Scansonic S8 Active Sub Manual

Scansonic Højttaler S8 Active Sub

Læs gratis den danske manual til Scansonic S8 Active Sub (9 sider) i kategorien Højttaler. Denne vejledning er vurderet som hjælpsom af 88 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 44.5 anmeldelser. Har du et spørgsmål om Scansonic S8 Active Sub, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/9
H I F I L O U D S P E A K E R S
S8
02
06
08
OWNER’S MANUAL
TROUBLESHOOTING
LIMITED WARRANTY
S8
H I F I L O U D S P E A K E R S
Introduction
Thank you for choosing Scansonic loudspeakers, we hope they
will bring you many years of enjoyment.
Please read this manual fully before unpacking and installing
the product.
Carton contents
During production and packing we have carefully checked and
inspected this subwoofer.
After unpacking please check for any damage from transport.
We recommend that you keep the original cartonbox and
packing material for any future shipping.
In the cartonbox you will find:
1 Input cable, RCA phono type
Loudspeaker installation
The subwoofer requires connection to the mains power supply,
so for your safety it is important that you read both this manual
and the amplifier manual before connecting.
Subwoofer positioning
Variations in placement of your loudspeakers can produce
dramatic differences in the way music sounds. No listening
rooms are the same and therefore we encourage you to spend
some time experimenting with which placements work best in
your listening room. Position of subwoofers are however less
critical compared with full-range loudspeakers because the low
frequencies reproduced by a subwoofer are difficult to locate
in the room. Trust your ears and be willing to experiment freely.
You can start with our basic recommendations.
To begin with, the subwoofer should be positioned between the
TV and one of your front loudspeakers. Fig. 1 - 3.
Connecting your subwoofer
We recommend that you read the manual of your amplifier or
AV-receiver carefully before connecting your subwoofer.
First switch off amplifier and all equipment when connecting
your subwoofer.
Connect the subwoofer input IN (4) and your amplifiers SUB out
with the enclosed RCA phono cable.
Connect the subwoofer net cable (2) to the mains voltage ,
and push the POWER ON/OFF button (1) to ON position, the
indicator lamp POWER LED (9) will now glow green and the
subwoofer is active and ready to be used. Fig. 4.
The Scansonic S8 subwoofer has a built-in AUTO STANDBY
function and after approximately 5 minuttes without any input
signal the subwoofer will automatically switch off, and the
indicator lamp POWER LED (9) will glow red. When an input
signal is detected the subwoofer will become active and the
indicator lamp POWER LED (9) will glow green.
Setting volume, frequency and phase
The volume, crossover and phase (controls 6, 7 and 8) can be
adjusted on the rearpannel, and we recommend that you adjust
the setting of these controls to your liking – try with different
music and films. If you want more detailed informations on
these control functions, we invite you to visit our homepage
www.scansonic.dk.
Running-in period
We recommend a running-in time of your new Scansonic S8
subwoofer of approximately 15-20 hours at normal listening
level before you decide on the final positioning and controls
settings of the subwoofer . During the running-in time the drive
units will settle in and perform as intended.
Care and cleaning
We don’t recommend use of any solvents or cleaners on
Scansonic S8 lacquered cabinets, the cabinet surface usually
only requires dusting or cleaning with a soft cloth (do not use
water).
The grille fabric may be cleaned with a normal clothes brush or
vacuumed carefully with the grille detached from the cabinet.
Avoid touching the woofer drive unit, and do not use the
subwoofer as a coffee or drinks table (risk of water being spilled
into the subwoofer).
Disconnect the subwoofer from the mains supply if taken out of
use for a longer period.
Environmental information
Scansonic S8 subwoofer comply with international directives
on the Restriction of Hazardous Substances (RoHS) in
electrical and electronic equipment and the disposal of Waste
Electrical and Electronic Equipment (WEEE) - the crossed bin
symbol indicates compliance and that the products must be
appropriately recycled or processed in accordance with these
directives.
Owner ’s manual

Produkt Specifikationer

Mærke: Scansonic
Kategori: Højttaler
Model: S8 Active Sub

Har du brug for hjælp?

Hvis du har brug for hjælp til Scansonic S8 Active Sub stil et spørgsmål nedenfor, og andre brugere vil svare dig


Højttaler Scansonic Manualer

Scansonic

Scansonic S6 Manual

18 August 2024
Scansonic

Scansonic S8 Active Sub Manual

17 August 2024
Scansonic

Scansonic Q1000 Manual

16 August 2024
Scansonic

Scansonic S12 Active Sub Manual

16 August 2024
Scansonic

Scansonic S5 Active Manual

13 August 2024
Scansonic

Scansonic S5 BT Active Manual

10 August 2024
Scansonic

Scansonic M7 Manual

8 August 2024
Scansonic

Scansonic S4 Manual

1 August 2024
Scansonic

Scansonic S5 BTL Active Manual

8 Juni 2023

Højttaler Manualer

Nyeste Højttaler Manualer

Ibiza Sound

Ibiza Sound LYRA400 Manual

15 September 2025
TVLogic

TVLogic RKM-356A Manual

14 September 2025
Ibiza Sound

Ibiza Sound DJ350LED Manual

14 September 2025
Mackie

Mackie HD1531 Manual

14 September 2025
Mackie

Mackie MR5mk2 Manual

14 September 2025
Mackie

Mackie DRM212 Manual

14 September 2025
Mackie

Mackie V-Class SRM210 Manual

14 September 2025
Mackie

Mackie CR4 Manual

14 September 2025
Mackie

Mackie DRM12A Manual

14 September 2025
Mackie

Mackie Thrash212 GO Manual

14 September 2025