2
For Customers in
the U.S.A.
Safety Information
Owner’s Record
The model number and serial number are
located on the wall of the robot’s battery
compartment and on the side of the supplied AC
adapter. Record the serial number in the space
provided below. Refer to the model and serial
number whenever you call upon your Sony®
AIBO® Customer Link (for customer support).
Model No. ERS-7
Serial No. ________________
Warning
•To reduce fire or shock hazard, do not expose
the robot to rain or moisture.
•To avoid electrical shock, do not disassemble
the robot. Refer servicing to qualified
personnel only. (Contact the AIBO Customer
Link (for customer support).) (page 5)
•Periodically examine the AC adapter for
conditions that may result in the risk of fire,
electrical shock, or injury to persons (such as
damage to the cords, blades, housing) and in
the event of such conditions, the AC adapter
should not be used until properly repaired or
replaced.
•Not intended for children under 8 years old.
Regulatory Information
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired operation.
Warning
•You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate
this equipment.
•The shielded interface cable recommended in
this manual must be used with this equipment
in order to comply with the limits for a digital
device pursuant to Subpart B of Part 15 of
FCC Rules.
Notice
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the
equipment and receiver.
•Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
•Consult the dealer or an experienced radio/TV
technician for help.
Note
FCC RF Radiation Exposure Statement: This
equipment complies with FCC radiation
exposure limits set forth for uncontrolled
equipment and meets the FCC radio frequency
(RF) Exposure Guidelines in Supplement C to
OET65. This equipment has very low levels of
RF energy that is deemed to comply without
testing of specific absorption ratio (SAR).
