Rane GM 16 Manual

Rane Mikrofon GM 16

Læs gratis den danske manual til Rane GM 16 (2 sider) i kategorien Mikrofon. Denne vejledning er vurderet som hjælpsom af 31 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 16 anmeldelser. Har du et spørgsmål om Rane GM 16, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

GM 16 Instructions

DESCRIPTION

Amplifying the acoustic sound of an

instrument over a sound system has been

difficult. Microphones feed back, and pickups

don't deliver a natural frequency response. By

mixing the two, the advantages of each come

through. The pickup supplies the gain and low

end, and the mic supplies the clarity and high

end to deliver the best combination of clear

sound and gain before feedback.

The Rane GM 16 is designed to be

mounted inside acoustic instruments such as a

guitar. It is a uni-directional condenser which

can be positioned for the best sound within the

instrument. It requires a special 6 volt 2-wire

phantom power supply to operate, supplied on

Rane's AP 13 Acoustic Preamplifier (for

which the GM 16 is intended to be used). A

second pair of leads are provided to connect to

an existing pickup. Output is derived from a

¼" TRS jack at the base of the gooseneck that

wires the pickup to the tip and the microphone

to the ring. This jack replaces the existing jack

or endpin on the instrument body. If a ¼" TRS

cable is used, both pickup and mic signals are

kept separate on a single stereo cable. If using

a mono ¼" cable, only the pickup is active.

INSTALLATION

1. Remove the strings. Enlarge the hole for the

GM 16 with a ½" tapered reamer if needed.

2. If the instument has a pickup, disconnect

the wires from the existing jack and solder

those leads to the loose set of wires

protruding from the middle of the GM 16.

Separate and cover the connections with

electrical tape.

3. Insert the microphone assembly through the

soundhole and tighten the strap button/

locknut from outside the instrument.

4. Replace the strings and tune the guitar. Set

the phantom power on the AP 13 to 6 volts.

Connect a quality ¼" TRS to TRS cable

from the instrument to the preamp. Set the

front panel switch to TIP=PZO/

RING=MIC. Consult the AP 13 owners

manual for further instructions.

MICROPHONE PLACEMENT

Position the microphone approximately

¼" beneath the soundboard near the treble side

of the soundhole, with the active black face of

the microphone towards the interior of the

instrument (approximately towards the chest

of the player). Rotating the active face of the

mic towards the back of the guitar often tends

to reduce excessive bass response.

Every instrument is different, and may

require a different mic position. You are

encouraged to experiment with positioning the

mic until the best combination of tone and

volume is produced. Like any microphone, the

GM 16 can feedback if not properly used.

Most pickups that sound 'midrangey' are

better with the 630 Hz slider pulled down in

the AP 13’s Piezo equalizer section. The mic

will be less boomy with it's Low Cut filter

raised. Experiment with combinations of mic

position and equalization for best results.

Produkt Specifikationer

Mærke:	Rane
Kategori:	Mikrofon
Model:	GM 16

Har du brug for hjælp?

Hvis du har brug for hjælp til Rane GM 16 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Mikrofon Rane Manualer

Rane GM 16 Manual

15 Juni 2025

Mikrofon Manualer

Nyeste Mikrofon Manualer

Trust Velica GXT 241 Manual

18 December 2025

SE Electronics V7 ENG Manual

15 December 2025

Eurosound PRO3 Manual

11 December 2025

Philips SmartMeeting PSE0540 Manual

8 December 2025

Galaxy Audio EVO-PE0P1 Manual

8 December 2025

Galaxy Audio EVO-PE0D4 Manual

8 December 2025

Philips SmartMeeting PSE0501 Manual

7 December 2025

Galaxy Audio AS-ANTM3 Manual

7 December 2025

Galaxy Audio EVO-PEED4 Manual

7 December 2025

TOA S4.10-RXA Manual

6 December 2025