Shark S1000UK Manual

Shark Damprenser S1000UK

Læs gratis den danske manual til Shark S1000UK (2 sider) i kategorien Damprenser. Denne vejledning er vurderet som hjælpsom af 32 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 16.5 anmeldelser. Har du et spørgsmål om Shark S1000UK, eller vil du spørge andre brugere om produktet?

Side 1/2
Please be sure to read the enclosed Shark® Instructions prior to using your unit.
S1000UK_QSG_MP_190328
QUICK START GUIDE
STEAM MOP
WHATS INSIDE
A Steam Mop Handle
B Steam Mop Pole
C Steam Mop Body
D Water Tank
E Water Tank Cap
F Dirt Grip Pad x 2
G Mop Head
B
A
C
D
F
G
E
ASSEMBLY
1. Align the Mop Handle and Mop Pole so the arrow
symbols inside them face forward. Insert either end
of the pole into the handle until it clicks securely into
place.
2. Align the Mop Pole and the Mop Body so their arrow
symbols face forward. Insert the pole into the top of the
mop body, sliding it in until it clicks into place.
3. Place the Dirt Grip™ cleaning pad on the floor with
the quick fastener strips facing up. Align the mop
head directly over the pad, then press the mop head
down onto the pad. The quick fastener strips will
secure the pad to the mop head.
3
(Click)
(Click)
1
2
USING THE STEAM MOP
For questions or to register your product, contact us at 0800 862 0453 or visit us online at sharkclean.eu
@sharkcleaning
Please be sure to read the enclosed Shark® Instructions prior to using your unit.
FILLING THE WATER TANK
1. To remove the water tank, lift it up and away from the
Steam Mop body.
1. Pull and twist the quick release cord holder to unwrap
the power cord completely (Fig. 1). When Steam Mop
is plugged into an electrical outlet, the power light will
illuminate (Fig. 2).
2. Remove the water tank cap by twisting counterclockwise.
Fill tank completely with distilled water or tap water.
3. Replace cap on water tank and turn cap clockwise to
seal. To replace the water tank, align it so the cap faces
down. Place the cap into the hole in the Steam Mop
body and slide tank down until it clicks securely into
place.
2. After 30 seconds, pump the handle a few times in a
downward motion to prime the mop and activate steam.
3. Mop with a forward and backward motion to
automatically customize steam output.
2
2
3
3
1
1
Fig. 1 Fig. 2


Produkt Specifikationer

Mærke: Shark
Kategori: Damprenser
Model: S1000UK

Har du brug for hjælp?

Hvis du har brug for hjælp til Shark S1000UK stil et spørgsmål nedenfor, og andre brugere vil svare dig