SolarEdge IAC-RBAT-5KCINV-02 Manual

SolarEdge Accu IAC-RBAT-5KCINV-02

Læs gratis den danske manual til SolarEdge IAC-RBAT-5KCINV-02 (2 sider) i kategorien Accu. Denne vejledning er vurderet som hjælpsom af 38 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 19.5 anmeldelser. Har du et spørgsmål om SolarEdge IAC-RBAT-5KCINV-02, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

What’s in the Package

SolarEdge Home Battery

Low Voltage

Used with SolarEdge inverters

Quick Installation and Operation Guide

for Europe

Ordered Separately

WARNING!

WARNING!WARNING!

Before installing or operating the SolarEdge Home Battery, read the Safety and Handling instructions at the back of this page.

Drill

Min 2 qualified installers

Level

Phillips

screwdriver

WARNING!

WARNING!WARNING!

This symbol denotes a hazard. It calls attention to a procedure that if not correctly performed or adhered to could result in injury or loss of life.

Do not proceed beyond a warning note until the indicated conditions are fully understood and met.

Version: 1.0, August 2022

Subject to change without notice.

Support Contact Informat

Support Contact InformatSupport Contact Information

ion

ionion

In case of any technical issues with SolarEdge

products, please contact us at:

https://www.solaredge.com/service/support

Emergency Response

guide, including emergency

phone numbers

Safety

Datasheet

Floor Stand

Flat Blade -

screwdriver

18 mm Wrench

SolarEdge Home Battery Mounting Bracket

and Screws

WARNING!

Make sure that the circuit

breakers of the battery are

in the OFF position and all

LEDs are turned off

Hammer

Pencil Wire Cutter

Mounting screws and

studs - Mmax 10

min 2

54.7KG

Wiring

video

Unpacking and

mounting video

Battery

Datasheet

Battery Installation

Manual

Turning off the Battery Power

LEDs

OFF

Battery Top Cover

Floor Stand Positioning and Leveling

1 2

3 4

Installing the Mounting Bracket

2.5 Nm

3- cm5

1WARNING!

Mount the battery on a stable surface

NOTE:

NOTE: NOTE: Use a minimum of two wall screws to

install the bracket. Use additional screws to

reinforce installation according to wall

condition.

Planning and Considerations

WARNING!

WARNING! WARNING! Connect no more than 5 batteries per inverter.

Use no more than 3 batteries per battery tower.

30 50 - cm

H: 54 cm

D: 24 cm

W: 50 cm

30 cm

Max 500 cm

25 cm

EMERGNCY EXIT

20 cm

Inverter

100 cm

Tools and Materials Required

Personnel

NOTE:

NOTE: NOTE: Before installing batteries on top of each

other, checked that the max tilt of the wall is 1.5%

Battery to

inverter

Tower to

Tower

Battery to

Battery

260 cm260 cm57cmDC cables

260 cm170 cm55cmGround cable

260 cm170 cm57cmCommunication cable

Available Cables

SASAFET

FET

FETFETY AN

Y AN

Y ANY AND HA

D HA

D HAD HANDLING I

NDLING I

NDLING INDLING INST

NST

NSTNSTRUCT

RUCT

RUCTRUCTIONS

IONS

IONSIONS

Read this entire document before installing or operating the SolarEdge Home Battery (referred to as the

“ ”Battery ). Failure to do so or to follow any of the instructions or warnings in this document can result in

electrical shock, serious injury, or death, or may damage the Battery and other property.

Do not discard this document! After installation, keep it adjacent to the Battery for future reference!

Installation

•Install the battery according to national and local codes and standards and in locations compliant

with local building codes and standards.

•The Battery installation must be carried out only by qualified electricians who have been trained in

handling low voltage electricity works.

•The Battery is heavy. Adhere to local regulations for material handling and heavy lifting, when

installing heavy equipment.

•Do not install the Battery in habitable spaces, including sleeping rooms.

•Make sure the mounting surface can sustain the total weight of the Battery and mounting bracket.

•Do not install the Battery, if it has been dropped, crushed, or has signs of physical damage.

•When the Battery is installed in a residential environment, fire detection and protection equipment

must be installed in accordance with local building and fire codes.

•Do not install the Battery near heating equipment, ignition sources, or open flames.

•Install the Battery only on non-combustible surfaces and under non-combustible ceilings, overhangs,

or eaves.

•Do not install the Battery in proximity to gas meters, valves, regulators, lines, or gas appliances.

Follow local codes. However, 2m / 6ft or more spacing is highly recommended. A failing battery may

ignite flammable gasses resulting in property damage, serious injury, or death.

•Avoid installing the Battery in direct sunlight.

•Install the Battery in a location protected from flooding.

•Do not install the Battery in the vicinity of water sources, including downspouts, sprinklers, or faucets.

•When installing the Battery in a garage or near vehicles, keep it out of the driving path. If possible,

install the Battery on a side wall and/or above the height of vehicle bumpers.

•Before beginning the wiring, ensure that the Battery is switched off. Also, make sure that the

DC safety switch of all inverters in the PV system is turned off.

Operation

•The Battery contains rechargeable lithium-ion cells that are potentially hazardous and can present a

serious fire hazard, injury and/or property damage if damaged, defective or improperly used.

