Rain Bird CPHVVBSPFF Manual

Rain Bird Ikke kategoriseret CPHVVBSPFF

Læs gratis den danske manual til Rain Bird CPHVVBSPFF (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 25 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 13 anmeldelser. Har du et spørgsmål om Rain Bird CPHVVBSPFF, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

INSTALLATION INSTRUCTIONS

HIGH VALUE IN-LINE VALVE CPHVVBSPMMCPHVVBSPFF

Male x Male adapter

Female threaded union

Male x Slip adapter

O N

O FF

MANUAL

1/4 TURN

Solenoid PTFE thread-seal tape

Bleed screw

Inlet

Outlet

BASICRECOMMENDED

Flow Sprinklers

System

pipe

System pipe

PVC glue

O N

O FF

MANUAL

1/4 TURN

Solenoid

Bleed screw

Inlet Outlet

PTFE thread-seal tape

BASICRECOMMENDED

PVC glue

Flow Sprinklers

System

pipe System

pipe

B AC B C

CPHVVBSPFF 26 x 34 mm

CPHVVBSPMM 25 mm

ENENGLISH

WASTE ELECTRICAL AND

ELECTRONIC EQUIPMENT (WEEE)

This symbol means that end of life

electrical and electronic equipment

(WEEE) should not be mixed with general household

waste. For proper treatment, recovery and recycling,

please take this product to designated collection

points. Rain Bird has met its national obligations

to the EU WEEE Directive by registering in those

countries to which Rain Bird is an importer. Rain Bird

has also elected to join WEEE Compliance Schemes

in some countries to help manage customer returns

at end of life.

1 2 3

COMMON

TROUBLESHOOTING

Problem Leaks at the valve

Solution Check pipe ttings, solenoid, bleed screw, etc. Retighten or

replace as required.

Problem Leaks at sprinkler heads (valve doesn’t close)

Solution Possible cause 1: Debris.

Open the bleed screw. Flush one minute. Open the solenoid.

Flush ve minutes.

Possible cause 2: External leaks at the valve.

See above.

Problem Sprinklers do not turn on (valve doesn’t open)

Solution Possible cause 1: Damaged or disconnected wire.

Inspect and repair as required.

Possible cause 2: Damaged solenoid.

Replace solenoid. Kit # SRKCP/CPF.

Possible cause 3: Damaged diaphragm.

Remove bonnet (top) and replace diaphragm. Kit # DRK-JTV.

NOTE: During winter shutdown, drain the system to protect HV valves

from freezing.

WIRING

TECHNICAL SPECIFICATIONS

Flow 0.05–6.82 m3/h (0.8 –113 l/min)

Pressure 1.0 –10.3 bar (15–150 psi)

Electrical 24 VAC (50/60 Hz)

BEFORE INSTALLING VALVE

• Make sure you have sucient water supply, pressure,

and ow.

• Flush system until water runs clear.

• For best performance, install a pressure regulator if

water pressure exceeds 10.3 bar (150 psi).

• If water source has sediment, install a 100 mesh or ner

lter.

• Do not use with water exceeding 43.3° C (125° F).

Refer to local building codes for other plumbing and

electrical requirements.

INSTALLATION STEPS (Outdoor Use Only)

Connect Pipe and Adapters to Valve

TIP: Using pipe unions (B) on both the inlet and outlet side

of the valve as shown will greatly simplify installation and

allow retightening to correct for leaks. Unions will also permit

connections to be preassembled on a benchtop and enable

easier valve maintenance/replacement in the future.

1. Apply PTFE thread-seal tape to all male threads (A and C).

DO NOT USE pipe sealant paste which will damage your

system. Assemble in the order shown and tighten.

2. Tighten the union (B) collars and test t the entire

assembly in the valve box.

CAUTION

Make sure the valve arrows face correctly in direction

of ow.

3. When satised with t of all components, clean the ends

to be glued with primer and apply solvent glue.

Connect Valve Wires

TIP: Use watertight connectors (gel caps) and multi-strand

direct burial wire only.

4. Connect the common wire from the controller (typically

white) to one of the two wires from valve solenoid. It

does not matter which wire you use.

5. Attach the valve’s remaining wire lead to the strand color

for that zone.

Operate Valve Manually

To ush the valve, turn on water and open bleed screw for

one full minute (this will ush smaller debris).

Tighten bleed screw and test system. If valve does not

close fully, check solenoid and bleed screw for leaks.

8. If valve still does not close fully, remove bonnet, ush

and reinstall.

Made in Mexico

RAIN BIRD CORPORATION

6991 East Southpoint Road, Tucson, AZ 85756, USA

UK Authorised Representative

Comply Express Ltd , Unit C2, Coalport House, Staord Park 1,

Telford TF3 3BD, UK

Imported in EU by RAIN BIRD EUROPE

Bât A, Parc Clamar, 240 rue René Descartes - BP 40072 -

13792 Aix-en-Provence, CEDEX 3, France

www.rainbird.com

® Registered trademark of Rain Bird Corporation

Rev. 09/22

Produkt Specifikationer

Mærke:	Rain Bird
Kategori:	Ikke kategoriseret
Model:	CPHVVBSPFF

Har du brug for hjælp?

Hvis du har brug for hjælp til Rain Bird CPHVVBSPFF stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Rain Bird Manualer

Rain Bird 3500 Manual

29 September 2024

Rain Bird CPHVVBSPFF Manual

20 August 2024

Rain Bird 8005 Manual

8 August 2024

Rain Bird IQ-NCC-4G Manual

28 Februar 2024

Rain Bird ESC-1 Manual

2 December 2023

Rain Bird 500 Manual

11 Oktober 2023

Rain Bird UT1 Manual

5 Oktober 2023

Rain Bird 32SA Manual

6 Juni 2023

Rain Bird 550 Manual

20 Oktober 2022

Rain Bird RC2 Manual

14 Oktober 2022

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Metronic 451074 Manual

13 August 2025

Bravilor Bonamat Bolero 43 Manual

13 August 2025

Swann SRNVW-650H Manual

13 August 2025

Amica DHKI 752 880 C Manual

13 August 2025

Motorola APX 6500 Manual

13 August 2025

Pyle PMKS7 Manual

13 August 2025

Milwaukee M12 2445-20 Manual

13 August 2025

Motorola APX DUAL Manual

13 August 2025

Metronic 451042 Manual

13 August 2025

Metronic 370276 Manual

13 August 2025