SoundTube CM-EZ-II Manual

SoundTube Ikke kategoriseret CM-EZ-II

Læs gratis den danske manual til SoundTube CM-EZ-II (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 3 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 2 anmeldelser. Har du et spørgsmål om SoundTube CM-EZ-II, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

Warning

Do not spec or install speaker near support beam, ventilation

duct or other structure that may interfere with speaker function

or dispersion.

Warning

SoundTube speakers must be installed by a professional audio

installer/contractor. For safety and for optimum audio performance,

installer must follow all directions issued by SoundTube Entertainment.

1.435.647.9555

800.647.TUBE

www.soundtube.com

70.7 Volt Transformer Taps (dB) 100 Volt Transformer Taps (dB) 25 Volt Transformer Taps (dB)

20W=103, 10W=100, 5W=97, 2.5W=94, 1.25W=91 20W=103, 10W=100, 5W=97, 2.5W=94 2.5W=94, 1.25W=91, .63W=88, .32 W=85, .16W=82

CM-EZ-II

Transformer Taps Settings

Install Instructions

Voice Coil

8 Ohm=106 dB

Box contents

1 Speaker

1 Flexible conduit clamp

1 Tile bridge

(shipped separate)

CM-EZ-IICM-E

CM-E

Z-II

CM-EZ-II

Snap cam

Grille bezel

Sheetrock/tile

Signal wires

Tap switch

20 W, 10 W, 5 W, 2.5 W, 1.25 W, voice coil/8 Ohm direc

Blind-mount

backcan

Safety cable stud

Flexible conduit clamp

Tile bridge

9.75" (248 mm)

1.435.647.9555

800.647.TUBE

www.soundtube.com

Drop Tile Ceiling Install Instructions

CM-EZ-II

CM-EZ-IICM-E

CM-E

Z-II

4. Set tap to proper setting.

CM-EZ-8 is factory preset

in the 70.7 Volt mode in

the 20 Watt setting.

7. Thread tap & signal wires

thru flexible conduit clamp.

Connect wires with wire

nuts. See tap settings on

front page of this manual

for proper settings.

8. Push connections and

terminated tap wires

into backcan. Push

flexible conduit clamp

into backcan and tighten

clamp onto conduit.

2. Using supplied tile bridge,

mark

9 9/16" (243 mm) hole.

6. Set entire assembly

facing down on top of

ladder. Pull signal wire

down to speaker.

3. Cut hole in tile using key-

hole saw or Roto-Zip tool.

1. Remove ceiling tile.

5. Lay tile bridge & tile on

floor with tile facing up.

Set speaker unit in hole

and lift ceiling tile & tile

bridge as a unit until

speaker snaps into place.

9. Install assembly into

ceiling tile rails.

10. Done! To Uninstall Speaker

1. Remove grille and

locate brass release

pins (x4).

2. Using a screwdriver, push

release pin up to release

cam. Turn clockwise

until threads engage to

lock cam. Properly term-

inate signal wire in ceiling.

Produkt Specifikationer

Mærke:	SoundTube
Kategori:	Ikke kategoriseret
Model:	CM-EZ-II

Har du brug for hjælp?

Hvis du har brug for hjælp til SoundTube CM-EZ-II stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret SoundTube Manualer

SoundTube IPD-SM52-EZ-WX Manual

6 Juli 2025

SoundTube CM82-EZS Manual

6 Juli 2025

SoundTube IPD-CM82-BGM-II Manual

6 Juli 2025

SoundTube IPD-CI52 Manual

4 Juni 2025

SoundTube IPD-CI62 Manual

3 Juni 2025

SoundTube SM500I-II-WX Manual

2 April 2025

SoundTube IPD-SM52-EZ Manual

2 April 2025

SoundTube IPD-CM52-BGM-II Manual

2 April 2025

SoundTube CM-EZ-II Manual

2 April 2025

SoundTube LA808i Manual

2 April 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Pfister Lima F-529-6LMS Manual

6 Juli 2025

Extron IPL EXP 200 Manual

6 Juli 2025

Metra PR-LOC2.4 Manual

6 Juli 2025

GYS PBT 720 Manual

6 Juli 2025

QSC Q-SYS I/O-USB Bridge Manual

6 Juli 2025

Videotec UPTIRPS Manual

6 Juli 2025

Hikvision ISD-SC6040D-H4CVL Manual

6 Juli 2025

Iogear GCS1224TAA4C Manual

6 Juli 2025

Panasonic EAHA800E Manual

6 Juli 2025

Sightron SII Manual

6 Juli 2025