Pyle AZPUCWM22 Manual

Pyle Støvsuger AZPUCWM22

Læs gratis den danske manual til Pyle AZPUCWM22 (2 sider) i kategorien Støvsuger. Denne vejledning er vurderet som hjælpsom af 13 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 7 anmeldelser. Har du et spørgsmål om Pyle AZPUCWM22, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

If the spin dryer does not work, check if:

• The inner lid and outer spin bowl lids are closed.

• The spin dry timer is set.

If there is excessive noise, check if:

• Something is touching the pulsator as it rotates.

• The machine is not placed on a level surface.

• The wash load does not exceed more than the machine

can handle to ensure balance during the spin cycle.

• Something is stuck between the spin bowl and tub.

Wash Day Maintenance

At the end of the day:

• Unplug the power cord from the outlet.

• Check that both timers are set to the OFF position "O"

• Wipe the inside and outside of the unit with damp clean cloth.

• Remove the hose from the water tap.

TWIN TUB WASHING MACHINE

Please read the manual carefully before using the machine

CLEANING AFTER USE

• Always clean the washing machine after every use. Ensure the power switch is

turned off and disconnected from the electrical outlet before performing this action.

POINTS TO REMEMBER

• Avoid using excessive amounts of bleach or detergent; use the amount of soap

recommended by the manufacturer.

• For your safety, ensure that the ground connection is correct.

• Never put your hands into the spin tub while operating.

• When washing, the water temperature should be below 120°F. This is to prevent

the plastic components from being deformed.

• Do not place the washing machine close to heat generating products such as gas

or electric cookers.

• Use soft cloth when cleaning the washing machine to prevent damages on the

surface of the cabinet.

• Do not place wet load on the control panel.

• Do not place washing machine outside or in a damp area.

BEFORE YOU CALL FOR SERVICE

• If you suspect the washing machine requires maintenance, follow these instructions

to save unnecessary costs before calling the manufacturer or a technician.

• If the washing machine will not start, check if:

o The hose circuit breaker is tripped or a fuse is blown.

o The cord is firmly connected to the power point or the power is not switched “ON”.

o Something is stuck and is preventing the pulsator from rotating.

o The wash timer is set.

TABLE OF CONTENTS

Contents Page

Parts Identification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

Chief Technical Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2

Operation Instruction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-4

Laundry Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Cleaning After Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

Point To Remember . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

Before You Call For Service . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

Maintenance After Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

INSTRUCTION MANUAL

PUCWM22

WARNING

• When connecting the appliance to the water main, use a new hose,

do not use an old hose.

• For washing machines with ventilation openings at the base, ensure that nothing

is obstructing the openings.

• If the power cord is damaged, it must be replaced by the manufacturer/distributor

or a certified technician.

• This appliance is not intended to be used by persons (including children) with

reduced physical, sensory or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision or instruction concerning

use of the appliance by a person responsible for their safety.

• Do leave children unattended and play near the appliance.

To Rinse In The Wash Tub

• Set the selector knob to “WASH” mode.

• Turn the water tap on.

• When the rinse water became clear, turn off the water tap.

• Set the selector switch “DRAIN” position to discharge the water.

Spin Drying

• To open the inner safety lid of the spin tub, lift up the outer spin cover and then

lift up the safety lid.

• Transfer the wash load to the spin tub commencing with small articles.

Ensure that the clothes are evenly distributed.

• Place the removable spin mat over the load to be dried and push lightly downward.

(To contain delicate articles within the tub.)

• Set the spin timer to the time recommended in the Laundry Guide.

The spin tub will spin for the time selected and then stop on (at the position “O”).

Caution:

Ensure that the spin tub completely stops before reaching in to the wash load.

Do not leave children unattended during this process.

• To remove or reposition clothes during the spin dry cycle, open the spin cover and

inner lids. In this case, the spin tub will automatically stop as a brake is activated

when the spin cover is opened. To restart, close both lids. If required,

reset the spin timer.

• Turn off the spin drying and rearrange the clothes inside the tub if abnormal

vibration is observed during spin drying.

INSTALLATION

Electrical Connection

• The unit is designed to function under the recommended power settings mentioned

in the rating label at the back of the washing machine.

• The power cord must be plugged into a grounded 3-pin outlet.

• If the power cord is damaged, it should be replaced by the manufacturer/distributor

or a certified technician.

Connection of Water Inlet Hose

• Attach the water inlet hose to the water inlet (Please refer to the Parts Identification

on page 1). Caution: Please use water BELOW 120°F.

• The drain hose should be placed so that the water can drain down without any

obstruction.

OPERATION INSTRUCTION

Preparing the Wash

• The machine should be placed on a flat surface.

• Separate the laundry into different groups like: white clothes, color clothes, delicate

clothes, lint-free and etc. Wash the laundry according to the washing guide.

• Clothes with worn patches or tears should be mended first. Empty all pockets and

close all fasteners.

Prior to Wash

• Remove the plastic spin mat from the spin tub.

• Check if wash timer knob is set to position “0” and the selector switch is set to “Wash”.

• Ensure that drain hose is placed properly to allow draining.

• Insert the power cord into a grounded 3-pin outlet.

To Wash

• Place the wash load and detergent in the wash tub.

• Set the selector switch to “Wash” mode.

• Fill the washing machine with water as recommended in the “Laundry Guide.”

• Set the wash timer to the wash period recommended in the laundry guide.

Your machine will now wash for the time selected. When the wash period expires,

set the selector switch to “Drain” position to discharge the water.

Simultaneous Washing and Spin Drying

• The machine has two motors designed for washing and spin drying that allows the

user to load, wash and spin dry all at the same time.

• Set the controls for both “wash” and “spin” modes (see “To Wash” and Spin Drying”).

CLEARING THE TUB

• First, set the selector knob to “DRAIN” mode.

• Wait until the machine empties completely.

• Then, set the selector knob to “WASH” mode.

• Lastly, unplug the power cord from the outlet.

PARTS IDENTIFICATION

1. CONTROL PANEL

2. WATER INLET

3. PULSATOR

4. WASH TUB LID

5. HOUSING

6. SPIN TUB LID

7. SPIN TUB

8. POWER CORD

9. PLASTIC SPIN MAT

10.DRAIN HOSE

LAUNDRY GUIDE

Type of

Fabric

Size of

Wash

Load

Water Level

(Volume)

Degree of

Soiling

Water

Temperature

Wash Cycle

Wash

Period

Spin

Period

Colored

Cotton and

Linens

Full

Half &

Less

High

Low

Heavy

Normal

Light

Below 104°F 5-10 mins. 3-5 mins

Nylon and

P.P

Delicates

Below 104°F

Full

Half &

Less

Half &

Less

High

Low

High

Normal

Light

Normal

to Light

4-5 mins.

2-3 mins.

2 mins.

1-2 mins.

CHIEF TECHNICAL DATA

Model

Rated Wash

Capacity

Rated Input

Power

Rated Power

Source

Energy Efficiency

Grade: 5

Wash Cleaning Rate 0.7

Packaging

Dimension

Net/Gross

Weight

Input Water

Pressure

Area

MPA

LengthxWidthxDepth

Consume

Water

(L/Cycle/KG)

Consume

Electricity

(KWh/Cycle/KG)

FrequencyVoltageSpinWashWash Spin

PUCWM22 3.5KG 1.5KG 250W 120W 110V 60 Hz 0.032 36 590x390x675(MM) 11/13KG 0.05~0.3

Produkt Specifikationer

Mærke:	Pyle
Kategori:	Støvsuger
Model:	AZPUCWM22

Har du brug for hjælp?

Hvis du har brug for hjælp til Pyle AZPUCWM22 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Støvsuger Pyle Manualer

Pyle PSTMIR14 Manual

6 December 2024

Pyle PUCVCBAT48 Manual

30 Juli 2024

Pyle AZPUCWM22 Manual

27 Juli 2024

Pyle AZPSTMIR14 Manual

2 Maj 2024

Pyle AZPUCWM11 Manual

11 April 2024

Pyle AZPSTMIR17 Manual

19 Oktober 2023

Støvsuger Manualer

Nyeste Støvsuger Manualer

Lavor Hydrus Manual

30 Juli 2025

ECOVACS DEEBOT X8 OMNI Manual

30 Juli 2025

Eibenstock EPS 50 Manual

30 Juli 2025

Eibenstock ESS 35MP Manual

30 Juli 2025

Holzmann SSAT2200_230V Manual

30 Juli 2025

Scheppach VC20 Manual

30 Juli 2025

Lavor Windy IE Foam Manual

29 Juli 2025

Lavor Zeus IF Manual

29 Juli 2025

Scheppach HD2P Manual

29 Juli 2025

AEG Clean 5000 AL51C1LDB Manual

29 Juli 2025