Scott i-CX 2 Manual

Scott Vugge & Dockingstation i-CX 2

Læs gratis den danske manual til Scott i-CX 2 (4 sider) i kategorien Vugge & Dockingstation. Denne vejledning er vurderet som hjælpsom af 24 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 12.5 anmeldelser. Har du et spørgsmål om Scott i-CX 2, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

i-CX 2

ALARM CLOCK RADIO

WITH iPod DOCKING STATION

Instruction Manual

GB-1

PRECAUTIONS

Follow the advice below for safe and appropriate operations.

PLACEMENT

. Do not use the unit in places which are extremely hot, cold, dusty, or humid.

. Place the unit on a flat and even surface.

. Do not restrict the airflow of the unit by placing it in a place with poor airflow, by covering it with a

cloth, or by placing it on a carpet.

. Do not place naked flame sources, such as lighted candles on the apparatus.

. Use the apparatus only in moderate climates (not in tropical climates).

. Do not expose the apparatus to dripping or splashing.

. Do not place objects filled with liquids, such as vases, on the apparatus.

SAFETY

. When connecting and disconnecting the AC power cord from the AC mains outlet, pull the plug and

not the cord itself. Pulling the cord may damage it and may be dangerous.

. The mains outlet and plug must always remain readily operable.

. When you are not going to use the unit for a long period of time, disconnect the AC power cord from

the AC mains outlet.

AC VOLTAGE

. Before use, check that the rated voltage of your unit matches your local voltage.

CONDENSATION

. When there is condensation inside the unit, it may not function normally.

. Let the unit stand for 1 to 2 hours before turning the power on, or gradually heat the room up and

dry the unit before use.

. Ensure a minimum distance of 5 cm around the apparatus for sufficient ventilation.

. Ensure that the ventilation is not impeded by covering the ventilation openings with items such as

newspapers, tablecloths, curtains, etc.

BATTERIES

. Pay attention to the environmental aspects of battery disposal.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

The lightning flash with an

arrowhead symbol within a

triangle is a warning sign

alerting the user to the

presence of “dangerous

voltage” inside the unit.

ATTENTION: To reduce the risk

of electric shock, do not remove

the cover. There are no user

serviceable parts inside the unit.

Refer all servicing to qualified

personnel.

The exclamation mark

within a triangle is a

warning sign alerting the

user to the presence of

important instructions

accompanying the

product.

. In case of malfunction due to electrostatic discharge, the apparatus has to be reset by disconnecting

it from mains supply.

GB-2

1234 561

15171819

TABLE OF CONTENTS

PRECAUTIONS 1

TABLE OF CONTENTS 2

BOX CONTENTS 2

LOCATION OF CONTROLS 2

POWER SUPPLY 3

BASIC OPERATION 3

RADIO OPERATION 4

PLAYING AN iPod AND CHARGING THE INTERNAL iPod BATTERY 5

AUX IN FUNCTION 6

AUX OUT FUNCTION 6

MAINTENANCE 6

TROUBLESHOOTING GUIDE 7

TECHNICAL SPECIFICATIONS 7

BOX CONTENTS

1. Unit

2. Adapters for different iPod models (7x)

3. Instruction manual

LOCATION OF CONTROLS

1. Speakers (2x)

2. AC power cord

3. AUX IN jack

4. AUX OUT jack

5. DIMMER HI-LO switch

6. FM antenna wire

7. iPod docking station and connector

8. AM/FM/iPod/AUX switch

9. ALARM SET/OFF button

10. CLK SET button

11. Tuning scale

12. dial TUNING

13. MIN (Minute set) button

14. SNOOZE button

15. FM STEREO LED indicator

16. ON LED indicator

17. Clock back up battery door

18. Clock display

19. Alarm indicator

20. HR (Hour set) button

21. SLEEP button

22. VOLUME dial

23. / , SKIP/SEARCH, PLAY/PAUSE buttons

24. ON button

25. AUTO OFF/MUSIC/BUZZER switch

GB-3

POWER SUPPLY

AC power supply

Insert the AC power cord into the AC mains outlet with a 230V AC ~ 50Hz power source.

Installing the clock back up battery

If the AC cord is disconnected or there is a power failure, this electronic clock is designed to continue

operating internally (without showing the time on the display) with a 9 volt battery (type 6F22, not

included). To install the battery, open the clock back up battery door on the bottom of the unit.

