Queenaire QT Cyclone QTC1250 Manual

Queenaire Luftrenser QT Cyclone QTC1250

Læs gratis den danske manual til Queenaire QT Cyclone QTC1250 (2 sider) i kategorien Luftrenser. Denne vejledning er vurderet som hjælpsom af 69 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 35 anmeldelser. Har du et spørgsmål om Queenaire QT Cyclone QTC1250, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

QUEENAIRE TECHNOLOGIES, INC.

“The Ozone Specialists”

Queenaire Technologies, Inc.

P.O. Box 133

Ashburn, VA 20146

Toll Free: 1-877-64 OZONE

Tel: 1-703-654-0385 Fax: 1-703-654-0386

Volume

Owners Manual

QT Cyclone

Troubleshooting Guide

If you are having problems with your ozone machine please refer to the following instructions:

1. The fan comes on, but the green light does not. Remove the top

cabinet from the unit and check the condition of the ceramic plate.

Replace if broken. Replace top cabinet. Remove and replace the .200

milliamp fuse in the back of the unit. If the green indicator light is still

out contact Queenaire Technologies Customer Service at 1-877-64

OZONE.

2. When you turn the unit on nothing happens. First check your power

source to ensure there is power to the outlet. Plug the unit in. Check

the fuse marked 2 amp on the back of the unit. Replace if blown. If

the unit still does not operate contact Queenaire Technologies Customer Service department at the

number above.

3. If for any reason you are not happy with the performance of this unit contact customer service at

1-877-64 OZONE.

Operating QT Cyclone

Following are basic guidelines for eliminating odors continuously in rooms up to 10,000 cubic feet.

his unit is designed to be used either continuously in areas that have ongoing odor problems

or as a maintenance tool to quickly eliminate odors on a portable basis in areas up to 60,000

cubic feet. You can maximize the results if you expose fabrics fully, open interior doors and

turn on your air handling system. Keep in mind that ozone is a surface agent and must make

contact with the source of the odors to insure complete deodorization. While this unit is designed to

run continuously it should be monitored to insure that ozone levels do not exceed OSHA safety levels

of .04 ppm. Following is a formula and chart to help you determine the best setting for your ozone

unit when dealing with specic odors. This is a general guideline only as the output will vary substan-

tially depending on the odor factor, temperature and humidity.

AREA x ODOR FACTOR = MG/HR REGUIRED

1. Measure the Cubic Footage (L x W x H) of the room to be treated = A (area)

2. Estimate the Odor Factor (B) as follows:

* Light Odors = 0.005

* Medium Odors = 0.018

* Strong Odors = 0.036

3. Multiply A x B to determine MG/HR needed to eliminate the odor.

4. Use the chart to the Right to determine the setting for your unit.

5. Adjust the settings as needed for complete odor control.

Example: A room 50' x 50' x 8' = 20,000 cu/ft x .018 Medium Odor = 360 mg/hr. Set ozone

knob to 4. While smell is not an accurate guide to ozone levels, in levels above .03 ppm ozone

has a very strong unpleasant odor. If you are experiencing a strong odor, headache, dry nose

and/or dry throat, you should either turn the unit down or o to allow the levels to dissipate.

Now that you have determined the approximate MG/HR necessary to eliminate the odor, operating

instructions are as follows:

1. Turn ozone-setting knob to appropriate setting.

2. Set the timer as follows: 1 = 15 min., 2 = 30 min., 3 = 45 min., 4 = 1.5 hr., 5 = 3.5 hr., 6 =

continuous.

3. Plug the unit into a standard outlet.

4. Place the unit on a table or counter o the ground. Ozone is heavier than air, so the higher the better.

5. Turn the unit on.

6. Be sure to monitor the unit and adjust ozone setting as required for complete odor control.

7. Perform maintenance on your QT Cyclone on a monthly basis. Maintenance instructions can be

found on the last page of this manual.

How Does QT Cyclone Eliminate Odors?

All Queenaire Technologies, Inc. units eliminate odors by producing a controlled level of ozone.

Ozone is created naturally in our environment by lightning and the suns ultraviolet rays. It is best

known for its benet in the stratosphere for protecting us from the suns rays. What you may not

know is that it is also that fresh smell you experience after a lightning storm. Ozone is Mother

Nature’s solution to outdoor odor problems. QT Cyclone incorporates a technology that duplicates

the eect of lightning and creates ozone indoors. The end result is the same, a fresh, odor free

environment.

QT Cyclone Maintenance Instructions

The life expectancy of your QT Cyclone unit is 10 - 15 years, provided it is serviced and main-

tained on a regular basis. It is recommended that you perform a simple cleaning and maintenance

of your unit every six months. The lter should be changed monthly. High contaminate areas such

as smoking and garbage rooms may require monthly cleaning. Maintenance kits are available

through your distributor.

Before you begin performing any work to your ozone unit, be sure to unplug the electrical cord.

Step 1.) Remove two screws on the top of the unit as well as the top two screws on each side of the

unit. Remove the top cover from the unit.

Step 2.) Carefully remove the white ceramic generator plates from their frame. The plates should

lift easily by pulling from the top straight up and out of the frame. Use an alcohol wipe to gently

wipe the plates free of any dirt or stains. Inspect the plates carefully for cracks, breaks or irremov-

able stains. The plates can be reused provided there are no breaks or stains.

Step 3.) Use the same alcohol wipe to wipe out the exposed areas inside the unit. Spread the

generator frames apart to wipe the inside of the metal plates that make contact with the generator

plate. Be sure to also wipe the base of the frames completely.

Step 4.) Once the ceramic plates are completely dry, reinsert the plates into the generator frames or

replace the existing plates.

Step 5.) Reattach the top cover to the unit and put screws back in place.

Step 6.) Remove and discard the green lter on the back of the machine and replace with new

filter.

Step 7.) You may at this point have to change your 200mA fuse. To test your fuse, simply turn the

unit on. If the green ozone light comes on you have completed maintenance of the unit and are

ready to put it back in service. If the light does not come on, locate the 200mA fuse holder on the

back of the unit and remove the holder with a at head screwdriver by turning the holder 1/4 turn.

Remove the blown fuse and replace with the fuse enclosed in your maintenance kit. Your unit

should now be ready to go back to work.

Ozone

Setting

MG/HR

80 mg/hr

161 mg/hr

220 mg/hr

390 mg/hr

560 mg/hr

625 mg/hr

740 mg/hr

860 mg/hr

980 mg/hr

1200 mg/hr

Produkt Specifikationer

Mærke:	Queenaire
Kategori:	Luftrenser
Model:	QT Cyclone QTC1250

Har du brug for hjælp?

Hvis du har brug for hjælp til Queenaire QT Cyclone QTC1250 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Luftrenser Queenaire Manualer

Queenaire QT Tornado QTT625 Manual

12 August 2024

Queenaire QT Cyclone QTC1250 Manual

9 August 2024

Queenaire QT Thunder-24 QTT24-II Manual

6 August 2024

Queenaire QT Storm QTSV Manual

6 August 2024

Queenaire QT Thunder QTT3F Manual

5 August 2024

Luftrenser Manualer

Nyeste Luftrenser Manualer

Teesa Pure Life 50 TSA8064 Manual

9 Oktober 2025

Gorenje AP500 Manual

8 Oktober 2025

Febreze FHT190W Manual

8 Oktober 2025

Febreze FHT180W Manual

7 Oktober 2025

LG PuriCare AeroTower U10CS1H Manual

5 Oktober 2025

4 Oktober 2025

4 Oktober 2025

3 Oktober 2025

3 Oktober 2025

3 Oktober 2025