Sharebot NG XXL Manual

Sharebot 3D printer NG XXL

Læs gratis den danske manual til Sharebot NG XXL (42 sider) i kategorien 3D printer. Denne vejledning er vurderet som hjælpsom af 33 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 17 anmeldelser. Har du et spørgsmål om Sharebot NG XXL, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/42

Sharebot Next Generation XXL

user's manual

Version 0.3 16/09/2015

Sharebot srl Nibionno Italy

page 1

Sharebot Next Generation XXL

user's manual

ATTENTION – EXTRUDER

The fusion and extrusion system of the thermoplastic filament requires a heated end up to temperatures of 250 degrees and more. The contact, even for a very limited

time, with the heated part causes burns. You must avoid to put your hands or other body parts in the printing area when printing and for minutes after the printing process

is over. The current temperature of the extruder is indicated on the LCD screen.

ATTENTION – HEATED PRINTING BED

All the printing plate is made of metal with the addition of a glass plate. This device is electrically heated and serves to bring to desired temperature the entire printing

bed, including the glass plate. The temperature is measured directly on the heating plate: so the temperature of the glass plate will be less than the one shown for several

minutes after the beginning of the heating process, but likewise it may be warmer than what is indicated on the display for several minutes after the end of the printing

due to the the phenomenon of thermal inertia. Remember that it can be set in special cases for temperatures of 90 degrees, while the recommended temperature for

prints is usually 80 degrees. At these temperatures the unintentional contact does not produce damage and burns if you retract immediately the body part that is in

contact, while at higher temperatures it greatly reduces the time necessary to create burns. You have always to check the temperature indicated on the display before you

start maneuvering like the removing of the glass plate on the printing bed.

Sharebot srl Nibionno Italy

page 2

Produkt Specifikationer

Mærke:	Sharebot
Kategori:	3D printer
Model:	NG XXL
Bredde:	950 mm
Dybde:	450 mm
Højde:	410 mm
Vægt:	38000 g
Produktfarve:	Sort
Kompatible hukommelseskort:	SD
USB-port:	Ja
Udskrivningsteknologi:	Fused Filament Fabrication (FFF)
Husmateriale:	Rustfrit stål
Indbygget kortlæser:	Ja
Visningsvindue:	Ja
Maksimal printstørrelse:	700 x 250 x 200 mm
Dysebredde:	0.4 mm
Lag (min.):	0.1 mm
3D scanner:	Ingen
Printemateriale:	Nylon, Polylactic acid (PLA), Thermoplastic polyurethane (TPU)
Opvarmet print platform:	Ja
Maksimal printhastighed:	41 mm³/s