Steelton 4CA-146072-CR Manual


Læs gratis den danske manual til Steelton 4CA-146072-CR (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 24 personer og har en gennemsnitlig bedømmelse på 3.6 stjerner ud af 12.5 anmeldelser. Har du et spørgsmål om Steelton 4CA-146072-CR, eller vil du spørge andre brugere om produktet?

Side 1/2
ASSEMBLY INSTRUCTIONS
Wire Shelving
A B
C
OR
D
Recommended Tools: Rubber Mallet
INCLUDED PARTS
A(4-5) Shelves (depending on unit)
B(4) Posts (knock-down)
(4) Upper (caps attached)
(0-4) Middle (depending on unit)
(4) Lower
(4-8) Post Connectors (depending on unit)
C(4) Leveling Feet
(4) Casters (in separate box for mobile units)
D(4) Pairs of Sleeves per Shelf
E(1) Wall Anchoring Kit (not pictured)
Washers, Drywall Anchors, and Screws
FINAL PRODUCT
05/2023
ASSEMBLING THE SHELVING UNIT
1Check parts list to ensure all parts are included.
2Attach the foot levelers or casters to the lower posts
by twisting them in a clockwise direction.
Note: the upper posts will already have caps
attached.
3Snap the sleeves onto the grooves on each post.
Ensure that the small, tapered side of each sleeve
is facing up.
4Hold the bottom shelf on its side and slide the top of
the four lower posts through the collars in the shelf
until the sleeves fit firmly inside the shelf collars.
5Stand the unit upright and place the next shelf on top
of the posts, sliding them through the shelf collars
until the sleeves fit firmly.
6Screw the upper posts into the lower posts using
the post connectors.
7Add additional split sleeves at desired shelf height
and continue to place the remaining shelves on top
of the posts, sliding them through the shelf slots
until the sleeves fit firmly.
8Press down on each corner of each shelf to secure
them in place.
Note: Placing a towel on a shelf then hitting it with
a rubber mallet can help secure the shelf in place.
Use caution not to damage the unit.
9Screw the foot levelers in or out to fully level the unit.
10 If additional security is needed, use the included
anchoring kit to attach the unit to the wall.


Produkt Specifikationer

Mærke: Steelton
Kategori: Ikke kategoriseret
Model: 4CA-146072-CR

Har du brug for hjælp?

Hvis du har brug for hjælp til Steelton 4CA-146072-CR stil et spørgsmål nedenfor, og andre brugere vil svare dig