Speco Technologies O4LT1 Manual

Speco Technologies Ikke kategoriseret O4LT1

Læs gratis den danske manual til Speco Technologies O4LT1 (45 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 71 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 36 anmeldelser. Har du et spørgsmål om Speco Technologies O4LT1, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/45

User Manual

4MP Full-Color IP Camera

O4LB1/ O4LT1

Please read this manual carefully before operang the unit keep it for further reference and

Important Safeguards and Warnings

1. Electrical safety

All installaon and operaon here should conform to local electrical safety codes.

Use a certied/listed 12VDC Class2 or adequate PoE switch.

Improper handling and/or installation could run the risk of fire or electrical shock.

2. Environment

Do not expose the heavy stress, violent vibraon long-term exposure water humidity during transportaon, unit to or to and

storage, and/or installaon.

Do not install near sources heat. of

Only install the product environments inside the specicaon operang temperature humidity range. in and

Do not install the camera near power lines, radar equipment other electromagnec radiation. or

Do not block any venlaon openings any. if

Use all the weatherproong hardware requirement minimize weather intrusion.to

3. Operaon and Daily Maintenance

Please shut down the device and then unplug the power cable before you begin any maintenance work.

Do not touch the CMOS sensor opc component. You can use a blower to clean the dust on the lens surface.

Always use the dry so cloth to clean the device. If there is too much dust, use a cloth dampened with a small quanty of neutral

detergent. Finally use the dry cloth to clean the device.

Please use a professional optical cleaning method to clean the enclosure. Improper enclosure cleaning (such as using cloth) may

result in poor IR functionality and/or IR reecon.

The grounding holes of the product are recommended to be grounded to further enhance the reliability of the camera.

Dome cover is an opcal device, please do not touch or wipe cover surface directly during installaon and use, please refer to the

following methods if dirt is found.

Stained with dirt:

Use oil-free so brush or hair dryer to remove it gently.

Stained with grease or ngerprint.

Use oil-free coon cloth or paper soaked with alcohol or detergent to wipe from the lens center outward. Change the cloth and

wipe several mes if it is not clean enough.

Produkt Specifikationer

Mærke:	Speco Technologies
Kategori:	Ikke kategoriseret
Model:	O4LT1

Har du brug for hjælp?

Hvis du har brug for hjælp til Speco Technologies O4LT1 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Speco Technologies Manualer

Speco Technologies CLTPX1 Manual

28 Januar 2025

Speco Technologies SB21M Manual

27 December 2024

Speco Technologies SB11M Manual

27 December 2024

Speco Technologies V5B3M Manual

18 September 2024

Speco Technologies APCR620L Manual

18 September 2024

Speco Technologies V5T3 Manual

18 September 2024

Speco Technologies SB01M Manual

18 September 2024

Speco Technologies V5T3M Manual

18 September 2024

Speco Technologies O8LMST1 Manual

18 September 2024

Speco Technologies APCR640L Manual

6 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Planet XGPN-100 Manual

15 Juni 2025

Proficook PC-EKA 1283 Manual

15 Juni 2025

OmniMount OBSP8 Manual

15 Juni 2025

Levenhuk FS10 Manual

15 Juni 2025

Vestil PM4-2148-LP Manual

15 Juni 2025

ElectriQ STRV-W1-B Manual

15 Juni 2025

Adler AD 4521 Manual

15 Juni 2025

AMX HydraPort HPX-AV102 Manual

15 Juni 2025

Hughes & Kettner Red Box Mk II Manual

15 Juni 2025

Hughes & Kettner Quantum QC 412 Manual

15 Juni 2025