2
TABLE OF CONTENTS
INTRODUCTION ........................................................... 3
Additional Technical Help, Support and Service ........ 3
Application, Export and Modifi cation ........................ 4
Meaning of Special Markings ..................................... 5
Safety Precautions (do not operate without reading) .. 5
Introduction to the 10C ............................................... 7
Contents and Technical Specifi cations ........................ 9
Accessories ............................................................... 10
Transmitter Controls &
Switch Identifi cation/Assignments ............................. 11
Charging the Ni-Cd Batteries ................................... 15
Stick Adjustments ..................................................... 16
Adjusting display contrast ........................................ 16
Changing mode .......................................................... 17
Power Down mode (TM10 module) .......................... 17
CAMPac initializing and data conversion (9C/9CS to 10C)
17
Radio Installation & Range Checking ...................... 18
Aircraft Frequencies ................................................. 22
Transmitter Displays and Buttons ............................. 23
Warning and Error Displays ..................................... 24
AIRPLANE (ACRO) FUNCTIONS ................................ 25
Map of Functions ........................................................ 26
Quick Guide to Setting up a 4-channel Airplane ...... 27
ACRO BASIC MENU FUNCTIONS ................................ 30
MODEL Submenu: MODEL SELECT, COPY, NAME .......... 30
PARAMETER Submenu: RESET, TYPE, MODUL, ATL, AILE-2,
CONTRAST, BACK-LIGHT, HOME-DISP, USER NAME, LOGIC SW
33
Servo REVERSE ........................................................... 38
END POINT .................................................................. 39
Idle Management: IDLE DOWN and THR-CUT .............. 40
Dual/Triple Rates and Exponential (D/R, EXP) .......... 42
TIMER Submenu .......................................................... 45
Auxiliary Channel assignments and CH9 reverse (AUX-CH)
. 46
TRAINER ..................................................................... 47
TRIM and SUB-TRIM ................................................... 48
SERVO Display ........................................................... 49
Fail Safe and Battery FailSafe (F/S) ......................... 50
ACRO ADVANCE MENU FUNCTIONS ........................... 51
Wing types ................................................................ 51
FLAPERON ................................................................... 52
FLAP TRIM .................................................................. 53
Aileron Differential (AILE-DIFF) ................................. 54
Using a 5-channel receiver: AILE-2 ............................ 55
ELEVON (see tail types) ............................................... 56
Tail types ................................................................... 56
ELEVON ....................................................................... 56
Twin Elevator Servos (AILEVATOR) ............................ 57
V-TAIL ......................................................................... 58
SNAP ROLL .................................................................. 59
Mixes: defi nitions and types ..................................... 61
ELEV-FLAP .................................................................... 62
AIRBRAKE/BUTTERFLY (crow) ..................................... 63
THROTTLE-NEEDLE ........................................................ 65
THROTTLE DELAY ......................................................... 66
THROTTLE CURVE ........................................................ 67
Linear, Prog. mixes 1-4 ............................................. 68
Curve, Prog. mixes 5-8 ............................................. 71
GYA gyro mixing (GYRO SENSE) ............................... 73
Other Equipment ....................................................... 74
GLIDER (GLID(1A+1F)/
(2A+1F)/(2A+2F)) FUNCTIONS . 75
Table of contents ........................................................ 75
Getting Started with a Basic 4-CH Glider ................ 76
GLIDER-SPECIFIC BASIC MENU FUNCTIONS ........ 78
Model type (PARAMETER submenu) ........................... 78
MOTOR CUT ................................................................ 79
GLIDER-SPECIFIC ADVANCE MENU FUNCTIONS
..... 80
AILE/RUDD .................................................................. 81
AILE-FLAP (GLID(2A+2F) only) .................................... 82
SPOILER MIX ............................................................... 83
OFFSETs (Additional fl ight conditions) ...................... 84
START DELAY (GLID(1A+1F) only) ................................. 85
CAMBER MIX ............................................................... 85
CAMBER FLAP .............................................................. 86
BUTTERFLY ................................................................... 87
Channel 3’s function selection (CONDITION/FUNCTION)
88
HELICOPTER FUNCTIONS .......................................... 89
Table of contents and reference info for helicopters . 89
Getting Started with a Basic Helicopter ................... 90
HELI-SPECIFIC BASIC MENU FUNCTIONS ................ 93
MODEL TYPE (PARAMETERS submenu) ........................ 93
SWASH AFR (swashplate surface direction and travel
correction) (not in H-1) .............................................. 95
THROTTLE MIX ............................................................ 96
Setting up the Normal Flight Condition ................... 97
THR-CUT (specialized settings for helicopter specifi c
models) ..................................................................... 98
HELI-SPECIFIC ADVANCE MENU FUNCTIONS ........... 99
THROTTLE HOLD .......................................................... 99
THR-CURVE, PIT-CURVE and REVO ............................. 100
Idle-ups ................................................................... 101
Trims/offset ............................................................. 102
Delay ....................................................................... 103
Hovering setups ...................................................... 104
High/low pitch ........................................................ 105
Gyros and governors ............................................... 106
Glossary ........................................................................ 110
Note that in the text of this manual, beginning at this
point, any time we are using a feature’s specialized name
or abbreviation, as seen on the screen of the 10C, that
name, feature, or abbreviation will be exactly as seen on
the radio’s screen, including capitalization and shown in
a DIFFERENT TYPE STYLE for clarity. Any time we mention
a specific control on the radio itself, such as moving
SWITCH A, KNOB VR(B) THROTTLE STICK, or the ,
those words will be displayed as they are here.