Shadow SH-SC1 Manual

Shadow Ikke kategoriseret SH-SC1

Læs gratis den danske manual til Shadow SH-SC1 (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 24 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 12.5 anmeldelser. Har du et spørgsmål om Shadow SH-SC1, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

Sensor

copper foil

Fax: (561) 743 0460

eMail: jjmelch@shadow-pickups.com

Shadow Elektroakustik

Peter-Haendel Straße 2

91334 Hemhofen · Germany

Shadow Electronics of America Inc.

17791 Alexander Run

Jupiter, FL 33478 U.S.A.

Fax: +49 - 91 95 - 92 99 30

eMail: info@shadow-electronics.com

Installation Instruction for Shadow SH SC1

Twind Cello Transducer

Inhalt:Inhalt:

Fig. 1Fig. 1

Fig. 2Fig. 2

2 transducer discs (20mm diameter)

output socket (6,3mm) with double sided adhesive

copper foil

2 transducer discs (20mm diameter)

output socket (6,3mm) with double sided adhesive

copper foil

If pickup is too loose, shim with included shim material (see Fig. 2). If pickup is too tight, file the bridge slot slightly.If pickup is too loose, shim with included shim material (see Fig. 2). If pickup is too tight, file the bridge slot slightly.

1. Test fit sensors into the slot between the wing and foot. Pickup should fit tightly for best output (see Fig. 1).1. Test fit sensors into the slot between the wing and foot. Pickup should fit tightly for best output (see Fig. 1).

2. Install the sensors into the bridge slot.

3. Locate the output socket in a convenient location on the instrument and attach with applied double sided adhesive.

2. Install the sensors into the bridge slot.

3. Locate the output socket in a convenient location on the instrument and attach with applied double sided adhesive.

Note: