Rupert Neve Designs Portico II Manual

Rupert Neve Designs Processor Portico II

Læs gratis den danske manual til Rupert Neve Designs Portico II (22 sider) i kategorien Processor. Denne vejledning er vurderet som hjælpsom af 29 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 15 anmeldelser. Har du et spørgsmål om Rupert Neve Designs Portico II, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/22

Operations Manual

By:

Serial #:

Portico II Channel User Guide

Thank you for your purchase of a Portico II Channel module.

Everyone at Rupert Neve Designs hope you enjoy using this tool as much as we have enjoyed

designing and building it. The name “Portico II” will be used for a series of new ultra-high end

professional products that will share some traits. Please take note of the following list of safety concerns

and power requirements before the use of this or any Portico II Series product.

Safety

It’s usual to provide a list of “do’s and don’ts” under this heading but mostly these amount to

common sense issues. However, here are important safety requirements that must be adheared to:

Heat generated by the Channel module is radiated through the case work and by convection through the

ventilation holes, therefore the holes should not be covered or blocked. To avoid overheating,

Portico II units should not be stacked immediately above or adjacent to other equipment that

gets hot, and one rack space above the unit should be left open for heat ventilation.

Also bear in mind that other equipment may radiate strong hum elds which could spoil

the performance of your Portico II module.

Protect the power cord from being walked on or pinched, particularly at plugs convenience receptacles

and the point where they exit from the apparatus. Do not defeat the safety purpose of the polarized or

grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type

plug has two blades and a third grounding prong. The wide blade or the third prong are provided for

your safety. Unplug the module during lightning storms or when unused for long periods of time.

Don’t operate your Portico II module in or around water! Electronic equipment and liquids are not

good friends. If any liquid is spilled, such as soda, coffee, alcoholic or other drink, the sugars and

acids will have a very detrimental effect. Sugar crystals act like little rectiers and can produce

noise (crackles, etc.). SWITCH OFF IMMEDIATELY because once current starts to ow the

mixture hardens, can get very hot (burnt toffee!) and cause permanent and costly damage. If it gets

wet and you suspect that good clean water may have gotten in, immediately unplug the unit, and

remove it from the source of water. Please contact support as soon as possible at

support@rupertneve.com for resolution. Clean only with dry cloth.

Don’t be tempted to operate a Portico II unit with the cover removed. The cover provides magnetic

screening from hum and R.F. stray elds.

Power Requirements

Each Portico II unit has a high quality, low noise switching power supply that is further ltered and shunt

regulated for an exceptionally quiet and reliable power source for the audio circuits. The power sup-

ply is considered “universal” in the sense that it will accept 100V through 240V AC and complies with

standard mains voltages around the world. Be absolutely sure to disconnect mains power (remove the

power cable from the IEC power connector at the back panel) before checking the fuse. The fuse is lo-

cated in the IEC power input connector and is accessed by opening the small panel labeled “FUSE”. The

fuse should always be replaced with the correct value and type. The Portico II power supply requires a

5x20 mm 2.5 amp fast acting ceramic body fuse Bussman type GDA 2.5A or equivalent.

Produkt Specifikationer

Mærke:	Rupert Neve Designs
Kategori:	Processor
Model:	Portico II

Har du brug for hjælp?

Hvis du har brug for hjælp til Rupert Neve Designs Portico II stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Processor Rupert Neve Designs Manualer

Rupert Neve Designs Portico II Manual

27 September 2024

Rupert Neve Designs Portico 543 Manual

22 Juli 2024

Rupert Neve Designs 5045 Manual

28 Januar 2024

Rupert Neve Designs Portico 542 Manual

26 December 2022

Rupert Neve Designs 5254 Manual

13 November 2022

Processor Manualer

Nyeste Processor Manualer

ART SOLO STUDIO Manual

2 August 2025

Tascam MM-2D-E Manual

24 Juli 2025

Tascam ML-4D/OUT-E Manual

23 Juli 2025

Tascam MM-4D/IN-X Manual

23 Juli 2025

LD Systems ZONE X 1212 Manual

23 Juli 2025

LD Systems ZONE X 1212 D Manual

22 Juli 2025

17 Juli 2025

17 Juli 2025

17 Juli 2025

17 Juli 2025