Shure PA805Z2 Manual

Shure Ikke kategoriseret PA805Z2

Læs gratis den danske manual til Shure PA805Z2 (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 13 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 7 anmeldelser. Har du et spørgsmål om Shure PA805Z2, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

IMPORTANT SAFETY INSTRUCTIONS

1. READ these instructions.

2. KEEP these instructions.

3. HEED all warnings.

4. FOLLOW all instructions.

5. DO NOT use this apparatus near water.

6. CLEAN ONLY with dry cloth.

7. DO NOT block any ventilation openings. Allow sufficient distances for

adequate ventilation and install in accordance with the manufacturer’s

instructions.

8. DO NOT install near any heat sources such as open flames, radiators,

heat registers, stoves, or other apparatus (including amplifiers) that pro-

duce heat. Do not place any open flame sources on the product.

9. DO NOT defeat the safety purpose of the polarized or grounding type

plug. A polarized plug has two blades with one wider than the other. A

grounding type plug has two blades and a third grounding prong. The

wider blade or the third prong are provided for your safety. If the provided

plug does not fit into your outlet, consult an electrician for replacement

of the obsolete outlet.

10. PROTECT the power cord from being walked on or pinched, particularly

at plugs, convenience receptacles, and the point where they exit from

the apparatus.

11. ONLY USE attachments/accessories specified by the manufacturer.

12. USE only with a cart, stand, tripod, bracket, or table specified by the

manufacturer, or sold with the apparatus. When a cart is used, use caution

when moving the cart/apparatus combination to avoid injury from tip-over.

13. UNPLUG this apparatus during lightning storms or when unused for long

periods of time.

14. REFER all servicing to qualified service personnel. Servicing is required

when the apparatus has been damaged in any way, such as power

supply cord or plug is damaged, liquid has been spilled or objects have

fallen into the apparatus, the apparatus has been exposed to rain or

moisture, does not operate normally, or has been dropped.

15. DO NOT expose the apparatus to dripping and splashing. DO NOT put

objects filled with liquids, such as vases, on the apparatus.

16. The MAINS plug or an appliance coupler shall remain readily operable.

17. The airborne noise of the Apparatus does not exceed 70dB (A).

18. Apparatus with CLASS I construction shall be connected to a MAINS

socket outlet with a protective earthing connection.

19. To reduce the risk of fire or electric shock, do not expose this apparatus

to rain or moisture.

20. Do not attempt to modify this product. Doing so could result in personal

injury and/or product failure.

21. Operate this product within its specified operating temperature range.

Explanation of Symbols

Caution: risk of electric shock

Caution: risk of danger (See note.)

Direct current

Alternating current

On (Supply)

Equipment protected throughout by DOUBLE INSULATION or

REINFORCED INSULATION

Stand-by

Equipment should not be disposed of in the normal waste stream

WARNING: Voltages in this equipment are hazardous to life. No user-ser-

viceable parts inside. Refer all servicing to qualified service personnel. The

safety certifications do not apply when the operating voltage is changed from

the factory setting.

WARNING: This product contains a chemical known to the State of California

to cause cancer and birth defects or other reproductive harm.

General Description

The Shure PA805Z2-RSMA is a passive directional antenna that improves

RF performance by rejecting off-axis RF signal. Positioned remotely, antennas

can be aimed directly at transmitters.

The antenna attaches to a microphone stand or to the separate wall-mounting

bracket, and delivers the following benefits over standard omnidirectional

half-wave antennas:

• Reduced interference

• Improved RF signal-to-noise ratio

• Antenna gain (8 dBi) helps overcome cable loss

Installation Instructions

1. Determine the length of cable required to connect each antenna to the receiver or antenna/power distribution system. Use the shortest length of cable pos-

sible, because longer cable runs increase power and signal loss.

Important: Only use low-loss reverse SMA cables to prevent signal loss.

2. Use reverse SMA cables to connect an antenna to each of the and ports of the receiver or antenna/power distribution system.ANTENNA A ANTENNA B

PA805Z2-RSMA

Passive Directional Antenna

3. Position antennas so there is nothing obstructing the line of sight to the transmitter, including the audience. Point antennas at the transmitters, with the rear

side facing sources of interference (Wi-Fi access points, for example). Placing them farther apart improves diversity performance. For optimal performance,

minimize the distance between the transmitters and the antennas by placing antennas near the stage, rather than at a front-of-house position.

Note: Always perform a walk-around test to verify coverage before using a wireless system during a speech or performance. Experiment with antenna placement