2 Channel RF Remote Controller User Guidelines
PAIRING RF REMOTE CONTROLLER WITH RECEIVER:
1. Press the RF Code Key on Receiver.
2. Press any button on RF Controller. Connected lights on Receiver will blink once to confirm pairing was successful.
3. To Delete pairing press and hold RF Code Key on Receiver for 3 seconds. Connected lights will flash twice.
Note: One Controller can be paired with up to 10 Receivers.
RoscoLED® VariWhite
Wiring Guide for Receiver
S1 S2
Power Off
Press to turn off the remote.
CCT Color Wheel
Touch to select color temperature. Drag finger to adjust
between warm white spectrum (orange) and cool white
spectrum (blue). This will allow you to utilize the full
capacity of your RoscoLED tape Kelvin range in a more
precise manor.
Brightness Down
Press and hold down to decrease light intensity.
Scene 2
Press and hold down to save current outputs. Click to
recall the saved color/effect you saved. You can save up
to two colors per scene by repeating this process for
Scene 1.
50% Brightness
Click to change from current
brightness setting to 50% intensity.
100% Brightness
Click to change from current brightness
setting to 100% intensity.
Power On
Press to turn on power to the remote.
Brightness Up
Press and hold down to increase light intensity.
25% Brightness
Click to change from current
brightness setting to 25% intensity.
75% Brightness
Click to change from current
brightness setting to 75% intensity.
LED Indicator
This will illuminate orange to indicate a response
between your finger and the remote. This ensures that
your remote should be working properly.
If it does not illuminate, click the power on button.
Scene 1
V+ V-
AC Power
50/60Hz
L
N
G
V+
V-
OUTPUT
IN PUT
12V/24V
CV PSU
VariWhite LED Strip
V+ V+
WW- WW-
CW- CW-
Pa iri ng K ey
RF LED Controller
V+
V-
INPUT
V+
V-
INPUT
V+
WW
CW
CCT LED Str ip
V+ V+
WW- WW-
CW- CW-
Pa iri ng K ey
RF LED Controller
V+
V-
INPUT
V+
V-
INPUT
V+
WW
CW