•In case of an electrolyte leak from the Battery, avoid contact with electrolyte and follow the

instructions in the

SolarEdge Home Battery Emergency Response Guide.–

Emission Compliance

•Changes or modifications not expressly approved by SolarEdge for compliance may void the user’s

authority to operate the Battery.

•Use the Battery only as directed in this document.

•Do not use the Battery if it is defective, appears cracked, broken, or otherwise damaged, or fails to

operate.

•The Battery and its components are not user-serviceable.

•Do not attempt to open, disassemble, repair, tamper with, or modify the Battery. The Battery cells are

not replaceable.

•Do not operate the Battery at ambient temperatures of above 50 122 10°C/ ° -F or below ° °F. C/14

Operating the Battery in temperatures outside the specified range might cause damage to the

Battery.

•Do not expose the Battery or its components to direct flame.

•Do not store or use flammable liquids or gasses in the vicinity of the Battery.

•Do not place any combustible items in the vicinity of the Battery.

•If the Battery catches fire, or if fire breaks out near the Battery, call the fire department immediately

and follow the instructions in the

SolarEdge Home Battery Emergency Response Guide.–

•The Battery is prone to re-ignition after extinguishing. Use caution and follow the emergency

response instructions.

•Do not immerse the Battery or its components in water or other fluids.

•Charge and discharge voltage: 44.8 56.5 - Vdc.

•Do not use solvents to clean the Battery or expose the Battery to flammable or harsh chemicals or

vapors.

•Do not use fluids, parts, or accessories other than those specified in this guide, including use of non-

genuine SolarEdge parts or accessories, or parts or accessories not purchased directly from

SolarEdge or a SolarEdge certified party.

•After the installation, do not place the Battery in storage conditions for more than one (1) month, or

permit the power feed to the Battery to be discontinued for more than one (1) month.

•Do not paint any part of the Battery, including any internal or external components such as the

exterior shell or casing.

•Ensure that snow does not accumulate around the Battery.

•A non-functioning Battery must be handled with caution. The Battery state of charge and risk of

venting may be unknown. Contact SolarEdge for assistance.

•Do not attempt to remove or transport a damaged or non-functioning battery. Contact SolarEdge or

your SolarEdge certified installer for support.

•This symbol on the product means: Do not dispose of this product with general household

waste. Consult your local regulations for proper disposal instructions.

LED Indications

SetApp

Configuring Installation

1. Hold the Reset button pressed for 3 to 6 seconds till

the LEDs blink.

2. Turn on the circuit breakers of the battery.

3. Run SetApp.

4. Scan the QR code on the inverter.

5. Follow the on-screen instructions.

For post-installation settings, see

Connection and Configuration

Connection and ConfigurationConnection and Configuration

application note.

NOTE: The battery operation is managed

by the SolarEdge inverter connected

to the battery.

Max ca

Communication Cable

+ -

1 3

Battery Capacity:

76 100- %

51 75- %

26 50- %

0-25%

Fault Indicator

Operation Indicator: Steady –Charging

Flashing Discharging–

Reset Button

Wiring

INV

- Battery Cable (Black)

+Battery Cable (Red)

Ground Cable (Yellow/green)

Installing the

Battery Top

Cover

IMPORTANT! For detailed LED

indications and button operation,

refer the Battery Installation Manual

3 to 6 Sec

Commissioning

CommissioningCommissioning

CAN

Add New Devices

Power Mode

Finish Settings

Self Test

OFF

Optional

Inverter

BAT+BAT-

BAT+

BAT-

WARNING!

WARNING! WARNING! Connect a ground cable according to local regulation.

Produkt Specifikationer

Mærke:	SolarEdge
Kategori:	Accu
Model:	IAC-RBAT-5KCINV-02

Har du brug for hjælp?

Hvis du har brug for hjælp til SolarEdge IAC-RBAT-5KCINV-02 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Accu SolarEdge Manualer

SolarEdge Home Battery Manual

25 August 2024

SolarEdge IAC-RBAT-5KCTOW-01 Manual

13 August 2024

SolarEdge IAC-RBAT-5KCINV-01 Manual

12 August 2024

SolarEdge BAT-05K48MOB-02 Manual

9 August 2024

SolarEdge SE3000H-RWS00BNO4 Manual

8 August 2024

SolarEdge IAC-RBAT-5KMTOP-01 Manual

7 August 2024

SolarEdge IAC-RBAT-5KFSTD-01 Manual

7 August 2024

SolarEdge IAC-RBAT-5KCBAT-01 Manual

6 August 2024

SolarEdge IAC-RBAT-5KCINV-02 Manual

6 August 2024

Accu Manualer

Nyeste Accu Manualer

Stiga E 24 Manual

20 Februar 2025

Stiga E 22 Manual

20 Februar 2025

Aim TTi PL303 Manual

31 Januar 2025

Vonroc CD829AA Manual

9 Januar 2025

Biltema 80-839 Manual

2 Januar 2025

JVC BN-VC2128 Manual

31 December 2025

DJI FPV Intelligent Flight Battery Manual

30 December 2025

Tripp Lite PV4IN1 Manual

30 December 2025

Stiga E 450 Manual

29 December 2024

Kress KAB08 Manual

29 December 2024