Connect the battery to the terminals of the battery snap inside the compartment (use of an alkaline

battery is recommended) and close the battery door.

After a power failure, the clock time should continue operating. If a flashing time appears on the

display, it indicates the battery is dead or not connected properly. The 9 volt battery will keep the

clock time accurately for approximately 30 minutes. If the power is restored after 30 minutes, the time

may need to be reset.

Precautions when using batteries

1. Replace only with an identical battery or an equivalent type.

2. An exhausted battery must be removed to prevent any battery leakage.

3. Dispose of the battery properly according to environmental regulations.

BASIC OPERATION

ON/ Standby mode

After connecting the power supply (refer to POWER SUPPLY), the unit goes to standby mode and

the clock time is displayed. Press the ON button to turn on the unit and the ON LED indicator lights

up. Press it again to go to standby mode.

Clock time setting

Set the clock

1. Hold down the CLK SET button and press the HR button to set the hours.

2. Hold down the CLK SET button and press the MIN button to set the minutes.

Set the alarm time

1. Hold down the AL SET/OFF button and press the HR button to set the hours.

2. Hold down the AL SET/OFF button and press the MIN button to set the minutes.

Alarm operation

The unit allows you to wake up to a buzzer or to music (AM/FM/iPod).

1. Press and hold down the AL SET/OFF button to display the alarm time.

2. To adjust the alarm time, follow the steps in “Set the alarm time”.

3. To enable the alarm function, slide the AUTO OFF/MUSIC/BUZZER switch to MUSIC if you want

to wake up to music or BUZZER if you want to wake up to the sound of the buzzer. The ALARM

indicator at bottom left corner of the display lights up.

When you choose to wake up to music, the alarm clock radio will start to play the last track it

played before the unit was switched off. This means you can choose which song you will to wake

up to.

4. If MUSIC mode is selected, slide the AM/FM/iPod/AUX switch to select the desired alarm source.

5. When the preset alarm time is reached, the buzzer or music will start up.

6. To stop the alarm, press the AL SET/OFF button. The alarm will sound again at the same time the

next day.

7. To disable the alarm function, slide the AUTO OFF/MUSIC/BUZZER switch to AUTO OFF.

Produkt Specifikationer

Mærke:	Scott
Kategori:	Vugge & Dockingstation
Model:	i-CX 2
Vekselstrømsindgangsspænding:	220 - 240 V
Vekselstrømsindgangsfrekvens:	50 Hz
Bredde:	155 mm
Dybde:	160 mm
Højde:	65 mm
Vægt:	900 g
Batterispænding:	9 V
Pakkevægt:	1080 g
Pakkedybde:	89 mm
Pakkebredde:	213 mm
Pakkehøjde:	182 mm
Wi-Fi:	Ingen
Bluetooth:	Ingen
FM radio:	Ja
Udgangseffekt (RMS):	1.6 W
Equalizer:	Ingen
Udgange til hovedtelefoner:	1
Slumretimer:	Ja
Strømforbrug (typisk):	14 W
Skærm:	LED
Pakketype:	Kasse
Batterier inkluderet:	Ingen
Fjernbetjening inkluderet:	Ingen
Frekvensområde:	- Hz
Impedens:	8 ohm (Ω)
Lyd-output kanaler:	2.0 kanaler
LED-indikatorer:	Strøm
Strømkilde type:	Vekselstrøm
Vækkeur:	Ja
Antal understøttede batterier:	1
Visning af ur/dato:	Ja
AUX-indgang:	Ja
Understøttede radiobånd:	AM, FM
Driver diameter:	50 mm
Hovedkassen højde (udvendigt):	1816 mm
Hovedkassens længde (udvendigt):	800 mm
Hovedkassens bredde (udvendigt):	1200 mm
Tilslutning af hovedtelefoner:	3,5 mm
Højttalereffekt:	0.8 W
Bruttovægt, indvendig emballage:	4.660 kg
Bruttovægt af den udvendige papkasse:	472.36 kg
Mængde indvendig papkasse:	4 stk
Forsendelseskasses kassens bredde (indvendig):	390 mm
Forsendelseskassens længde (indvendig):	190 mm
Forsendelseskassens højde (indvendig):	227 mm
Kampatibilitet med Apple-docking:	iPad, iPhone
Snooze funktion:	Ja
Indbygget oplader:	Ja