Russound CA4-WP Manual

Russound Ikke kategoriseret CA4-WP

Læs gratis den danske manual til Russound CA4-WP (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 40 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 20.5 anmeldelser. Har du et spørgsmål om Russound CA4-WP, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

CA4-WP

CA4 Wall Port

Installation Manual

Overview

The Russound CA4-WP Wall Port provides a connection between

the CA4 controller and the CA-KP keypads. It is mounted near the

controller in a single-gang electrical box.

Specications

1.9" x 1.9" x 4.1" ( 49 x 49 x 105mm)Dimensions:

Weight: 0.25 lb. (0.11kg)

Keypad ports: 4

CAT-5 - RJ-45 terminationKeypad Cables:

Speaker connections: 4

14-18 gauge - screw terminationSpeaker Cables:

Wall Port to controller 6' (2m)Max cable length:

Wall Port to keypad 240' (73.2m)

Wall Port to speaker 240' (73.2m)

Safety Instructions

1. Read Instructions - All the safety and operating instructions should be read

before the appliance is operated.

2. Retain Instructions - The safety and operating instructions should be

retained for future reference.

3. Heed Warnings - All warnings on the appliance in the operating instructions

should be adhered to.

4. Follow Instructions - Follow all operating and user instructions.

5. Water and Moisture - The appliance should not be used near water;

for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet

basement, or near a swimming pool.

6. Wall Mounting - The appliance should be mounted to a wall as

recommended by the manufacturer.

7. Heat - The appliance should be situated away from heat sources such as

radiators, heat registers, stoves, or other appliances (including ampliers) that

produce heat.

8. Power Sources - The appliance should be connected to a power supply

only of the type described in the operating instructions or as marked on the

appliance.

9. Grounding or Polarization - Precaution should be taken so that the

grounding or polarization means of an appliance is not defeated.

10. Object and Liquid Entry - Care should be taken so that objects do not fall

and liquids are not spilled into the enclosure through the openings.

11. Damage Requiring Service - The appliance should be serviced by qualied

service personnel when:

The power supply cord or the plug has been damaged;

Objects have fallen, liquid has been spilled into the appliance;

The appliance has been exposed to rain;

The appliance does not appear to operate normally; or

The appliance has been dropped or the enclosure is damaged.

12. Servicing - The user should not attempt to service the appliance beyond

that described in the operating instructions. All other servicing should be

referred to qualied service personnel.

13. Care – From time to time you should wipe o the front panel with a soft

dry cloth.

Limited Warranty

The Russound CA4-WP is fully guaranteed for two (2) years from the date

of purchase against all defects in materials and workmanship. During this

period Russound will replace any defective parts and correct any defect in

workmanship without charge for either parts or labor. For this warranty to

apply, the unit must be installed and used according to its written instructions.

If service is necessary, it must be performed by Russound. Russound assumes

no responsibility for defects resulting from abuse or servicing performed by an

agency or person not specically authorized in writing by Russound. Damage to

or destruction of components due to improper use voids the warranty. In these

cases the repair will be made at the owner’s expense. Accidental damage and

shipping damage are not considered defects under the terms of the warranty.

To return for repairs, the unit must be shipped to Russound at the owner’s

expense, along with a Return Authorization number and documentation

explaining the nature of the service required. Any product returned without

prior written permission will be returned to sender. Russound sells products

only through authorized Dealers and Distributors to ensure that customers

obtain proper support and service. Any Russound product purchased from an

unauthorized dealer or other source, including retailers, mail order sellers and

online sellers will not be honored or serviced under existing Russound warranty

policy. Any sale of products by an unauthorized source or other manner not

authorized by Russound shall void the warranty on the applicable product.

the property of their respective owners. Russound is not responsible for

typographical errors or omissions. Specications are subject to change without

notice.

Russound, Inc. 5 Forbes Rd., Newmarket, NH 03857, USA

tel 603.659.5170 • fax 603.659.5388 www.russound.com

Technical support: 866.888.7466 e-mail: tech@russound.com

KAW 02/03/10

Wall Port Installation

Pick an unobtrusive location close to the controller that 1.

all cables (speaker and keypad) can be routed to.

Install an electrical box, using a UL/CSA approved plastic 2.

single-gang (18 ci or deeper) electrical box. If there will

be two controllers you should use two single-gang

boxes separated slightly to allow space for the cables.

Route CAT-5 wire from the electrical box to the four keypad 3.

locations. Route the speaker cable from the electrical box

to the corresponding speaker locations. Label each set of

cables with the zone and location.

Terminate each CAT-5 wire with a RJ-45 plug using the 4.

T568A standard conguration.

