Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 USA
Customer Service: 1-800-359-5520 • info@sanus.com • www.sanus.com
©2009 Milestone AV Technologies. All rights reserved. Sanus is a division of Milestone. All other brand names or marks
are used for identification purposes and are trademarks of their respective owners.
ELM205 Power Conditioner
(6901-100215 <01>)
Specifications
• 2,700 joule surge suppression
• Dual Stage EMI/RFI noise filtration 20-50dB (100KHz-1MHz)
• Gold-plated coaxial input and outputs
• Combo ethernet/phone jack - supports up to 100Base-T connection speeds
• 125V/60Hz/12 A max
• Suppressed voltage rating: L-N 400V L-G 500V N-G 500V
• Audible alarm if surge has served it’s useful life
• Resettable fuse
• Interchangeable 1’ * or 6’ ** power cords
• ClickFit compatible
* 1’ power cord is intended for use in special installations only; such as, dedicated equipment intended to be mounted near a
receptacle.
** 6’ power cord is intended for use in all other installations.
Warranty
Your Sanus ELM205 has a five year product warranty against manufacturer’s defects. If you have any questions or experience any
problems with your Sanus Elements product, please contact Sanus Systems Customer Service at 1-800-359-5520.
Avoid potential injuries! Do not disassemble the surge protector. Disassembling the surge
protector will void the warranty and may cause serious personal injury.
Avoid potential damage to your electrical components! Disconnect the surge protector during
lightning storms. Not for use near water or in areas with high moisture.
This product contains small items that could be a choking hazard if swallowed. Keep these items
away from young children!
WARNINGS
Hardware and procedures for multiple mounting configurations are included. When you see this symbol,
choose the correct configuration to suit your needs. Not all hardware included will be used.
The input plug of this power tap is intended to serve as the disconnect device, it shall be easily
accessible and withdrawn.
Cable distribution system should be grounded (earthed) in accordance with ANSI/NFPA 70, the National
Electrical Code (NEC), in particular Section 820.93, Grounding of Outer Conductive Shield of a Coaxial
Cable.
CAUTIONS
