Soundsphere SS-BCM Manual

Soundsphere Ikke kategoriseret SS-BCM

Læs gratis den danske manual til Soundsphere SS-BCM (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 7 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 4 anmeldelser. Har du et spørgsmål om Soundsphere SS-BCM, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

SS-BCM - Universal Beam Clamp

OWNER’S MANUAL

360º of the Best Sound Around™

Contact: MSE Audio, 855.663.5600 / 913.663.5600 / sales@mseaudio.com

BCM Installation and Safety Procedures

WARNING

Be sure to securely tighten all hardware before hanging the loudspeaker. Wire rope (steel cable), cable clamps with

saddles and thimbles of suitable size and strength are the recommended materials for overhead suspensions. All

loudspeakers should be redudantly safety wired to structural members of the building with an approved safety wire

system or other agency certied materials.

IMPORTANT: Always check local safety codes before installing any overhead loudspeaker system and for periodic

inspection and maintenance of the installation.

Install Instructions

1. Slide the BCM onto the I-beam until it stops against the I-beam ange.

2. Tighten the clamp lock bolts securely so that the tips bite into the beam. Then tighten the jam nuts down against the clamps.

3. With heavy pliers or a hammer, bend the security strap tightly around the I-beam ange as shown.

4. Hang the loudspeaker from the eyebolt (4) with supplied (or appropriate*) hardware. Be sure the BCM is in proper

alignment with the load so that the hanging weight is vertical with respect to the BCM (offset loads signicantly reduce the

load capacity of the BCM assembly).

5. Install an appropriate safety wire through the reector leg or mounting tab (located on the rear of the loudspeaker’s

reector under the leg mounting bolt) and fasten it to a suitable structural member of the building. Safety wiring standard

vary in different localities - please read the WARNING below.

CLAMP LOCK BOLTS

CLAMP JAM NUTS

Produkt Specifikationer

Mærke:	Soundsphere
Kategori:	Ikke kategoriseret
Model:	SS-BCM

Har du brug for hjælp?

Hvis du har brug for hjælp til Soundsphere SS-BCM stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Soundsphere Manualer

Soundsphere SS-Q-12AWR Manual

12 November 2025

Soundsphere SS-MBM Manual

4 Februar 2025

Soundsphere SS-ATB Manual

4 Februar 2025

Soundsphere SS-MBL Manual

4 Februar 2025

Soundsphere SS-BCL Manual

4 Februar 2025

Soundsphere SS-BCM Manual

4 Februar 2025

Soundsphere SS-110B Manual

4 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Vevor SP-CAG-435320 Manual

1 December 2025

Vevor LX-PMMA-36*48 Manual

1 December 2025

Vevor TC2135 Manual

1 December 2025

Vevor PFFSTGSH08 Manual

1 December 2025

Microchip M1A3P600L Manual

1 December 2025

1 December 2025

1 December 2025

1 December 2025

1 December 2025

1 December 2025