Strip 1 to 2 inches (2.5 to 5 cm) o the end of each speaker 5.

cable jacket. Then strip 1/4 inch (0.7 cm) of insulation o

each wire.

Twist the speaker wire strands together so there are no 6.

strands separated from the bundle.

Insert the proper speaker wire, matching channel 7.

and polarity for all four wires. Tighten the screws until

the wires are secured in the terminal.

Cable as follows (standard 4-conductor):

White -- L+ (left channel positive), Green -- L- (left channel

negative), Black -- R- (right channel negative) and Red --

R+ (right channel positive).

Check to make sure there are no stray strands of wire 8.

outside the terminals. If there are, remove the wire, twist

the strands together, and reconnect the wire to the

terminal.

Complete the same steps for the remaining zones. Plug 9.

each of the RJ-45 plugs into the corresponding keypad

zone jack on the rear of the wall port. All four Note:

connections from the controller to the wall port must be

made, even if there are less than 4 keypads connected

to the system. Cables between the wall port and the

controller must match numerically (#1 on the wall port

to #1 on the controller).

Mount the wall port in the electrical box. Push any extra 10.

cable back into the wall. Screw the wall port plate to the

electrical box. Attach the trim plate to the wall port.

CA4 Wall Port (rear)

Speaker terminals

Four pair 8 ohm speakers

Two channels each

RJ-45 Keypad Connections

Connect to each keypad

RJ-45 Connections

Use included CAT-5 cables

to connect the controller

to the Wall Port.

CA4 Wall Port (front)

When changing face plate

colors, the plate cutouts

must be on the same side

as the zone numbers

Wall Port Front and Rear Speaker Outputs

The CA4 supports speaker outputs for zones 1 through 4 for

each controller with a maximum of eight zones. Each speaker

connection requires a 8-ohm load and will provide 15 watts

per channel. Standard 16-gauge 4-conductor stranded

speaker wire can be run up to 125 feet; 14-gauge wire can be

run up to 250 feet.

The speakers are connected to the CA4 Wall Port using xed

screw terminals. Each of these terminals is designated for the

speaker set of a particular amplied zone. To avoid confusion,

connect one zone speaker set at a time starting with Zone 1,

taking care to keep zone and speaker wire identities straight.

Controller / Keypad Conguration

The CA4 Wall Port jacks are located on the rear of the

controller. These RJ-45 ports must be connected to the

corresponding jacks on the wall port. Each keypad is then

connected to the wall port.

All CAT-5 connections are made with RJ-45 connectors

using the T568A Wiring Standard conguration. For a clean

installation use the included RJ-45 CAT-5 pass-through

cables to connect from the controller wall port jack to the

corresponding one on the CA4-WP. Using the same wiring

conguration to terminate the ends, route a CAT-5 cable

from the wall port to each of the keypads. Cables from the

controller to the wall port should not exceed 6 feet (2m).

The maximum recommended CAT-5 cable length is 240 feet

(73.2m) between the wall port and the keypad.

Note: All four CAT-5 cables must be connected between the

controller and wall port for proper operation.

Caution: Cables between the wall port and the controller

must match numerically (#1 on Controller to #1 on Wall Port,

etc.). Swapping cables to dierent ports can damage the

equipment.

Produkt Specifikationer

Mærke:	Russound
Kategori:	Ikke kategoriseret
Model:	CA4-WP

Har du brug for hjælp?

Hvis du har brug for hjælp til Russound CA4-WP stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Russound Manualer

Russound CA4-KP Manual

5 September 2024

Russound SA-ZX3 Manual

5 September 2024

Russound KNX-RIO-1 Manual

5 September 2024

Russound CB-140 Manual

5 September 2024

Russound A-H4D Manual

5 September 2024

Russound CA4-WP Manual

5 September 2024

Russound A-K4 Manual

5 September 2024

Russound HTP-7.2 Manual

1 September 2024

Russound SLM-1K Manual

1 September 2024

Russound ALT-70V-50 Manual

1 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

ORNO OR-ZL-1678 Manual

15 Juni 2025

LiftMaster 041-0405-000 Manual

15 Juni 2025

CDN TMW1 Manual

15 Juni 2025

Bradley S19-500 Manual

15 Juni 2025

Vestil FE-4-72 Manual

15 Juni 2025

Powr-Flite PFX1080 Manual

15 Juni 2025

Hughes & Kettner BassKick 707 Manual

15 Juni 2025

Marshall VSC-100 Manual

15 Juni 2025

Xiaomi Smart Electric Toothbrush T501 Manual

15 Juni 2025

Scarlett SC-SM10S53 Manual

15 Juni 2025