Sharkoon Vibe-Fixer III 5.25" Manual

Sharkoon Hukommelseskortlæser Vibe-Fixer III 5.25"

Læs gratis den danske manual til Sharkoon Vibe-Fixer III 5.25" (2 sider) i kategorien Hukommelseskortlæser. Denne vejledning er vurderet som hjælpsom af 42 personer og har en gennemsnitlig bedømmelse på 3.5 stjerner ud af 21.5 anmeldelser. Har du et spørgsmål om Sharkoon Vibe-Fixer III 5.25", eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Manual

www.sharkoon.com

HDD VIBE FIXER

1. Apply the cushion pads to the frame (fig. 1).

2. Slide the silicone covers over the 6 clamps of the

frame (fig. 2).

3. Fasten the rubber bands to the outer clamps of

the frame (fig. 3).

9. Fasten the last rubber band to the frame’s central

hook (fig. 7).

This is how the frame should finally look like (fig. 8).

10. Install the frame with the HDD into the computer

case. Secure it with the included screws.

Operating conditions:

Any hard disk of 3.5" width and 1" height can be

mounted and operated with the Vibe-Fixer. The

operation temperature should not exceed 50°

Celsius permanently. For short periods of time, up

to 70° Celsius are tolerable for the rubber bands.

Keep in mind that the aging process of the rubber is

accelerated by heat! The rubber bands must not be

exposed to daylight (UV light) for long periods of

time.

Transportation note:

Rough handling during transportation may cause

some displacement of the hard disk from its rubber

suspension. After transportation open the PC, check

and correct any possible displacement of the disk to

ensure perfect operation of the unit.

It is strongly recommended to check the rubber

bands prior to any movement/shipment of the

computer (see section "Maintenance").

Maintenance:

The rubber bands of the VIBE FIXER are subject to

an aging process. Therefore it is required that the

rubber bands’ condition is checked every 12-18

months and to replace them if needed. Take a very

close look at the spots where the rubber is bent the

most, at the hooks and at the edges of the hard disk.

If cracking shows up, any part of the rubber feels

tacky or if the surface of the rubber bands looks

distinctively whitish, do not use the unit until the

rubbers have been replaced. You can order /

purchase substitution rubber bands at

support@sharkoon.com.

4. Two silicone covers come with a lengthwise cut.

Slide these covers over both inner parts of the

rubber bands (fig. 4).

5. Fasten the two inner parts of the rubber bands

with the included cable tie. Take care to move the

cable tie over the silicone covers (fig. 4). Cut the

overlaying end of the cable tie with a pair of

scissors.

6. Place the frame on a flat surface in front of you.

7. Pull up the outer string of a rubber band and

carefully slide the HDD into the gap (the strings of

the rubber bands which are tied together by the

cable tie go underneath the HDD) (fig. 5).

Note:

Take care that the rubber bands will not be amaged

by the HDD or parts of it.

8. Slide the outer string of the second rubber band

over the HDD and center the drive between the

rubber bands (fig. 6).

Note:

The rubber bands of the frame are quite sensitive to

mechanical damage. Sharp edges of the hard disk

may cause small cuts in the rubber, which might go

unnoticed but could eventually lead to disruption of

the rubber. While inserting the hard disk into the

frame this risk is most present. Therefore any sharp

edges on the hard disk must be covered using

standard isolating tape.

Important:

Never pull or press the rubber bands directly onto

any electronics of the hard disk. It is harmless if the

rubber bands touch the electronics, yet force must

be avoided. Try to avoid placing rubber bands

directly across processor chips of the hard disk as

they might get hot.

Produkt Specifikationer

Mærke:	Sharkoon
Kategori:	Hukommelseskortlæser
Model:	Vibe-Fixer III 5.25"

Har du brug for hjælp?

Hvis du har brug for hjælp til Sharkoon Vibe-Fixer III 5.25" stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Hukommelseskortlæser Sharkoon Manualer

Sharkoon Vibe-Fixer III 5.25" Manual

18 August 2024

Sharkoon Media Reader IV Manual

17 August 2024

Sharkoon Media Reader All-in-One Manual

16 August 2024

Hukommelseskortlæser Manualer

Nyeste Hukommelseskortlæser Manualer

Vantec UGT-CR940 Manual

27 Februar 2025

Act AC7054 Manual

20 Februar 2025

OneSpan Digipass 882 Sm@rt Tan Photo Manual

26 December 2024

Vimar 19457.TR.M Manual

15 December 2024

D-Link DUB-2325 Manual

13 December 2024

König CSU3H4P200BL Manual

8 Oktober 2024

König CSU3ACR100BL Manual

4 Oktober 2024

Hama 123948 Manual

18 September 2024

Icy Dock MB123SRCK-1B Manual

6 September 2024

StarTech.com 1B-USB-C-CFE-ADAPTER Manual

5 September 2024