SSV Works WP-RZF3O4 Manual

SSV Works Soundbar WP-RZF3O4

Læs gratis den danske manual til SSV Works WP-RZF3O4 (2 sider) i kategorien Soundbar. Denne vejledning er vurderet som hjælpsom af 14 personer og har en gennemsnitlig bedømmelse på 3.7 stjerner ud af 7.5 anmeldelser. Har du et spørgsmål om SSV Works WP-RZF3O4, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/2
WP-RZF3O4
4 Seat RZR XP1000 & 2015+ RZR900
4 Speaker Overhead WP System
SSV WORKS, 201 N. Rice Ave Unit A, Oxnard, CA 93030
www.SSVworks.com | Phone: 818-991-1778 | Fax: 866-293-6751
!
Please read and understand these
instructions completely before
installation to avoid possible injury, or
WARRANTY INFORMATION:
All SSV Works enclosures are covered by a limited lifetime warranty against defects
in material or workmanship. All SSV Works Electronics are covered by a limited 1 year
warranty against defects in material or workmanship. All SSV Works Speakers are
covered by a limited 1 year warranty against defects in material or workmanship. Labor
for replacement of defective components is not covered. Contact SSV Works for further
warranty information.
1. WP-RZF3O4 x 1
2. M6 x 1.0 Screws x 12
3. M6 Washers x 12
4. Mounting Brackets x 2
TOOLS NEEDED FOR INSTALLATION
INSTALLATION NOTES
PARTS LIST
PARTS LIST IMAGES
5. Fuse Holder with Fuse
6. Crimp on ring terminal
7. Zip Ties
To make wiring easier, locate the battery in the vehicle before beginning the installation. The use of a thread locker is recommended on all
screws to prevent loosening due to vibration.
2. M6 x 1.0 Screws x 12 3. M6 Washers x 12
5. Fuse Holder with Fuse
4. Mounting Brackets x 2
9. Crimp on ring terminal 10. Zip ties
1. WP-RZF3O4
- Wire Crimpers
- Wire Strippers
- 13mm Wrench for Battery
Terminal
- #3 Phillips Screwdriver
A. With one person on either side of the vehicle place the WP-
RZF3O4 into location from the underside of the cage.
C. Once the enclosure is in position, press the bracket toward
the center of the vehicle and tighten the brackets using the #3
screwdriver. NOTE: After all brackets are tightened, it may be
necessary to go back and re-adjust the brackets to ensure the
enclosure is properly secured.
B. While holding the enclosure securely toward the front crossbar of
the cage, loosely install the 2 brackets using the screws provided
WP-RZF3O4
A
C
B
D. Using the zip ties provided, route the Power/Ground loom to the battery location
away from any moving parts or sharp metal. NOTE: The 4 pin short cable is for
additional speakers (WP-RZF3O+2F, Front add on and WP-RZF3O+2R, Rear add
on) and the 4 pin long cable is for adding an SSV Works Powered Subwoofer (Part#
WP-RZ3GBS10)
D D
A. Cut the power/ground cable to length; be sure to
leave enough wire at the battery location to wire to
the battery, strip back approximately 4 inches of the
black tubing to expose the red/black wires inside.
Strip back 1/4”-1/2” of wire to make your
connections.
B. Crimp the supplied
fuse holder onto the
end of the RED wire
and attach to the
battery “+” terminal.
C. Crimp the supplied
ring terminal to
the BLACK wire
and attach to the
battery “-” terminal.
WIRING INSTRUCTIONS
A
B C
© Copyright 2016 SSV Works, Oxnard, CA 93030 WP-RZ3FO4 Rev. A 2-8-16

Produkt Specifikationer

Mærke: SSV Works
Kategori: Soundbar
Model: WP-RZF3O4

Har du brug for hjælp?

Hvis du har brug for hjælp til SSV Works WP-RZF3O4 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Soundbar SSV Works Manualer

SSV Works

SSV Works WP-RZF3O4 Manual

1 Juli 2025

Soundbar Manualer

Nyeste Soundbar Manualer

LG

LG SK8 Manual

3 Oktober 2025
LG

LG LAS454B Manual

3 Oktober 2025
Samsung

Samsung HW-H430 Manual

2 Oktober 2025
Insignia

Insignia NS-HMSB20 Manual

1 Oktober 2025
Philips

Philips TAB8200 Manual

1 Oktober 2025
Hisense

Hisense HS1000 Manual

1 Oktober 2025
Insignia

Insignia NS-SBAR21F20 Manual

30 September 2025
Insignia

Insignia NS-HTSB22 Manual

29 September 2025
Samsung

Samsung HW-J365 Manual

25 September 2025
Boston Acoustics

Boston Acoustics TVee 26 Manual

25 September 2025