITS ONLY)....................................................2-15

2.12 F

INAL INSPECTION ......................................................................................................................2-15

SECTION III OPERATION ..............................................................................................................3-1

3.1 SCOPE ............................................................................................................................................3-1

3.2 PAC24 C

ONTROLS..........................................................................................................................3-1

3.3 P

OWER SWITCH (3) (EMG-FAIL SAFE OPERATION).....................................................................3-1

3.3.1 S

INGLE PANEL FAIL SAFE OPERATION...........................................................................................3-1

3.3.2 D

UAL PANEL FAIL SAFE OPERATION.............................................................................................3-1

3.4 M

ICROPHONE SELECTOR (2) ..........................................................................................................3-2

3.4.1 T

ELEPHONE OPERATION ................................................................................................................3-2