Rheem 52S160 Manual

Rheem Kedler & kedler 52S160

Læs gratis den danske manual til Rheem 52S160 (44 sider) i kategorien Kedler & kedler. Denne vejledning er vurderet som hjælpsom af 38 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 19.5 anmeldelser. Har du et spørgsmål om Rheem 52S160, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/44
This water heater must be installed and serviced by a qualified person.
Please leave this guide with the householder.
Owner’s Guide
and
Installation Instructions
Solar Hiline Water Heater
WARNING: Plumber – Be Aware
Use copper pipe ONLY. Plastic pipe MUST NOT be used.
It is a requirement of a solar water heater installation that all pipe work be in copper
and not plastic, due to the effects of high water temperatures and pressures.
PATENTS
This water heater may be protected by one or more patents or registered designs in the name of
Rheem Australia Pty Ltd.
TRADE MARKS
®
Registered trademark of Rheem Australia Pty Ltd.
™ Trademark of Rheem Australia Pty Ltd.
Note: Every care has been taken to ensure accuracy in preparation of this publication.
No liability can be accepted for any consequences, which may arise as a result of its application.
WARNING: Plumber – Be Aware
The solar hot and solar cold pipe work between the solar Hiline storage tank and the solar
collector(s) are supplied in the pipe kit. The supplied copper solar hot and solar cold pipes MUST BE
used.
If the solar water heater is installed either on a metal roof or in a trafficable area, such as on an
accessible roof, then the solar hot and solar cold pipes must be insulated. The solar hot and solar
cold pipes may be required to be insulated to comply with local regulations.
If insulation is required, the full length of the solar hot and solar cold pipes MUST BE insulated.
The insulation must:
be of a closed cell type or equivalent, suitable for a solar water heating application and capable
of withstanding the temperature of the water generated by the solar collectors under stagnation
conditions
The specification of the chosen insulation material should be checked with the insulation
manufacturer prior to installation as different materials may vary in temperature tolerance.
be at least 13 mm thick, however thicker insulation may be required to comply with the
requirements of AS/NZS 3500.4
be weatherproof and UV resistant
be fitted up to and cover the connections on both the solar storage tank and the solar collectors.
The insulation will offer corrosion protection to a metal roof against water runoff over the copper
pipe, assist in avoiding accidental contact with the solar pipe work as high temperature water can
flow from the solar collectors to the solar storage tank and also reduce pipe heat losses.
Plastic pipe MUST NOT be used, as it will not withstand the temperature and pressure of the water
generated by the solar collector(s) under stagnation conditions. The solar collector(s) can generate
extremely high water temperatures up to 150°C and high water pressure of 1000 kPa. Plastic pipe
cannot withstand these temperatures and pressures and MUST NOT be used. Failure of plastic pipe
can lead to the release of high temperature water and cause severe water damage and flooding.
There must be a continuous fall of a minimum 10° in the pipe work from the solar Hiline storage
tank to the solar collector(s). The highest point of the solar cold pipe and solar hot pipe must be
where they connect to the solar Hiline storage tank, otherwise thermosiphoning will not occur.
A non return valve MUST BE installed on the cold water line to the solar storage tank AFTER the
cold water branch to a temperature limiting device.
The solar water heater, including the collector circuit and solar collectors, is to be isolated during the
testing and commissioning of the heated water reticulation system in a building, in accordance with
Clause 11.1 and 11.3 (a) of AS/NZS 3500.4.

Produkt Specifikationer

Mærke: Rheem
Kategori: Kedler & kedler
Model: 52S160

Har du brug for hjælp?

Hvis du har brug for hjælp til Rheem 52S160 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Kedler & kedler Rheem Manualer

Rheem

Rheem RTG-95XLN-3 Manual

8 Februar 2025
Rheem

Rheem RTG-84XLP-3 Manual

2 Januar 2025
Rheem

Rheem RTG-95DVLN-3 Manual

2 Januar 2025
Rheem

Rheem RTEX-08 Manual

2 Januar 2025
Rheem

Rheem RTG-84DVLN-3 Manual

2 Januar 2025
Rheem

Rheem RTG-95XELP-3 Manual

2 Januar 2025
Rheem

Rheem RTEX-18 Manual

2 Januar 2025
Rheem

Rheem RTGH-68DVLP-3 Manual

2 Januar 2025
Rheem

Rheem RTGH-95DVELP-3 Manual

2 Januar 2025
Rheem

Rheem Continuous Flow 874T26PF Manual

30 August 2024

Kedler & kedler Manualer

Nyeste Kedler & kedler Manualer

Daikin

Daikin EKHWSP180D3V3 Manual

9 April 2025
Daikin

Daikin SDGTB1209 Manual

9 April 2025
Daikin

Daikin SDGTB06 Manual

9 April 2025
SIME

SIME HOME PLUS Manual

1 April 2025
Corbero

Corbero CTEV350 Manual

10 Marts 2025
Corbero

Corbero CTM80 Manual

10 Marts 2025
Stiebel Eltron

Stiebel Eltron SHC 15 AU Manual

27 Februar 2025
Stiebel Eltron

Stiebel Eltron SNU 5 Plus Manual

27 Februar 2025
Stiebel Eltron

Stiebel Eltron DEM 6 Manual

27 Februar 2025
Stiebel Eltron

Stiebel Eltron DHCE 8/50 Manual

27 Februar 2025